查询词典 joint-stock

Preparation for a stroke requires that you extend the finger at the middle joint, while keeping the large joint at about the middle point of the limits of its range of motion.

在准备拨弦时你需要伸展这个关节，而保持大关节在运动范围之中的中点位置。

Flange joint bolt is just put in from the side of flange joint component, nut screw in from the side of flange of coupling.

法兰连接螺栓只能从被连接构件的法兰侧放入，螺母从联轴器的法兰侧拧入。

Joint type of this valve is flange joint.

本阀连接方式为法兰连接。

Pointing to some problems such as easy defect of joint, big pushing to voltage of power net and frequent defects existed in hydraulic station control system of BF, the reforming included replacing pressure meter with electric joint by pressure transmitter with intellectual digital display, replacing alternating contactor by alternating frequency conversion technique and increasing relay control to 984PLC control has been done in Jigang.

针对高炉液压站控制系统存在的接点易损坏、对电网电压冲击大、故障频繁等问题，改造采用带智能数显表的压力变送器代替电接点压力表，应用交流变频技术代替交流接触器，并将继电器控制升级为984PLC控制。

Comparison was made about the clinical performance, such as 10 meters walking time, patient self-appraisal, squat activities and sporting pain, joint swelling, joint effusion and bone friction sound of the three groups of patients before treatment and one months, three months, six months, one year after treatment.

对比观察三组患者治疗前和治疗1月、3月、半年、1年时10米步行时间、患者自我评价、下蹲活动及运动疼痛、关节肿胀、关节腔积液、骨摩擦音等临床表现。

The suitability of the different processes was analyzed by observing the weld appearance,studying the microstructure and measuring the mechanical properties of the joint.The results show that a favorable weld can be obtained under the suitable parameters by laser beam welding or tungsten inert gas welding with filler metal.The TIG welded joint has a wider HAZ,and the laser welde...

试验结果表明：在工艺参数合适的条件下，加焊丝TIG焊和激光焊均能获得成形较好的焊接接头；TIG焊接头热影响区较宽，焊缝深宽比小，而激光焊时热影响区不明显，焊缝深宽比大；两种焊接方法所获得的焊缝区组织均为均匀的等轴晶，但激光焊时焊缝组织更细，从而使接头抗拉强度大幅度提高，达到母材的94%左右。

The equal rigidity design for the flexible joint of DTG is discussed in this poper,which derived the equations of calculating the axial and radial rigidity of two gimbal flexible joint inthis paper.

本文讨论了动力调谐陀螺仪挠性接头的等刚度设计，导出了双平衡环动调陀螺挠性接头轴向刚度和径向刚度的计算公式。

I got a mail which contain the information of developing a kind of new head joint from a friend who always sent me mails before, it likes old Chedeville head joint, made with the same material, and it can make more shake.

我从一位常给我写信的人那里收到了一份介绍一种新开发专业笛头的函件，它类似于老的 Chedeville 笛头，用同样的材料制造，并应该能够产生更多的震动。

Measurement should be done after each step to properly correct the deformity and avoid secondary instability. Alignment of the femur and tibia should be correct to ensure the center of the femoral head, knee joint and ankle joint at the same line.

结果显示对于严重的膝内外翻畸形和屈曲畸形的患者，软组织松解平衡应有计划、分步骤地进行，每完成一步都要进行测量，要做到既纠正到位，又不可过度纠正造成关节继发不稳定。

The results show that laser-arc welding can achieve full penetration by single-path butt jointing through appropriate parameters; Y shape groove with 8 mm truncated edge can enhance the penetration ability of laser-arc hybrid welding. Low welding speed is good for penetration, however the limitation still exists for hick plates joint. Gap is significant factor of penetration when work pieces is large thickness. The hardness of thick plates joint shows that there is big difference in mold of vertical thermal cycle using laser-arc hybrid welding.

结果表明：通过激光功率等焊接规范匹配，激光-电弧复合焊接能实现20 mm厚板的全熔透单道对接；钝边为8 mm的Y形坡口有助于提高厚板激光-电弧复合焊缝熔透能力；降低焊接速度有利于提高熔深能力；工件厚度较大时，装配间隙对焊缝熔深能力的影响较为显著；接头硬度表明厚板激光复合焊焊缝纵向热循环模式存在较大差异。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。