查询词典 jockey pump

In order to obtain more exact analytical solution to study the output characteristics of double-clad fiber lasers,according to the continuous-wave rate equations of fiber lasers,using typical parameters of double-clad fiber lasers,the contribution of the re-emission effect arising from the interaction between the upper-level atoms and pump light was estimated.Taking into account the predominant part of the re-emission to improve the accuracy of the integration approximated rate equations,the integration of the product of the loss and radiation should be found and explicit analytical expressions for the output of the DCFLs and gradient efficiency of the pump radiation,were deduced,and certain issues of concern were discussed.

为了求得用于研究双包层光纤激光器输出特性的更为精确的解析解，根据稳态速率方程组，针对典型的双包层光纤激光器参量，在估计了上能级粒子再发射项和抽运光产生的影响后，采用保留再发射贡献主导部分的办法以提高可积分近似方程的精确度，明确地提出了要获得光纤激光器输出功率的解析表达式的关键在于求出损耗系数与光场乘积的积分值，简洁地求得了输出功率和抽运光斜线效率的显函数解析表达式，并对其相关问题进行了讨论，以915nm，920nm和975nm的抽运光为例，当输出激光为1090nm时，得出975nm抽运光产生的斜率效率最高并可高达约87%。

Multiple class partial flow pump:(1)The head coefficient value should be low in the single class partial flow pump.(2)The total area of larynx wicket gate should be 200% the single classs larynx area.

2对于多级部分流泵：(1)部分流多级泵扬程系数的取值应比单级部分流泵的取值偏低一些；(2)部分流多级泵导叶总的喉部面积应是单级部分流泵喉部面积的两倍。

A new type of mud pump with high flow, high pressure, compactness and light weight is designed for truck mounted water well drill rig, tackling the difficulty in mud pump matching.

为车装水文水井钻机设计大流量、压力、体积、质量的新型泥浆泵，解决其泥浆泵配套难的问题。

Theoretically the pump blade failure mechanism was worn on, the impact of wear failure leaves the various factors was analyzed, combined with practice pumping station operation and maintenance experience, the focus at a reasonable selection, surface heat treatment, non-metallic protective coating alloy powder spray repair welding and welding six aspects, premature wear of the pump blade technical measures and repair methods was prevented in order to enhance its effective life.

理论上阐述了水泵叶片磨损失效的机制，具体分析了影响叶片磨损失效的各种因素，并结合泵站运行实践和维修经验，重点在合理选材、表面热处理、非金属涂层防护、合金粉末喷焊和补焊等6个方面，提出了防止水泵叶片过早磨损的技术措施和修补方法，以提高其有效的使用寿命。

By using ZW-100 water-jet loom as an example, the work principle of pump piston for water-jet looms is introduced and the design of the pump piston is carried out by the common optimization design method and fuzzy optimization design method.

以日本津田驹ZW-100喷水织机为例，在介绍喷水织机的工作原理的基础上，对喷水织机的水泵柱塞进行了普通优化设计和模糊优化设计。通过对优化结果的对比分析，得出了采用模糊优化设计优于普通优化设计的结论

With method given by the paper, the impeller and volute of centrifugal pump can been designed according to the flow rate and head, and take optimization choosing with numerical test to aubstitute for real pump or model teat.

用本文提出的方法，可以根据设计工况点或高效点的流量与压头的要求，通过数值计算，确定离心泵通流部分的形状和尺寸，并且用数值试验进行优化选择，以代替多种方案的模型或实物试验进行优化方案的选择。

It is available to carry out numerical simulation and fluid dynamic analysis further. Based on Frozen-Rotor Approach and Rotor-Stator Approach, the numerical simulation was carried out in the centrifugal pump and the numerical results showed that the flow in the impeller and volute of centrifugal pump is periodically unsteady. Due to the interaction between impeller and volute the flow is characterized by pressure fluctuations and it is the strongest at impeller outlet and at the vicinity of the tongue. The unsteady pressure fluctuations are also one of the most important reasons to induce vibration and noise. Secondly, the flow field of the volute is characteristic of the vortex flow, and the vortex flow presents very complicated developing process which is creating, increasing and dissipating every now and then. All these lead to very large flow loss in the volute.

采用Frozen-Rotor冻结转子模式和Rotor-Stator滑移界面模式系统开展了不同工况下离心泵内叶轮与蜗壳耦合的定常和非定常流动研究，结果表明由于叶轮与蜗壳的干扰蜗壳进口周向流动的不均匀性是非常强烈的，特别是叶轮与蜗舌间的相互干扰最为强烈，一直影响到叶轮进口和蜗壳扩散管出口的流场；在蜗壳内整个流动是以旋涡形式向出口推进的，并随着包角的变化旋涡表现出十分复杂的产生、发展和耗散的演化过程，导致蜗壳内较大的流动损失。

Note: The decompression valve role in continuing to do, there will be a part of the oil (about 1 L / min) flow back into the tank through the vent port lost the oil pump part of the output flow, so in a system, such as the use of several cut pressure valve, you must take into account the loss of pump output flow problems.

注意： 减压阀在持续做减压作用时，会有一部分油（约1 L/min）经泄油口流回油箱而损失泵的一部分输出流量，故在一系统中，如使用数个减压阀，则必须考虑到泵输出流量的损失问题。

According to the project practice of pumps in Yu-zhong Steelworks, this paper put forward some water hammer preventive measures of long distance pipe pump station of water supplying, such as the multifunction controlling valve of the water pump, one-way surge tank and vent valve, etc.

根据水锤计算的特徵线法，建立了泵出口附近设单向调压塔水锤计算的数学模型，结合榆中钢厂供水泵站的工程实际，提出了长管道供水泵站采用多功能水泵控制阀、单向调压塔、进排气补气阀对事故停泵水锤的防护措施。

When the pump to work, you can cut off the water through the valve and pump impeller ring round access, and release the water within the liquid ring round.

当泵正常工作后，可通过阀截断水环轮和水泵叶轮的通道，并且放掉水环轮内的液体。

You can snipe the second and third union leaders from this position.

您可以鹬第二和第三工会领袖从这一立场出发。

Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.

针对当前XML数据流质量检测存在的不足，提出构建XML键的矢量矩阵作为窗口，利用矢量积小波变换多级分解与重构XML数据流，再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法，满足XML数据流质量重构时实时检测的要求，保证XML数据的约束性、一致性与完整性；为了更好的适应网络负载，采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。