英语人>网络例句>jet stream 相关的网络例句
jet stream相关的网络例句

查询词典 jet stream

与 jet stream 相关的网络例句 [注:此内容来源于网络,仅供参考]

The results show that: Near the slot exit, three synthetic jets couple to one jet and move downstream. Two synthetic jets on both sides are limited and rolled by the middle synthetic jet until they merge together into one centrosymmetric synthetic jet.

研究结果表明:三股自耦合射流都在出口附近耦合成一股射流向下游运动,两侧的射流受到中间一股射流的卷吸融合在一起,融合后仍然是一股沿中心线对称的自耦合射流。

The deflective mechanism of the oscillating water jet is analyzed and the effects of jet deflection on the self oscillating water jet are investigated.

分析了自激振荡射流的偏转特性,研究了偏转特性对射流振荡脉冲压力、射流切割性能等方面的影响。

According to the actual parameters of coal mining face, the models of jet blower and air compressor are made out. Then locate the jet blower on mining face and air screen is produced by the jet blower to prevent the gob areas gas effusing to the top even angle.

然后在工作面具体安放射流风机,通过射流风机产生空气幕进行均压、阻断采空区瓦斯向上隅角涌出。

A hotwire anemometer was used to measure the jet velocity at the exit of the precessing jet nozzle and the power spectrum density was obtained afterwards in order to analyze the precessing feature of the jet. It is shown that an obvious precession motion is generated in a nozzle even with a large expansion ratio E=10 and a small length-to-diameter ratio LD=2. The precessing frequency is mainly dependent on the nozzle diameter and the intake flow rate, increasing with the enhancement of the flow rate and with the reduction of nozzle diameter.

采用热线风速仪测量旋进喷嘴出口射流的速度,并对该射流进行功率谱分析以研究其旋进特性,结果表明,实验所用的膨胀比E=10、长径比L/D=2的喷嘴同样能产生明显的旋进射流,旋进频率主要取决于喷嘴的尺寸和射流的流速,并随流速的增大和喷嘴直径的减小而增大。

In comparison with bugle shaped nozzle, bifurcated nozzle downward jet angle 45°, cow-nose nozzle and three-hole nozzle, in all, the last two are better than the former and bifurcated nozzle downward jet angle 45 is better than bugle shaped nozzle; Cow-nose nozzle is helpful for guaranteeing the product's quality, in order to protect jet flow from eroding the strand at narrow face, gain uniform temperature distribution at cross section and decrease heat flux, adding the block's width to 100 mm. Three-hole nozzle is advantageous to increase flux and casting speed, but should avoid weak shell thickness in the center broad. In the real production, setting the SEN's immersed depth or plugging the hole at the bottom can adjust the flow and temperature distribution in the mold.

对比喇叭形水口,双侧孔水口(45°),牛鼻子水口和三孔水口,总的说来后两者优于前两者;而双侧孔水口(45°)又优于喇叭形水口;牛鼻子水口和三孔水口比较各有特点,前者对保证铸坯质量有利,为防止流股对窄面的冲击,增加挡块宽度到100 mm,可使结晶器横截面上温度分布更加均匀,降低窄面热负荷;后者对增加流量,提高拉速非常有利,但要防止中孔射流过强导致铸坯中心坯壳变薄,在实际生产中可通过控制水口浸入深度或塞住浸入式水口的底孔来调节结晶器中的流动与温度分布状态。

In comparison with bugle shaped nozzle, bifurcated nozzle downward jet angle 45°, cow-nose nozzle and three-hole nozzle, in all, the last two are better than the former and bifurcated nozzle downward jet angle 45 is better than bugle shaped nozzle; Cow-nose nozzle is helpful for guaranteeing the product"s quality, in order to protect jet flow from eroding the strand at narrow face, gain uniform temperature distribution at cross section and decrease heat flux, adding the block"s width to 100 mm. Three-hole nozzle is advantageous to increase flux and casting speed, but should avoid weak shell thickness in the center broad. In the real production, setting the SENs immersed depth or plugging the hole at the bottom can adjust the flow and temperature distribution in the mold.

对比喇叭形水口,双侧孔水口(45°),牛鼻子水口和三孔水口,总的说来后两者优于前两者;而双侧孔水口(45°)又优于喇叭形水口;牛鼻子水口和三孔水口比较各有特点,前者对保证铸坯质量有利,为防止流股对窄面的冲击,增加挡块宽度到100 mm,可使结晶器横截面上温度分布更加均匀,降低窄面热负荷;后者对增加流量,提高拉速非常有利,但要防止中孔射流过强导致铸坯中心坯壳变薄,在实际生产中可通过控制水口浸入深度或塞住浸入式水口的底孔来调节结晶器中的流动与温度分布状态。

On basis of the features of Yuanliangshan tunnel, jet ventilation technology has been successfully used in the construction of the tunnel and the calculation method for the air volumes of construction jet ventilations are improved. The calculation method for the air volumes of construction jet ventilations is not only suitable for gas tunnels consisting of twin tubes, but also suitable for long tunnels with ancillary adits and large-scale underground structures.

在圆梁山隧道的施工通风中,结合该隧道特点,成功实施了射流通风技术,并进一步完善形成了施工射流通风的风量方法,该方法不仅适用于有平行双孔的瓦斯隧道,同时也可在有辅助坑道的长大隧道或者大规模地下空间的施工通风中推广应用。

These engines deal with larger comparative airflows and lower jet velocities than the pure jet engine, thus giving a propulsive efficiency (Part 21) which is comparable to that of the turbo-prop and exceeds that of the pure jet engine fig.

因而,其推进效率(第21章)与涡轮螺旋桨的相当,超过了纯喷气发动机的推进效率(图1-lO)。

Jet-type (including the liquid jet and gas jet).

喷射的流体式(包括液体喷射的流体和气体喷射的流体)。

Jet-type (including the liquid jet and gas jet).

射流式(包括液体射流和气体射流)。

第5/500页 首页 < 1 2 3 4 5 6 7 8 9 ... > 尾页
相关中文对照歌词
Jet
Death From Above
Jet Blue Jet
The Jet Set
Jet Set (Demo 2)
Jet Boy Blue
Jet Lag
Leaving On A Jet Plane
Jet Airliner
Jet Pilot
推荐网络例句

Finally, the Knight strung a line between two of the monoliths and tied the horses up there.

最后,骑士们在两颗巨石之间拉了一条绳子,将他们的座骑绑在上面。

T7zN/hyS0 The island lies south by east from here.

那个岛位于此地的正南偏东方向。

However, the design and research of 3D coaxial feeding head dont appear.

聚焦方式:透镜/反射聚焦;送粉方式:载气式/非载气式。