查询词典 iterative method

In this way, the demodulation arithmetic and pulse compression of multi-channels can be packed into a single FPGA.To compensate the nonlinear effect of power amplifier, a successive overrelaxation iterative method of digital predistortion is applied here to ensure the low sidelobe performance, high output power and fast iterative speed.

分析了功放非线性对超低副瓣脉冲压缩信号的影响，基于射频功率放大器、矢量信号发生仪和矢量信号分析仪，采用松弛迭代法实现并优化了功放数字预失真算法，提高了迭代收敛速度与稳定度。

Nonlinear equations of the iterative solution, including : simple iterative method, Newton, secant, to the Newton law.

非线性方程组的迭代解法，包括：简单迭代法、Newton法、割线法、拟Newton法等。

In the solution of the Difichlet boundary problem ofLaplace equations, we provide an effective method for determining the spectral radiusand the best slack variable of block basic iterative methods. At the same time, wepresent the spectral radius and the best slack variable of basic iterative methods from thenine-point difference scheme.

在解决Laplace方程Dirichlet边值问题上，文章为确定块基本迭代方法的谱半径和SOR方法最优松弛因子提供了一个有效的方法，并推导了九点差分格式下的块基本迭代方法的谱半径和SOR方法最优松弛因子。

For solving the linear system with the iterative method, it is very important to estimate the spectral radius of the iterative matrices.

在用迭代法解线性方程组时，迭代矩阵的谱半径估计在迭代法的收敛性分析中起着重要的作用。

For example,,,where .2.Convergence of the iterative method: firstly I give a new upper bound for the spectral radius of iterative matrix , where is a double strictly diagonal dominant matrix.

迭代法的收敛性分析：首先给出了一般迭代阵谱半径新的上界估计，其中矩阵为双严格对角占优矩阵，是一种比严格对角占优更广泛的矩阵类。

The paper describes a new iterative decoding algorithm for the product codes, its feedback method is completed by a linear combination of soft output of encoder and the receipt information is different with the traditional turbo iterative decode. When decoder obtains the soft output matrix built -1 and +1, the complexity can be reduced greatly and the performance can be lost utile by reducing the number of candidate code words and omitting the complicated operation of LLR.

针对乘积码提出一种新的迭代解码算法，该算法的反馈方式有别於Turbo码的传统迭代译码，是通过输出软信息与接收软信息进行线性叠加来实现的，此时子译码器的候选码字个数将大为降低，同时译码输出也无须做复杂的LLR计算，直接映射为由-1，+1组成的软输出矩阵，从而在牺牲较小性能的情况下很大程度地降低了译码复杂度。

Many questions in natural science and engineering canbe transformed into nonlinear equations to be salved,Newton iterative method is an important technique to one-and multi-dimensional variables and iterative process exhibits sensitive dependence on initial guess point.

自然科学与工程中的许多问题都可以转化为非线性方程组的求解问题，牛顿迭代法是重要的一维及多维的迭代技术，其迭代本身对初始点非常敏感。

Firstly, this paper investigated roundly the basic theory of the ambient vibration method, analyzed systematically the main methods of ambient vibration identification, and discussed their advantages and disadvantages. Then we established the finite element model of structural dynamics and test model and analyzed their mutual relation, improved MUSIC method and correlation function method in the harmonic identification, and gave the subspace method and correlation function method based on continuous model, which is multi-harmonic retrieve technique. And then, this paper also puts forward least-squares method to estimate directly structural physical and modal parameters; this approach replaced the derivative operator in the continuous time model with an equivalent approximation, and estimated the physical parameters of structures by the least-squares method. And then, we discussed the approximation methods of derivative and their convergence. Finally, this paper researched the modal parameters of a frame structure by the simulation and test. The results demonstrated that subspace method, correlation function method and the least-squares method are effective and stable respectively.

全面地研究环境振动识别方法的基本理论，系统地分析环境振动识别方法的主要方法，讨论它们的优点和不足；建立结(来源：6666AB44C论文网www.abclunwen.com)构动力学的有限元模型和试验模型，分析有限元模型与试验模型之间的相互关系；改进谐波识别中的MUSIC识别方法和相关函数识别方法，给出大型结构模态识别的连续型的子空间分解识别方法和相关函数识别方法，这个方法是多元谐波识别方法；提出直接识别结构的物理参数和模态参数的最小二乘方法，这个方法利用导数的近似值代替导数值，并运用最小二乘方法识别结构的物理参数，讨论导数近似值的选择方法，分析算法的收敛性；通过仿真计算和模型实验，研究高层框架结构的模态参数识别，验证子空间分解识别方法、相关函数识别方法和最小二乘识别方法的有效性，算法的稳定性；从理论和试验两个方面分析和研究噪声对识别精度的影响，影响识别精度的因素，以及部分模态成分的模态参数不能够被识别的原因。

The revised Hargraves formula has the best result compared with Penman-Monteith formula, the average relative error is 6%, moreover, Hargaves method requiring the least data in calculating ETo, so this method has the high actual application value; The following are Radiation method and Blaney-Criddle method ; The worst is the Pan method, even after revised, the highest and average relative error is 36% and 10%, respectively. So, in this study, Penman-Monteith method, Radiation method, Blaney-Criddle method and Hargraves method are used except Pan method.

在这四种方法中，修正后的Hargraves方法与彭曼—蒙特斯方法的计算结果符合最好，其平均相对误差为6％，而Hargraves方法需要的气象数据只有计算时段的最高、最低温度，该方法具有较高的实际应用价值；辐射方法和布兰尼—克里德尔方法次之；蒸发皿方法最差，即使在修正后，E601型蒸发皿的最大误差也高达36％，平均为10％，所以在预报系统的研究设计中采用了除蒸发皿方法之外的四种方法。

The primary studying works and characteristics:1 To summarize reinforcing theory of cement mixing pile composite foundation2 To analyze the primary mechanics characters and changing rules of cement mixing pile, based on analysis of test data both indoor and outdoor.3 To discuss siding frictional resistance, ending resistance, ultimate bearing capacity of simple mixing pile and effectiveness factor of grouped piles, loading ratio of soil between piles under cushion cap of grouped piles and stress ratio of pile and soil and so on, and use many computation method and experimentation method to ensure bearing capacity of mixing piles composite foundation.4 To point out and analyze eight sides flaws and problems of the bearing capacity calculation method of mixing pile compositefoundation which ensured by national and normative method/ formula.5 To apply test results of loading tests and a few settlement observation data, use gray theory to predicate ultimate bearing capacity of deep mixing piles, actual example demonstrate engaging between theoretical predicted value and actual value.6 To apply groovy layerwise summation method to discuss entity piles method, double foundation method, equivalent layerwise summation method and consolidation theoretical method and so on, especially by combination of engineering example, use FEM to calculate or discuss the settlement and changing rules of composite foundation.7 To discuss problems of critical length of composite foundation by combination of engineering example and numerical analysis method, and analyze the contrast of critical length between simple pile load and most area load of composite foundation, not only critical length of composite foundation is relative to modulus ratio between piles and soil, but also upside load distribution area of composite foundation.

主要的研究工作与特色为：(1)总结了水泥搅拌桩复合地基的加固原理；(2)在对室内外试验资料进行统计分析的基础上，系统分析了搅拌桩水泥土的主要力学特性及其变化规律；(3)探讨了搅拌单桩的侧摩阻力、端阻力、极限承载力及群桩效率系数、群桩承台下桩间土荷载分担比及桩土应力比等，提出用多种计算方法并结合试验方法来综合确定搅拌桩复合地基的承载力；(4)明确指出和分析了按国家有关规范的方法确定搅拌桩复合地基承载力所存在的八个方面的缺陷与问题；(5)利用过去没有加载至破坏阶段的载荷试验成果和较少的沉降观测数据，尝试了用灰色理论预测深层搅拌桩的极限承载力，实例表明理论预测值与实测值吻合较好；(6)在常规分层总和法的基础上，探讨了复合地基沉降计算的实体墩基法、双层地基法、等效作用分层总和法、固结理论法等，特别是结合工程实例，用有限元数值计算等方法计算和讨论了搅拌桩复合地基的沉降及其变化规律；(7)结合工程实例，用数值分析方法探讨了复合地基临界桩长的问题，指出和分析了单桩荷载下的临界桩长与复合地基大面积荷载下的临界桩长存在很大的差别，复合地基的临界桩长不仅与桩土模量比有关，而且与复合地基上部荷载分布面积有关。

Nowadays, most of research are to build a transmutative Petri Nets through adding controlling place sets, controlling arc sets and controlling policy to the basic Petri Nets, while the Controlled Petri Nets could be used to argue many controlling theory problems conveniently and to induce many logically and physically supervisory and solve the Event Feedback Controlling Problems and State Feedback Controlling Problem in DEDS supervisory theory.

目前大多数的研究表现为在变形后的受控Petri网基础上，利用各种方法求得各种逻辑型、结构型控制器，解决DEDS监控理论中的事件反馈控制问题与状态反馈控制问题。

On one hand, there are discussions with the works council and union about extension of short time working up to the end of September.

一方面，有讨论，工程理事会和联盟关于延长工作时间短至9月底。