查询词典 layer

The vertical electric field of the buried layer is enhanced due to the low k of the dielectric buried layer at the drain side,the electric field in the drift region is modulated by the compound dielectric layer with different k values,and both increase the breakdown voltage of the device.

CDL SOI结构利用漏端低k介质增强埋层纵向电场，具有不同k值的复合介质埋层调制漂移区电场，二者均使耐压提高。

The microstructure of hardened layer and formation mechanism were investigated.The microstructure of hardened layer consist of the completely hardened region and the transition region.The completely hardening region is composed of fine acicular martensites,residual austenites and a few dot-like carbonides.From surface to bottom in the hardened layer,the microstructure varies from fine to coar...

结果表明：采用适当的磨削参数可满足该钢所要求的淬火温度，进而获得适宜的淬硬层显微硬度和强化层深度；磨削淬火层由完全硬化区和过渡区组成；完全硬化区主要由细小针状马氏体组成，从表面到里层，组织形貌呈现&细→粗→细&的变化规律，其形成机理是热-力耦合作用影响磨削淬火过程中的奥氏体晶粒大小及其位错密度，并将直接影响转变后的马氏体组织形貌。

Through the research,it is found that both the Chinese causatives and the English causitives have double-core structrure at the deep layer.The two groups of causatives present similar features in the process of transforming from the deep layer to the surface layer.

通过研究发现，汉英致使句在深层都是双动核结构，从由深层向表层的转换过程中，两组句子表现出了相似的特点。

In a preferred embodiment, a creped spunbond layer is used as the cover material and a co-apertured intake/distribution layer and transfer delay layer are the capillarity fabric.

在一个优选实施例中，起绉纺粘层用作覆面层材料，且共穿孔的吸入/分布层和输送延迟层是毛细作用织物。

In accordance with damping layer position, damping layer value, damping layer length for free vibration and forced vibration to discuss which restrain vibrate effetely.

分别针对阻尼层的位置、阻尼层长度、阻尼值的大小在自由振动与强迫振动探讨其抑制振动效果。

As a result, some ideas about the fabrication are put forward.The EPMA experiment results show that the main element such as W, Mo, Ti, Ni, Cu, Fe element are changed gradually in W-Mo and W-Mo-Ti FGM. In the layer rich in W, the grain are intervained and are mixed mechanismly. The same is to the layer rich in Mo and W-Mo. These grain felt up by some sinter. In Mo-Ti layer rich in Mo, the grains are also mixed mechanismly. Ni, Cu, Fe element assembled at interface. Ni melt by Cu plays an vital role in sinter effect. The microstructure characteristics result show that the compactness of W-Mo and W-Mo-Ti FGM is good.

电子探针实验结果表明W-Mo系、W-Mo-Ti系梯度功能材料中主要元素W、Mo、Ti、Ni、Fe、Cu分布整体上具有梯度变化规律，发现富W区、富Mo区、W-Mo混合区中颗粒交错分布，基本上以机械混合的形式存在，颗粒之间主要靠烧结剂的粘结作用实现致密化；以Mo为主要组分的Mo-Ti混合区，也是以机械混合的形式存在；Cu溶解于Ni形成固溶体更好地起到活化烧结能力，Ni、Cu、Fe在宏观层间界面富集，有利于烧结致密化。

The effect of the tool composition on the friction and wear behavior was investigated,and the morphologies of the rake face and rear face of the tool cutting the steel in air and nitrogen were observed on a scanning electron microscope. It was found that the Al_2O_3/TiB_2 tool was dominated by adhesive and abrasive wear in low speed dry cutting; while in high speed dry cutting,the tool was characterized by oxidation wear. An oxide layer of TiO_2 was formed by way of the oxidation of the reinforcing agent TiB_2 at a very much high cutting temperature, which contributed to greatly reducing the friction coefficient and increasing the antiwear life of the tool.Such a friction-reducing and antiwear behavior of the oxide layer was enhanced with increasing content of TiB_2 in the tool composite. However,the tool showed a relatively poorer wear resistance in N_2 than in air, because N_2 acted to retard the oxidation of the TiB_2 and the formation of the oxide layer on the tool rake face.

结果表明：低速干切削时，Al2O3/TiB2陶瓷刀具的磨损机制主要表现为粘着磨损和磨料磨损；而在高速干切削时，刀具的磨损机制主要表现为氧化磨损，刀具表面经由氧化反应生成具有润滑作用的反应膜而起到固体润滑作用，从而使刀具的耐磨性能提高，随着TiB2含量和切削速度的增加，反应膜的减摩抗磨作用增强；而在切削区通入氮气时，由于刀具表面氧化膜形成受阻，刀具的抗磨能力有所降低。

Therefore, in this thesis, we conduct a layer-by-layer analysis of handovers and investigate, systematically, the cross-layer effects of WLAN adapters, network configurations and application software on handover delays.

因此，在本篇论文里，我们透过有系统的方式，逐层分析及探讨不同厂牌的无线区域网卡、不同的网路环境组态以及应用软体实作上的差异的交递行为，以及在交递过程中跨阶层的交互影响。

Telnet tests the Application layer, pingtest the Network layer.Telnet is an application used to remotelyconfigure a device. If telnet is succesfful youknow that full 7 layer stack on the sending and receiving host areconfigured correctly and are inworking order

因为telnet命令是工作在应用层，ping命令是工作在网络层的，telnet是应用于远程控制设备的，所以如果能telnet成功的话，这就证明了两台主机或设备已经联通了，在联通性上面已经没有问题了。

Based on the pattern of partial double-layer LICS, different analysis models of nonlinear, linear, rigid joint and pin joint were compared, linear property of double-layer region and nonlinear property of single-layer region was disclosed, and then a nonlinear-linear combine method was put forward with a definite object in view.

针对局部双层叉筒网壳的布局特点，本文对局部双层叉筒网壳进行了非线性、线性、刚接、铰接等多种分析方法的比较，揭示了双层区域的线性性质和单层区域的非线性性质，进而有的放矢地提出了&非线性-线性联合&这种适合局部双层网壳分析的合理、准确、高效的方法。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷