查询词典 kwh

Below, we compare BEV and FCV technologies based on a vehicle model that is capable of delivering 100 kW of peak power, and 60 kWh total energy to the wheels.

下面， 我们比较基于能交付100千瓦峰值功率的一个车辆模型的BEV 和FCV 技术，以及在车轮的60 kWh 总数能源。

By 1991, the average heat rate was 10,367 BTU/kWh, which corresponds to 33% efficiency.

到1991年，平均耗热率是10，367 BTU/kWh，效率为33％。

Electricity generated by major dams like the Jensen Dam, TVA Project, Grand Coulee Dam and Hoover Dam still produce some of the lowest-priced ($0.08/kWh), clean electricity in America.

发电主要水坝如詹森坝的TVA项目，大古力坝和胡佛水坝仍然生产了，价格最低的（$ 0.08/kWh ），清洁电力在美国。

Jie Sheng chemical into the liquid is mainly sulfur-burning sulfuric acid, potassium sulfate, chlorosulfonic acid, liquid sulfur dioxide, sulfur trioxide, nitrosyl sulfuric acid, as well as cogeneration for steam systems, a variety of products amounted to more than 20 years of logistics million tons, capacity 16 million KWH, steam 140,000 tons; a lot of sulfur in addition to the downstream products in the study of chemical development.

捷盛化学目前主要建成液体硫磺制酸、硫酸钾、氯磺酸、液体二氧化硫，三氧化硫、硫酸亚硝酰项目以及余热发电、供汽系统，各类产品年物流量达20余万吨、发电量1600万KWH、蒸汽14万吨；另外还有诸多硫化工下游产品在研究开发之中。

The technology scheme is chosen middle frequency DBD to develop large-scale ozonizer. And based on above mention, the test prototype is realized successfully, when fed gas is oxygen, the test prototype can output 300g/h ozone gas, and the ozone concentration is about 50g/m〓, the energy efficiency is 150g/kWh.

选择确定中频介质阻挡放电作为研制大产额臭氧发生器的技术方案，并在放电等离子体合成臭氧的试验研究基础上，研制成功300g／h的臭氧发生器试验样机，原料气体为氧气时，样机产生臭氧的浓度为50g／m〓，并达到150g/kWh的臭氧产率。

Under technological conditions such as: room temperature, current density 200 A/m^2, anolyte acidity 0.5 mol/L chlorhydric acid, acidity of catholyte 1.5 mol/L chlorhydric acid, circulation of anolyte and catholyte 40 L/h, Ni(superscript 2+) concertration 0.85 mol/L, and the average cell voltage 1.3 V, the electricity consumption of dissolving a ton of nickel base alloy is 813 kWh, and the Ni(superscript 2+) retention rate of the ion exchange membrane is more than 99.5%.

在电流密度200 A/平方公尺、阳极酸度0.5 mol/L、阴极酸度1.5 mol/L、循环量40 L/h、Ni(上标 2+)浓度0.85 mol/L左右和室温的条件下电解，平均槽电压1.3 V，电溶1 t镍合金板耗电813 kWh，阴离子交换膜对镍的截留率大於99.5%。

Results showed that, the specific refining energy consumption is decreased with increment of rotation speed of the primary refiner. At freeness level of about 670 mL CSF, for example, the specific refining energy consumptions is 363 kWh/t o.d. at 3000 r/min, and 305 kWh/t o.d. at 3500 r/min, which is equivalent to 16% energy saving, furthermore the specific energy consumption is only 265 kWh/t o.d. at 4000 r/min, which means 27% less refining energy required. At the same time, pulps produced at higher refiner speed have higher strength properties and lower shives contents. There is little change of optical properties of the pulps.

结果表明：小叶桉物料在相同条件下进行汽蒸、挤压和化学预浸渍后，分别采用3500 r/min和4000 r/min的盘磨转速进行第一段磨浆，浆料磨至游离度670 mL时所需磨浆电耗与3000 r/min时的相比，分别下降16%和27%；浆料中纤维束含量分别降低20%和35%；第一段磨后浆料再分别经相同盘磨转速（3000 r/min）的后续磨浆后，与相近游离度的浆料性能比较可知，随第一段磨浆盘磨转速的提高，浆料的细小组分含量略有增加，纤维束含量显著降低，强度性能有不同程度的改善，但光学性能变化不显著。

With a thermal efficiency of more than 45 percent （compared with a typical subcritical plant thermal efficiency of 30-38 percent）, a fuel conversion rate of less than 272.9 grams/KWh

由于热效率超过50％（典型的临界发电厂热效率为30％-38％），燃料转换率少于272.9 grams/KWh

During this time frame, the 25 kWh battery will be established as a kind of industry standard size.

而除了标准25 kWh电池，预期在电池领域也将陆续有其他价格/容量比的重要进展。

The gap between domestics and world advanced level is about 60g/kWh, in terms of

供电煤耗与世界先进水平仍然相差约60克/kWh。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。