查询词典 jointer

I knew that the pieces would be too wide to fit the small diameter of the boiler and look right so out came the saws and jointer.

我知道，作品将过于广泛，以配合小直径的锅炉和照顾的权利，使来自于该锯和接头。

In China, civil procedure law can t classify the necessary jointer, but the procedure theorists think that are two kinds of necessary joint actions.

我国法律对必要共同诉讼未作进一步的分类，同时立法和理论都认为必要共同诉讼包括两种类型。

The jointer provides azimuth information when working with other engineering well logging tool s.

该通用短接可与其它工程测井仪器组合，并提供方位信息。

The basic structure of the WSP-1T special thread jointer recently developed by Wuxi Seamless Steel Tube Co., Ltd.

简介了无锡西姆莱斯石油专用管制造有限公司最近开发成功的WSP-1T特殊螺纹接头的基本结构。

The filter consists of a fuzzy impulse noise detector, impulse noise canceller and fuzzy jointer.

该滤波器由模糊脉冲噪声检测器、噪声消除器与模糊结合器构成。

Author just think carries the research with two kinds of bit jointer mode, announce these two area start in development market economy level and the collective condition that its develop the place in the process to have and foundation.

笔者试想通过两种模式共同点的研究，揭示这两个区域在发展市场经济起步阶段及其发展过程中所具有的共同条件和基础。

Construction practice proved that weld jointer test results by adopting these two kinds of welding combination can both meet the corresponding specification requirements,but these two methods have their different characteristics and applicability.

实际施工应用表明，两种焊接组合焊接接头检验结果均满足相关规范要求，但各有其不同特点及适用性。

The oil tube thread jointer used to conduct coating with the compound lubricant when connect the jointers.

以前在油井管螺纹接头连接时，要进行涂覆复合润滑脂。

However if this kind of compound lubricant coating is omitted, it is not only improve the operation environment, but also reduce the total drilling cost. The non-lubricate high quality tube jointer was developed by Nippon Steel Corp.. It adopt the solid lubricant membrane, the fine lubrication and sealing properties insures the same performance.

但省略这种复合润滑脂的涂覆，不但可改善操作环境，也可降低总钻采成本，因此，新日本制铁公司开发出无润滑剂型高级管接头，此接头采用了固体润滑剂被膜，良好的润滑性、密封性等使用性能确保和以前接头同等。

The results showed that the fracture toughness of the weld of HFW pipe was lowest.The value of absorbed energy of HFW weld was closely related to the heat treatment process.But the fracture toughness of fusion zone of submerged-arc welded jointer,its microstructure was coarse granular bainite,and was lower than the other locations of heat affected zone;and with the increasing of steel strength,the effect of welding heat cycles on the pipeline steel became stronger,and form coarse microstructure in fusion zone leading to decrease fracture toughness.

结果表明，高钢级管线钢高频焊接焊缝处的断裂韧性最低，其冲击功大小与热处理工艺密切相关；而埋弧焊接热影响区断裂韧性在熔合线处最低，其主要原因是此处的组织为粗大的粒状贝氏体，而且强度越高焊接热循环对管线钢的作用越强，在熔合线附近更容易产生粗大组织，使断裂韧性降低。

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。