查询词典 laser diode

The principle of constant power drive is: PD converts the change of output light power of laser diode into the change of diode current, and the change of current is feed back to voltage-current converser which adjusts output current of driver to compensate the laser diode.

这样，当激光器的输出光功率衰减时，驱动器相应的增大输出电流；当激光器的输出光功率增强时，驱动器就相应减小输出电流。对许多激光器应用来说，最希望脉冲输出，因为脉冲输出只有极小的结发热。

It uses a macro laser sensor based on optical-electronic triangulation method to get diametric size, and uses grating linear transducer and scanning sensor composed of laser diode and photo-diode to get axial size of the work-piece to be measured.

它利用基于光学三角法的激光位移传感器获得轴类零件的径向尺寸，利用半导体激光器与光电二极管组成的扫描式发讯传感器和光栅传感器的组合获得轴向尺寸。

Diode-pumped solid-state laser is solid-state laser, used laser diode instead of flash lamp to pumping laser m...

激光二极管泵浦的固体激光器是用激光二极管代替闪光灯去泵浦激光晶体的固体激光器。

Diode-pumped solid-state laser is solid-state laser, used laser diode instead of flash lamp to pumping laser media.

激光二极管泵浦的固体激光器是用激光二极管代替闪光灯去泵浦激光晶体的固体激光器。

ABSTRACT The laser diode pumped solid state lasers are that solid state laser, used laser diode instead of flash lamp to pumping laser gain materials.

激光二极管泵浦的固体激光器是用激光二极管代替闪光灯去泵浦激光晶体的固体激光器。

The luminescence power of semiconductor laser diode is tested after the radiator element of laser diode is made and the drive circuit is designed. Then, chaos mathematic model is introduced to produce deterministic class stochastic signal and C langrage program, which is based on the hardware circuit design of MSP430, is designed and on-line debugged to implement the dynamic stimulation effect and avoid the body adaptability with the duty cycle of chaos sequence. The duty cycle is adjusted and controlled to accomplish the reinforcing and reducing in moxibustion. At last, Average power of laser diode is tested under the conditions of different duty cycles and the waveforms are collected by applying virtual instrument.

在半导体激光器散热装置的特别制作及工作驱动电路的设计基础上，完成半导体激光器发光功率的测试，然后引入混沌数学模型方法来产生确定性的类随机信号，在 MSP430 单片机硬件电路设计的基础上，应用单片机 C语言进行程序设计并在线调试，实现传统灸法的动态刺激效果，采用混沌序列占空比信号消除人体适应性，调整和控制输出占空比的改变以达到灸疗的补泻手法的实现，最后对不同控制占空比情况下激光器输出的平均功率进行测试，完成工作波形的采集。

The laser diode and the chip of the laser diode driver and the 4∶1 multiplexer,which are realized in different materials and processes,are fabricated on one same ceramic substrate using a film circuit to make up one opto-electronic integrated circuit,i.e.,an OEIC.The chip and the diode are realized with a 0.35μm CMOS process and with wet etching,polymer planar, and lift-off technologies, respectively.The module is encapsulated with a wing shell.

该发射机采用薄膜电路和激光焊接耦合技术将高速集成电路和光电子器件进行混合集成，其中高速集成电路是采用0.35μm硅CMOS工艺实现的单片4∶1复接器加激光驱动器芯片，光电子器件是采用湿法腐蚀、聚合物平坦和lift-off等技术实现的激光器芯片，最终混合集成模块采用蝶形管壳进行封装，体积小、性能优良。

The laser diode system is composed of three external cavity diode lasers and four injection diode lasers and a tapered amplifier. Four laser beams as 40K and 87Rb cooling and repump lights are obtained by using acoustic optic modulators to offset the frequencies from the three ECDL lasers. Four light beams with the different frequencies are injected into four slave lasers for injection locking, then Rb cooling light, K cooling light and K repump light are injected into a semiconductor tapered amplifier in a master oscillator-power configuration.

采用三台外腔光栅反馈半导体激光器、四台注入锁定激光器和一台半导体激光放大器组成激光系统，三台外腔光栅反馈半导体激光器通过声光调制器产生四束光，分别作为40K和87Rb原子的冷却光和再抽运光，四束不同频率成份的激光分别注入锁定四台从激光器，然后Rb cooling光、K cooling光和K repump光再同时注入半导体激光放大器进行放大。

Based on the laser longitudinal mode splitting theory, a novel scheme of dual-frequency laser with large frequency-difference is presented using electrically controlled birefringence of liquid crystal, and the transmitted resonant mode splitting by birefringent of Fabry-Perot etalon has been analyzed theoretically. A new element of liquid crystal Fabry-Perot etalon is designed and fabricated, which serves as aselector and splitter of both laser longitudinal modes and Fabry-Perot etalons transmitted resonant modes. Two different experimental systems of laser-diode end-pumped Nd:YAG laser have been set up using two different LDs, and the transmission of liquid-crystal cell have been measured. When the empty LCFP is inserted in the cavity of high-power LD pumped Nd:YAG laser, the oscillation of a single laser longitudinal mode have been observed, such a result shows that the designed and fabricated LCFP element is capable of selecting single axial mode. While an anti-reflected liquid crystal cell is inserted in the cavity of Nd:YAG laser end-pumped by the high-power LD, it is difficult to confirm weather the laser longitudinal modes have been spitted or not. The subject is summarized in this thesis and the improvement of the project has been presented.

论文以激光纵模的分裂理论为基础，提出了可望获得几十GHz甚至上百GHz的液晶电控双折射双频Nd：YAG激光器的总体方案，并对用双折射效应分裂F-P标准具透射谐振模进行了理论分析；设计并加工了一种集激光纵模选择、激光纵模分裂和F-P标准具谐振透射模分裂于一体的多功能元件——液晶电控双折射F-P标准具；建立了两种不同功率激光二极管端面泵浦的Nd：YAG激光实验系统，并对液晶盒的透射性质进行了测试；将未灌注液晶的空液晶F-P摘要标准具插入大功率LD泵浦Nd：、叭G激光谐振腔内，观察到了单纵模激光输出，说明所设计和加工的液晶F一P标准具具有纵模选择能力；将镀有增透膜的液晶盒插入大功率LD泵浦Nd八7AG激光谐振腔内，是否产生了激光纵模分裂现象还难以确定。

Then we make a further discussion of its applied areas including laser diode, pigtailed laser diode, laser diode arrays, different shape of inner cladding, etc.

标 签 光纤激光器侧面耦合微棱镜双包层激光二极管 fiber laser side pumping micro-prism double-clad laser diode

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。