查询词典 iron alloy

For pre-selection of iron compounds that ferrous sulfate, ferrous chloride, ferrous fumarate, carbonyl iron, amino acid chelated iron, iron asporotate, fenic chloride and ferric pyrophosphate were added in reconstituted skim milk to undergo in vitro digestion, respectively, and then the selected iron compounds were added in reconstituted whole milk to compare the iron bioavailability by estimating dialyzable ferrous iron, dialyzable total iron, nondialyzable and total ferrous iron, respectively.

取硫酸亚铁、反丁烯二酸亚铁、氯化亚铁、艰基铁、Iron asporotate、Amino acid chelated iron、氯化铁与焦磷酸铁等不同铁剂添加於脱脂还原乳中进行体外消化试验，并筛选生物利用性佳之铁剂分别添加於全脂还原乳中，以可透析二价铁、可透析总铁、未透析二价铁及总二价铁等作为评估之指标。

For pre-selection of iron compounds that ferrous sulfate, ferrous chloride, ferrous fumarate, carbonyl iron, amino acid chelated iron, iron asporotate, fenic chloride and ferric pyrophosphate were added in reconstituted skim milk to undergo in vitro digestion, respectively, and then the selected iron compounds were added in reconstituted whole milk to compare the iron bioavailability by estimating dialyzable ferrous iron, dialyzable total iron, nondialyzable and total ferrous iron, respectively.

取硫酸亚铁、反丁烯二酸亚铁、氯化亚铁、艰基铁、Iron asporotate、Amino acid chelated iron、氯化铁与焦磷酸铁等不同铁剂添加於脱脂还原乳中进行体外消化试验，並筛选生物利用性佳之铁剂分别添加於全脂还原乳中，以可透析二价铁、可透析总铁、未透析二价铁及总二价铁等作为评估之指標。

The result shows that modification can make the β-Si phase thin when the joining amount is 0.3wt%, making the best modification result. Alloying elements Mn and Ni are always used to neutralize iron"s harm in aluminum alloys. They can form many kinds of complicated metallically compounds with Fe and Al, and eliminate needle-like iron-rich phases to reduce iron"s harm in Al-Fe alloy. Copper makes the alloy microstructure thick and electromagnetic stirring obviously makes the alloy microstructure thin, round the second phase, when the stirring voltage is 200V, making the best result; Reheat makes liquid phases emerge in the alloy, when the warming temperature is 650?

研究结果表明：红磷可以明显细化合金中的初晶硅，当加入量为0.3wt%时，取得最佳变质效果；锰、镍合金中加入后，通过形成多种复杂金属间化合物，细化针片状富铁相，减小铁对铝硅合金性能的危害；铜使合金微观组织发生粗化；电磁搅拌明显细化合金组织，使第二相圆整化，搅拌电压为200V时，取得最佳细化效果；二次加热使合金组织中产生部分液相，在650？

Iron-base fluxed alloy is produced by adding suitable amount of boron and silicon into iron-carbon alloy, which is usually used on the wearable and weak-acid-medium proofing accessories under 500℃. Although the performance of iron-base fluxed alloy can not match with that of the nickel or cobalt alloy, it has wide source materials and low prices, which is the great advantage for application.

铁基自熔性合金是铁——碳合金中加入一定量的硼、硅元素制成的，通常应用在常温——500℃以下耐磨损、耐弱酸腐蚀介质的机械零部件上，仅管铁基自熔性合金，综合性能不如镍、钴基合金，然而原料来源广泛，价格便宜，这是其得以普及应用的较大优势。

Is a research, development, production and sales of integrated enterprise, mainly produces high-speed road crash barrier, the ball ink on water pipes, ductile iron pipe, centrifugal ductile iron pipe, ductile iron manhole covers, cast iron spilled water pipes, cast iron pipes, cast iron-cast copper-wing-style cast aluminum alloy radiator, cast iron railings fence, green railing, artistic doors, anti-theft, sewage wells, hoods,箅子, flexible pipe fittings and other products, can also be synchronized in accordance with the requirements of the customers design, drawings and samples custom processing.

连云港光明铸业有限公司，是集研制、开发、生产、销售于一体的综合性企业，主要生产高速路防撞护栏、球墨上水管、球墨铸铁管、离心球墨铸铁管、球墨铸铁井盖、铸铁泻水管、铸铁排水管、灰铸铁铸式铸翼式铜铝合金散热器、铸铁围墙栏杆、绿化栏杆、艺术大门、防盗、污水井、盖、箅子、柔性管件等系列产品，还可根据用户需要进行花样设计、来图来样加工定做。

At present, we offer high quality high proportion fishing fall, high proportion alloy ball, high proportion alloy round stick, high proportion alloy unit, high proportion alloy golf head, high proportion alloy off-centered dipole and other high proportion alloy abnormal units. Production capacity: above 200T/year.

按合金组成特性及用途分为W-Ni-Fe、W-Ni-Cu、W-Co、W-WC-Cu、W-Ag等主要系列，其密度高达16 。5-19.0g/cm3，而被世人称为高比重合金，它还具有一系列优异的特性，比重大：一般比重为16.5-18.75g/cm3，，强度高：抗拉强度为700-1000Mpa，吸收射线能力强：其能力比铅高30-40%，导热系数大：为模具钢的5倍；热膨胀系数小：只有铁或钢的1/2-1/3，良好的可导电性能；具有良好的可焊性和加工性。

Moreover, the hot compressive deformation behavior of the RS/PM AZ91 magnesium alloy and AZ91 alloy matrix composite were also investigated, the conclusions are drawn as follows:1. The processing parameters of the atomization-twin rolls quenching technology were optimized as follows: the diameter of the nozzle 1mm, the wheel velocity 25m/s, the pressure of atomization gas 0.3MPa and Ar gas for melt injection 0.1MPa. The RS AZ91 alloy flakes exhibited fine and uniform microstructures. When the flakes were extruded at 673K, extruded velocity of 0.1mm/min and extrusion ratio of 25:1,the magnesium alloy rods with clean surface, uniform dimension and excellent mechanical properties were obtained.2. The RS AZ91 magnesium alloy powders prepared by atomization-twin rolls quenched technology exhibited fine equiaxed grains with the grain size of 1-3μm, the phase constituent included supersaturate solid solution phaseα-Mg and miner fineβ-Mg_(17)Al_(12) phase. The as-extruded materials also exhibited equiaxed grains with the size of 5-7μm and a large number of fineβ-Al_(12)Mg_(17) and fewer AlMg_2Zn phases were detected in the alloy.

本文还研究了快速凝固/粉末冶金AZ91镁合金热压缩变形流变应力行为，快速凝固/粉末冶金法原位生成Mg_2Si增强AZ91镁基复合材料，经过系统的研究，获得如下结论：1、雾化-双辊急冷法在下列工艺参数组合下：双辊线速度25m/s；喷嘴直径1mm；熔体压射压力0.1MPa；雾化气体压力0.3MPa。，可获得宏观尺寸细小、微观组织均匀细小、综合性能优良的的快速凝固AZ91镁合金细碎箔带，快速凝固箔带在挤压温度为673K、挤压速度为0.1mm/min，挤压比为25：1时，可获得的外表光洁、尺寸均匀、组织性能优异的镁合金棒材。2、雾化-双辊急冷法制备的AZ91镁合金粉末态为细小等轴晶组织，晶粒尺寸1-3μm，组织为α-Mg过饱和固溶体和微量的细小β-Mg_(17)Al_(12)相组成；粉末挤压棒材为等轴晶组织，晶粒尺寸5-7μm，组织中含有大量细小的β-Al_(12)Mg_(17)以及AlMg_2Zn析出相，室温力学性能，抗拉强度383MPa，屈服强度275MPa，断后伸长率7.5%。

The results show that Fe0.13[Co20Ni80]0.87 alloy fibers are characterized with thin diameters between 0.3 and 2.0 μm, with high aspect ratio, dense and smooth surfaces. The crystalline size of the alloy fibers are mainly influenced by the thermal reduction temperature and are in the range of 20 to 50 nm with a corresponding reduction temperature range of 300 to 700 ℃. The magnetic properties of the alloy fibers are largely affected by the carbon content and crystalline sizes of the alloy fibers. With increasing thermal reduction temperature, the coercivity decreases while the saturation magnetisation value of the alloy fibers dramatically increases at lower reduction temperatures. The alloy fibers prepared at reduction temperature of 700 ℃ have a saturation magnetisation value of 120 Am2/kg and a coercivity value of 10.4 kA/m, respectively.

结果表明：Fe0.13[Co20Ni80]0.87合金纤维的直径为0.3~2.0 μm，表面光滑、长径比大；组成合金纤维的晶粒大小与还原温度密切相关，当温度为300~700 ℃时，晶粒尺寸由约20 nm增加到约50 nm；该合金纤维显铁磁性，其矫顽力主要受合金中C含量及晶粒大小的影响，随制备温度的升高而降低；饱和磁化强度则主要与合金的组分相关，随还原温度的升高和合金纯度的提高而增大；经700 ℃热还原后，合金纤维的饱和磁化强度 m s为120 Am2/kg，矫顽力 H c为10.4 kA/m。

The results show that the dissolution process of prefabricating alloy can be divided into two periods when the temperature of zinc melt is below the melting point of aluminum.Firstly,zinc melts infiltrates into the prefabricating alloy and then Zn-Al-TiC alloy forms in the surface layer of the prefabricating alloy.Secondly,the Zn-Al-TiC alloy of this alloy surface layer begins to dissolve to the zinc melt.

结果表明：当锌熔体温度低于铝熔点时，预制合金的溶解可分为两个阶段：第一阶段为液态锌向预制合金中浸渗，并在预制合金表层内形成Zn-Al-TiC合金；第二阶段为预制合金表层内的Zn-Al-TiC合金开始溶解并进入锌熔体。

At 1273K, the density of dislocations were considerably decreased in deformed TiAlMnNb alloy, twinning and 11 superdislocations were hardly observed, but few 1/212 superdislocations and 01 perfect dislocations were found in deformed TiAlMnNb alloy. In high temperature range, brittle-to ductile transition had already occurred in deformed TiAlMnNb alloy, unpinning and climbing were the dominant deformation behavior in TiAlMnNb alloy. In the same way as TiAlMnNb alloy, different distinguishing feature the dislocation configuration at low, intermediate and high temperatures emerged in deformed TiAlMnNbB alloy.

在中温区域，合金中位错组态变化可分为两个小区域，在673K以下，合金的位错组态有孪晶、1/210单位位错和少量的11超点阵位错；这一温度区间内孪晶和位错密度都大大提高，不同系统的孪晶相互交割阻碍了孪生的继续发展，不同方向的位错相互交割阻碍位错进一步滑移，同时孪晶界面也阻碍了位错的运动。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48