查询词典 iteration method

First, a special normal transversal at the initial point is constructed and a second-order Taylor's algorithm is used to trace the projections along the aforementioned normal transversal. A curvature based method for controlling iteration step is further proposed by projecting the given point onto the curvature circle of the normal transversal at the initial point. Finally gradient based method for correcting iteration errors is put forward.

首先构造初始点处的一条特殊的法截线，并给出沿着该法截线追踪投影点的二阶泰勒迭代方法；然后将给定点向初始点处的法截线的曲率圆作投影，提出基于曲率的步长控制策略，在此基础上给出了基于梯度的迭代误差矫正方法。

In this chapter proposed the repetition iteration algorithm through the training sequence and its the corresponding array data-in repetition useenlarges the TD-SCDMA channel in the iteration step, may approach theoptimum result under the short data length, take the LMS algorithm asthe example simulation result indicated this method is feasible, mayeffectively improve the TD-SCDMA system smart antenna the performance.

本章中提出的重复迭代算法通过把TD-SCDMA信道中训练序列及其对应阵列输入数据重复使用加大迭代步数，可以在短的数据长度下逼近最佳结果，以LMS算法为例的仿真结果表明该方法是可行的，可以有效改善TD-SCDMA系统智能天线的性能。

Introduces the Julia set's definiens of Newton iteration function. With the aid of computer and the theory method ,this paper discusses the Newton iteration function's Julia set and Julia set's fractal structure of polynomial f=z 4-1 on complex plane , and also shows the Julia set's graph.

介绍了复平面上Newton迭代函数的Julia集的定义，借助计算机迭代制图及理论方法讨论了复平面上4次复多项式f＝z4－1的Newton迭代函数的Julia集及Julia集的分形结构，给出了其Julia集的分形图形。

Including the main-element elimination method, the direct LU decomposition, Jacobi iteration, high Sisaideer iteration.

包括了列主元消元法、直接LU分解法、雅克比迭代、高斯赛德尔迭代法。

The idea and method of realizing iteration function system, graphics iteration system and L-system in Flash, are explored in this article.

探讨了在Flash中实现迭代函数系统、图形迭代系统和L系统的思路和方法。

Based on prestressed steel beams, considering effect of the method of construction to slip and stress increment, accoding to conception that procedure of calculation reflects the procedure of construction and change of structural internal force, making good use of the method of section conversion and making iteration reflect the coupling of slip and stress increment, bringing forth a method of iteration and modified stiffness to calculate the deflection of prestressed composite steel-concrete beams in normal servicing prase.

以预应力钢梁为基础，充分考虑施工方法对结构滑移和应力增量的影响，依据设计计算中反映施工过程和结构受力变化过程，通过截面换算，以循环迭代法来考虑滑移和预应力钢束的耦合作用，提出了计算预应力钢—混凝土组合梁正常使用阶段挠度变形的迭代—修正刚度法。

The modal parameters of some typical structures, such as cantilever beam, stiffened plate were calculated with the iteration method.

用这种迭代算法计算了几种典型阻尼结构悬臂梁和压筋板的模态参数，计算结果与试验模态分析结果或理论解析计算的结果基本一致。

5Study on vehicle-bridge coupled vibration program of multi-beams bridgeThe vehicle-bridge coupled vibration equation is detruded on the base of three axisvehicle,and the vehicle-bridge coupled vibration program is established with iteration method,which is used for analyzing the dynamic response of the assembly slab bridge.

5板桥车-桥耦合振动程序研究以三轴车辆为例建立车-桥耦合振动方程，采用分离迭代法，编制了板桥车-桥耦合振动程序，并以实例验证了其计算结果的正确性，为装配式板桥动力响应分析提供计算平台。

The two feasible engineering application curves are given which curve pc*=f1,optimum combustion chamber Pc* versus nozzle expansion ratio ε and curve ε*= f2, optimumnozzle expansion ratio ε versus combustion chamber pressure Pc resoved by iteration method.

用迭代法求解，给出了两条工程上行之有效的曲线──最佳燃烧室工作任强随喷管膨胀比ε的变化曲线和最佳喷管膨胀比ε*随燃烧室工作压强pc的变化曲线。

To compute the solution to the nonlinear equation of pressure in the Riemann problem for the pressure grdient equations, the Godunov scheme gives a reasonable approximate value for the exact solution. By using the Newton-Ruphson iteration method and some necessary computation, we get the inter-cell numerical flux directly.

为求压差方程黎曼问题中关于压力的非线性方程的解，Godunov格式给出一个合理的初始近似值，利用Newton迭代法和一些必要的计算得到格式中的数值流。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。