查询词典 knee joint

It is a feasible and effective way to extense knee joint ankylosis that the local tissue in the joint is prolongated.

延长膝关节局部组织是治疗伸直型膝关节僵直可行和有效的治疗方法。

Pain can be reliably eliminated in most patients with hip or knee joint disease, and improvement in joint motion is generally achieved.

胶合剂所作的假体部位，用十多年后会松动，而全关节成形术对老年和活动较少的人，却有维持最长时间的效果。

They act to flex the knee joint and also to extend the hip joint.

他们的行为给屈伸膝关节，并延长髋关节。

The hypertension model rats were induced with bi-kidney-bi-clip method, then the focal cerebral ischemia-reperfusion rat model was induced by reversible occlusion for a middle cerebral artery with a thread on the stroke prone renovascular hypertensive model rat. While the rats in sham operation group were operated without thread insertion. Shuigou (Du 26), bilateral Neiguan(PC 6) and bilateral Housanli (Zusanli, ST 36) were located according to"Atlas of Experimental Animal Acupoints" made by Hua's. Shuigou (Du26): 1 mm below nasal apex right on the Labium leporinum, be punctured 1 mm obliquely upward; Neiguan (PC 6): at the lateral palm of the forearm3 mm above wrist joint, between ulna and radius, be punctured 1 mm perpendicularly; Housanli (Zusanli, ST 36): under knee joint, 5 mm below the capitulum of fibula, be punctured 7 mm perpendicularly. The skin of Shuigou (Du 26) and the root of right ear, Neiguan (PC 6) and Housanli (Zusanli, ST 36) were connected with electroacupuncture Therapeutic Instrument G6805 with the parameters of continuous wave, 120 times/minute in frequency, 1 mA in intensity for 30 minutes.

用双肾双夹法复制易卒中型肾血管性高血压模型，在此基础上，运用栓线法制备大鼠局灶性脑缺血再灌注模型；假手术组除不插入栓线外，其余步骤同模型组；电针治疗组取水沟(唇裂鼻尖下1 mm正中处，向上斜刺1 mm)、双侧内关(前肢内侧，离腕关节约3 mm处的尺桡骨缝间，直刺1 mm)、双侧足三里(膝关节下侧，在腓骨小头下约5 mm处，直刺7 mm)水沟穴与右耳根部皮肤、内关与足三里接G6805电针治疗仪，连续波，频率120次/min，强度1 mA，留针30 min。

The range of joint motion exceeded 90° in 92% of the patients, and most of the patients had normal line of force of the knee joint, but 4 patients remained varus deformity of 5°-10°.

术前至最后1次随访，均膝关节功能评分27(12~55)分/77(56~98)分；92%的患者膝关节活动度超过90°多数病例术后膝关节力线正常，4例残留5°~10°内翻畸形。

Taking the moments of hip and knee joint as its controlled variables, the simulation of the motion equation shows that: After increasing the joint moment at the cushioning phase, the vertical velocity of the body center of mass distinctively speedup while horizontal velocity fall to some degree. Thus, the resultant velocity remains basically constant, but the result distance of long jump can be increased due to the enlargement of the angle of take-off.

以髋、膝关节肌力矩作为运动方程的控制变量，对其修改后的模拟结果表明：增大缓冲阶段的关节肌力矩后，人体重心的垂直速度得到明显提高，而水平速度则有所下降，在腾起合速度变化不大的情况下，由于腾起角的增大提高了跳远成绩。

There were 36 males and 41 females. one of them died during anesthesia. Another two died within 4 weeks after surgery. The other 74 cases were followed up for more than 6 months. All of them had obtained fracture union. Average operation time was 54.5 minutes. Average blood loss was 150 c.c.. There were several complications. These included 2 superficial wound infection, 6 inferior migration of the nail, 2 nail penetration of the head, 16 knee discomfort, 6 limitation of knee joint motion, 6 with an external rotation deformity of more than 20 degrees.

男性有36位，女性有41位其中有一例因麻醉并发症故未及开刀即死亡，有二例因它病而在开刀后未满四星期内死亡，其余74例追踪时间至少六个月以上，其骨折处均愈合良好，平均手术时间为54.6分，平均出血量为150cc，有二例发生浅部伤口感染，有12例在打入骨钉之骨洞处发生纵走之裂痕，有六例骨钉滑脱，有二例骨钉穿透股骨头，有16例膝部不舒服，有六例膝部活动度受限，有六例发生超过20度之外翻变形。

The artificial total knee arthoplasty is an good therapeutic tool to severve knee joint osteoarthritis and arthritis pauperum.

对严重的膝关节骨关节炎和类风湿性关节炎，人工全膝关节表面置换术是理想的治疗手段。

High quality perioperative nursing of total knee replacement can facilitate and promote the recovery of the knee joint function.

通过对人工膝关节置换术患者的术前及术后康复护理，能加快和促进膝关节功能的恢复。

OBJECTIVE: To summarize classification of knee joint, techniques of knee replacement surgery and complications following replacement.

目的：对膝关节假体的分类、膝关节置换手术技巧及其置换后并发症等方面进行归纳总结。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐