查询词典 isothermal parameter

In this paper,the internal energy and heat of the polytropic process ,the adiabatic process and the isothermal processes of the varying mass system are discussed.

讨论了变质量系统的多方过程、绝热过程及等温过程的能量关系，并与常质量系统的多方过程、绝热过程及等温过程的性质进行了比较。

When the equivalent strain rate is relatively low, this influence can be neglected and the compression process can be considered as an isothermal process. While the equivalent strain rate is high, this influence is of importance and the compression process can be approximately considered as an adiabatic process.

当等效应变速率很小时，变形热效应对流动应力的影响可忽略不计，压缩过程可近似认为是等温过程；当等效应变速率较大时，变形热效应对流动应力的影响相当显著，压缩过程基本上成为绝热过程。

When the equivalent strain rate is relatively low, this influence can beneglected and the compression process can be considered as an isothermal process. While the equivalent strain rate is high, this influence is of importance and the compression process can be approximately considered as an adiabatic process.

当等效应变速率很小时，变形热效应对流动应力的影响可忽略不计，压缩过程可近似认为是等温过程；当等效应变速率较大时，变形热效应对流动应力的影响相当显著，压缩过程基本上成为绝热过程。

Non-isothermal combustion shows that the apparent activation energy and the frequency factor both decreased with increasing bitumious coal content...

非等温燃烧的研究表明，以特征温度区间计算，表观活化能和频率因子均随混煤中烟煤比例的增加而降低。

During isothermal extruding of blank, in order to make the material fill successfully into the mold cavity and demould successfully, by using dressing on curved surface of the globoid cams and adopting circular arc transition on each connection, the blank with high precision and shape approximate limit was obtained.

在毛坯等温挤压过程中，为使材料顺利地充满凹模型腔以及成形后脱模顺利，通过在弧面凸轮曲面上加盖敷料及在各连接处采取圆弧过渡，以制得高精度的近似净形零件毛坯件；并采用MSC。

The influences of isothermal quenching temperature on the retained austenite and mechanical properties of ADI were studied.

摘要研究了等温淬火温度对ADI中残余奥氏体及其力学性能的影响。

The article discusses carefully the no-existence condition of limit cycle of a nonlinear kinetic model in isothermal branched-chain or autocatalysis chemical reaction in the CSTR.

详细讨论了CSTR反应器中简单的分枝链式自动催化反应的非线性动力学模型的极限环不存在的条件，给出了某些特殊情况下极限环存在的条

The solubility limit of element Ta in binary compound NiZr2 wasdetermined as 13.5 at% at the present experimental temperature.3 The investigation of the phase equilibrium relation arid the thermodynamic extrapolation of Ni-Cr-Zr ternary system at 1173 KThe isothermal section of Ni-Cr-Zr ternary system at 1173 K was determined and the phase equilibrium relation and their stability were analyzed and discussed.

同时，利用文献所报道的有关该体系的相关二元子系统的热力学信息成功地外推和预测了该三元系的热力学性质。

The concentration distribution of pulverized coal in blowpipe of blast furnace was measured in an isothermal two-phase model by means of a computer measuring system based on infrared transmission.

利用开发的红外透射法粉体浓度计算机测定系统，在高炉氧煤喷吹气-固两相流动模拟装置上测定了氧煤枪的煤粉浓度场。

The effective energy barrier for non-isothermal crystallization was estimated as a function of the relative degree of crystallinity using the isoconversional analysis of calorimetric data.

能源的有效屏障非等温结晶估计作为一个功能的相对结晶度使用isoconversional分析热数据。

The dissecting of samples in group2 were difficult. The root of pulmonary artery and ascending aorta failed to be unfolded because fibrous tissue was tough, right and left fibrous trigone were too firm to be solved by hand. Cardiac muscle fibers couldn't be stripped along myofibrillar trajectory since they were prone to break because of their friability.

组2的心脏解剖困难，表现为纤维组织坚韧，游离肺动脉非常困难；徒手无法松解左、右纤维三角，肺动脉和主动脉根部的游离非常困难；心肌纤维坚硬、质脆，解剖时容易断离成碎块，无法沿纤维走行方向剥离。

We have battled against the odds in a province that has become increasingly violent.

我们对在一个争夺日益激烈省的可能性。