查询词典 kn.

In view of the above factors, to a certain extent, affected the greenhouses of the application and promotion, plus the current bamboo, wood steel prices rising, the vast rural areas in urgent need of a low-cost, corrosion-resistant, resistant to moisture, anti-aging a new framework to shed Instead of the traditional bamboo, wood, steel materials, in the light of this, I units commissioned by the relevant departments, research institutions and the parties concerned under the guidance of experts, completed a "no-pillar greenhouses skeleton of" key project, supported by aircraft I developed a special formula units, the production of greenhouse skeleton without pillars of quality and cheap, quality higher than that of a steel frame, lower than the cost of bamboo, wood, the technical supervision departments test, the main performance indicators are as follows: the simulation of the actual scope: 5.8 - 6.8KN bending strength ≥ 3.3 KN compressive strength ≥ 20 KN water absorption ≤ 13

鉴于上述因素，在一定程度上影响了塑料大棚的应用与推广，又加之目前竹、木钢材价格不断上涨，现广大农村急需一种价格低廉、抗腐蚀、耐潮湿、抗老化的新型大棚骨架来代替传统的竹、木、钢材料，鉴于此，我单位受有关部门委托，在各方科研机构及有关专家的指导下，完成了《无支柱塑料大棚骨架机》的攻关项目，该机配以我单位研制的特殊配方、工艺生产的无支柱大棚骨架质优价廉，质量高于钢架，成本低于竹、木，经技术监督部门测试，主要性能指标如下：模拟实际受力范围：5.8-6.8KN 抗折强度≥3.3KN 抗压强度≥20KN 吸水率≤13

Both KN-Sucrose and KN-Dextrose propellants ignite readily, most likely aided by the natural caramelization process that occurs upon heating.

双方千牛蔗糖和千牛-葡萄糖推进剂点燃容易，最有可能的资助，由自然caramelization过程中发生后，暖气。

Composite membrane was applied in the desalination-purification for dye KB-R, and the rejection for KN-R was kept at nearly 100% and the flux waved about 45L/m h. The dye KN-R was almost desalinized through 8 times cycle.The separation properties of three hollow fiber composite membranes for nucleotide containing phosphate were tested at 0.6MPa, room temperature.

在室温、0.6MPa下，考察了CMa，CMb和CMc三种复合纳滤膜对含有磷酸盐杂质的核苷酸的分离性能，膜CMc对核苷酸的截留率最高(达97.9％)，同时膜的通量也较大(为27.5L／m~2h)，因此选用膜CMc作为核苷酸分离用复合纳滤膜(来源：A586d0dBC论文网www.abclunwen.com)。

Stroke Lead Ball center-to-center diameter Basic load rating Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm mm mm kN kN kg kg/m 70 1 4.15 0.29 0.42 0.01 0.07 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 1.00圈 70000 有大球径滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK4， FK4 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 35.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用。。。

Stroke Lead Ball center-to-center diameter Basic load rating Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm mm mm kN kN kg kg/m 70 1 6.2 0.54 0.94 0.017 0.14 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 1.00圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK5， FK5 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 60.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用 1 无。。。

Stroke Lead Ball center-to-center diameter Basic load rating Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm mm mm kN kN kg kg/m 1100 10 21 11.1 22 0.58 1.81 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer o...

载荷钢球圈列数 DN值预压预压方法导轨型号 1row 2.50圈 70000 有大球径滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK15， FK15 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性 EF15， FF15 单一螺帽右螺纹 1：1 110.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装。。。

Stroke Lead Ball center-to-center diameter Basic load rating Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm mm mm kN kN kg kg/m 200 4 14.65 4.2 7.6 0.13 0.8 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of...

载荷钢球圈列数 DN值预压预压方法导轨型号 1row 1.50圈 70000 有大球径滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK10， FK10 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性 EF10， FF10 单一螺帽右螺纹 1：1 40.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置。。。

Stroke Lead Ball center-to-center diameter Basic load rating Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm mm mm kN kN kg kg/m 20 1 5.15 0.32 0.55 0.012 0.11 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 1.00圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK4， FK4 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 47 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用 1 无无。。。

Stroke Lead Ball center-to-center diameter Basic load rating Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm mm mm kN kN kg kg/m 700 10 21 11.1 22 0.58 1.81 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of...

载荷钢球圈列数 DN值预压预压方法导轨型号 1row 2.50圈 70000 有大球径滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK15， FK15 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性 EF15， FF15 单一螺帽右螺纹 1：1 110.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装。。。

Stroke Lead Ball center-to-center diameter Basic load rating Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm mm mm kN kN kg kg/m 100 10 8.4 2.16 3.82 0.049 0.30 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diamee...

载荷钢球圈列数 DN值预压预压方法导轨型号 2列 1.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK6， FK6 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性 EF6， FF6 单一螺帽右螺纹无 100.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用。。。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。