查询词典 kinetic theory model

Thegeneral study of nuclear structure, including the study of state and the newest development of deformed nucleus, is briefly introduced at the beginning of this article. Bohr quadrupole deformation theory has been deduced in detail. Then based on Bohr model, group kinetic energy and potential energy expression of nuclear in the condition of small deformation was deduced.

本文首先简单介绍了核结构领域的一些研究概况，包括形变核的研究现状及其最新进展，详细推导了Bohr四极形变理论，在Bohr模型基础上(假定原子核是理想不可压缩的无旋流体)，导出原子核在小形变条件下的集体运动动能和势能表达式。

Therefore, the constructed model may violate thermodynamics theory or be unknown, which results in unrealistic biochemical reactions. This study proposes a two-objective optimization approach to estimation of kinetic parameters for modeling metabolic pathways and its application to muscle glycogenolysis.

由於代谢过程之中的动力学参数之间存在著热力学限制以及反应代谢物的Gibbs生成自由能会决定反应平衡常数，使用这类参数值所建成的模型可能未遵守热力学原理，导致不真实的生化反应。

A good example of this imaginary model that helps is found in the kinetic molecular theory, in which gases are pictured as being made up of many small particles that are in constant motion.

在这个理论中，气体被描绘成由许多不断运动的小颗粒组成。

Kinetic model has important significance for both theory and practice studies on microorganism cultivation.

动力学模型对微生物培养过程的理论研究和生产实践具有重要的意义。

M/s. The following dimensionless relationships were obtained: Sh=2+0.073Re〓Sc〓〓〓 The desulphurization process by powder injection and blowing in RH refining of molten steel and its mechanism have been considered and analyzed. Based on the tworesistance mass transfer theory and the mass balance of sulphur in the system, a kinetic model for the process has been developed. The related parameters of the model have been reasonably determined. Modeling and calculations for the process by injecting and blowing the lime based powder flux under the assumed operating modes in a RH degasser of 300t capacity have been carried out using the model.

考虑颗粒与液流的相对速度，RH—PTB条件下熔池传质特性可由下式表征： Sh=2+0.073Re〓Sc〓考虑紊流中脉动速度引起的能量耗散，RH—PTB条件下熔池传质过程服从如下关系：〓将粉剂颗粒与钢液间的传质当作刚性的气泡与钢液间的传质处理，对RH—PTB过程有：〓考察和分析了RH喷粉脱硫过程及机理，基于双重阻力传质理论和体系内硫的质量衡算，建立了RH喷粉脱硫过程的动力学模型，确定了模型各有关参数，包括各传质系数和脱硫处理过程中钢液内参与脱硫反应的粉剂量等。

In this paper,the forming mechanism and affecting favtor of bulk metallic glasses is systematically discussed from the aspects of thermodynamic, kinetic and microstructure . Thermodynamic factors which favor the amorphization of alloys analyzed, the glass forming range of ternary alloys system was proposed by using Miedema theory, Toop model and considering the influence of free energy of pure metals at different temperature. The approach was applied to predict the composition range of amorphous Mg-Cu-La alloys. Several methods(such as three empirical criterions ,binary alloys phase diagram , Miedema theory and Toop mode) were used to design a series of Mg65Cu25La10 、Mg68Cu17La15 and Mg57Cu23La20 alloys, These bulk amorphous alloys with maximum diameter thickness reaching to 1mm were prepared by means of graphite-molding casting though the raw materials are of a low purity by conventional casting processes at a low cooling rate.

本文从合金的热力学、动力学及结构形成条件方面系统的讨论了Mg 基大块非晶的形成机制及影响因素，并从非晶形成的热力学观点出发，综合应用Miedema理论和Toop 模型，并考虑纯金属在不同温度下的自由能，在此基础上提出了一种定量预测三元非晶合金形成范围的方法，用该方法计算Mg-Cu-La 三元合金系的非晶形成范围，应用多项技术(三经验原则、二元合金相图及Miedema 理论和Toop模型)设计了Mg65Cu25La10 、Mg68Cu17La15 和Mg57Cu23La20非晶合金。

In order to reflect the catalyst deactivation during the oxidative polymerization and difference of the reactivity between monomer,the oligomer soluble in water,and the oligomer unsoluble in water,a new heterogeneous kinetic model was proposed according to Flory statistical theory.It was found that the polymerization rate estimated by the new model was consistent with the calculated data.

根据DMP氧化聚合过程中催化剂随时间延长而逐渐失活，不同种类的苯氧阴离子活性不同以及非均相聚合特点，提出了水介质中DMP氧化聚合动力学模型，并采用多元非线形回归计算得到模型参数，采用模型计算得到的聚合速率与实验测定值一致，证明所提出模型的正确性。

In the fifth chapter, the theory of photocatalytic degradation and kinetic study of methyl orange is carried out. Result of kinetic study show that the degradation reaction can be expressed by the first-order reaction kinetic model.

第五章以甲基橙为研究对象，研究了光催化反应动力学及其反应机理，结果表明，该反应降解可以用一级反应动力学方程进行描述。

According to horizontal vibration theory of beam of u- niform section,the kinetic model of the orthogonal turn-milling slender rod is presented,and according to the peculiarity of the turn-milling cutting force,the simplify cutting force model is presented.

根据等截面梁横向振动理论，建立了正交车铣加工细长杆的动力学模型，并根据车铣切削力的特点，建立了切削力的简化模型。

In order to explore the influence of the interactions between particles and between gas and particles on the formation of heterogeneous flow structure, a computational study was carried out by using a two-fluid model based on the particle kinetic theory.

应用双流体模型 CFD模拟的方法，从恢复系数和曳力两方面，研究了气固密相流化床中颗粒之间和气固相之间的相互作用对床内非均匀流动结构形成与变化的影响。

I didn't watch TV last night, because it .

昨晚我没有看电视，因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来，在北京的很多小区里，电梯液晶电视被撤了下来。