查询词典 landing

The plane hunted a bit on the ground when landing.

这架飞机在地面降落时偏航了一点点。

In the heavy fog he had to make the landing by flying blind .

在大雾里他只得凭仪器来降落。

About the first adventure we had yesterday afternoon after landing here, came near finishing that heedless Blucher.

我们上岸后，在昨天下午碰到了头一件险事，差点断送了冒失鬼勃鲁吉的性命。

In the 1970s, for instance, West Coast trawlers were landing 11,000 tonnes of bocaccio a year. In 2001, just before the fishery was closed, the catch was 214 tonnes.

例如七十年代，在美国西海岸拖网渔船每年捕捞上岸11000吨菖鲉，到2001年，在此渔场被关闭前，捕捞量已降到214吨。

The bomb bay would be located between the two nacelles, and the tricycle landing gear would also be stored in the same area.

炸弹湾将位于两国之间的发动机舱，和三轮车起落架也将被储存在同一地区。

November 1943: As the invasion at Empress Augusta Bay gets under way on Bougainville, US troops are seen climbing over the side of a Coast Guard-manned combat transport to enter the landing barges.

1943年11月：获得由于在奥古斯塔皇后湾入侵的方式下，在布干维尔，美军看到了一个海岸警卫队侧攀登载人作战运输进入登陆驳船。

Has been awarded a contract by BAE Systems Australia to provide a Synthetic Vision display, for the development of a rotorcraft brownout landing system.

水银计算机公司获得一份BAE系统公司澳大利亚分公司授予的合同，为开发旋翼机的警戒灯着陆系统而提供合成视觉显示系统。

Prior to landing in Buenos Aires, you are strongly encouraged to glue your jaw shut.

前降落在布宜诺斯艾利斯，你都极力鼓励胶水，你的下巴被关闭。

Our design takes into consideration random air turbulence, carrier burble and deck motions ,and designs the automatic landing control system for longitudinal control laws. The results show that the control designed by the LQG/LTR is robust, and the simulation result are ideal.

在考虑大气干扰、舰尾流和甲板运动的条件下，以某飞机为例，对其纵向自动着舰控制系统进行分析、设计与仿真，结果表明采用LQG/LTR方法设计的控制器具有较好的鲁棒性，并且具有良好的效果。

The last night pa was boosed he was standing on the landing there bawling out for his boots to go out to Tunney's for to boose more and he looked butty and short in his shirt.

最后那个晚上爹喝得醉醺醺的。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。