查询词典 iron alloy

An Al-6Mg-0.4 alloy was prepared by semicontinuous ingot metallurgy method. In order to determine the best thermal process technics, the thermoplastic of Al-6Mg casted alloy was studied. The tensile properties of the casted sample were tested at 250, 300, 350, 400, 450, 475 and 500 ℃, respectively, after homogenizing annealing treatment. The high temperature deformation and fracture behavior of the alloy was investigated by scanning electron microscopy and transmission electron microscopy.

摘 要：采用半连续铸锭冶金法制备一种成分为Al-6Mg-0.4的合金，铸锭样品经均匀化退火后，测试其在250，300，350，400，450，475和500 ℃时的瞬时拉伸力学性能，借助扫描电镜和透射电镜的观察和分析，研究该合金的高温变形及断裂行为。

The results indicate that AZ91D magnesium alloy liquidus temperature is about 595℃ and solidus temperature is about 470℃, so the difference between solid and liquid temperature is l25℃, which implies that AZ91D magnesium alloy belongs to a type of wide crystallization temperature range and low-melting-point alloy.

研究发现，AZ91D镁合金的液相线温度为595℃，固相线温度为470℃，液、固相线温度差为125℃，属于宽结晶温度范围低熔点合金。

Aluminum alloy window; aluminum alloy sliding sash; aluminum; aluminum alloy

不断的研究出高科技新产品，以适宜市场的需求。

In seawater and fresh water, aluminum alloy was not corroded as the all protection of alclad. In salt lake, the alclad on LC4 aluminum alloy remaindered for half a year, and used up for one year. The base of LC4 aluminum alloy was corroded seriously.

在海水和淡水中，包铝层可以对铝合金基材起到完全的保护作用，使基材免遭腐蚀；而在盐湖水中，半年时LC4铝合金表面尚有包铝存在，而一年时LC4铝合金表面包铝已完全消耗至尽，LC4的基体发生严重腐蚀。

The results show that the rare earth element Ce can codeposit with cobalt-base alloy, and with increase of mass added of Ce in solution, the content of Co, Ni, Ce in alloy increases and the content of B decreases. Ce can increase plating rate of alloy in some range of content. The rare earth makes deposition potential mve in positive direction and polarizability decrease.

结果表明，在水溶液中稀土元素Ce可以与钴基合金实现共沉积，且随着镀液中Ce的浓度的增大，合金镀层中Ce、Co和Ni的含量逐渐升高，B含量降低；且Ce在一定范围内能够明显提高合金的沉积速度；稀土还使Co-Ni-B合金的析出电位发生了正移，减小了极化度。

The results show that La can refine the microstructure of Zn-22%Al alloy, slow down the grain growth and reduce the equiaxial degree during ageing, that the strength of Zn-22%Al-alloys and Zn-22%Al alloy remains constant after ageing below the warm-rolling temperature, and that La can improve the strength and the stability of mechanical properties of Zn-22%Al alloy.

结果表明：La具有细化Zn-22%Al合金的组织并阻碍时效时晶粒长大和等轴程度降低的作用；在低于温轧温度(80 ℃)下时效时，加La和不加La的Zn-22%Al合金的室温力学性能保持不变； La可提高Zn-22%Al合金的强度以及时效时力学性能的稳定性。

The catalytic performance of all the amorphous alloy catalysts mentioned above was measured during liquid phase hydrogenation of furfural to furfuryl alcohol, together with the kinetic studies. The relationship between the catalyst performance and the structure of catalyst, surface electronic state of the amorphous alloy has been systematically studied based on a series of characterization of catalysts . Meanwhile, the promoting effects of the support on the thermal stability and catalytic activity of the amorphous alloy catalysts have been discussed.

本文采用一系列的表征方法(XRD、XPS、TEM、BET、氢吸附、TPD等)进一步研究非晶态合金催化剂的表面结构、表面电子态和催化性能之间的关系，探索电子效应和几何效应对催化剂活性中心结构的影响，探索非晶态合金的晶化失活和载体对非晶态结构的稳定化作用，以及修饰剂对催化性能的改善作用等。

The results show that a few cavitations distribute randomly and isolatedly in the gauge length in Mg-8.42Li alloy at 573 K and 1.67×103 s1. The transgranular fracture appears at 573 K and 5×104 s1 in Mg-8.42Li alloy and dimple fracture along grain boundary appears at 573 K and 1.67×103 s1 in Mg-7.83Li alloy.

结果表明：Mg-7.83Li和Mg-8.42Li合金分别获得850%和920%的最大超塑性；Mg-7.83Li合金在573 K时发生了显著的超塑性晶粒长大；在573 K和1.67×103 s1条件下制备的Mg-8.42Li合金中的空洞较少，且在变形区中随机而孤立地分布。

Combined with the observation of the metallograph and analysis of the change of chemical composition of alloys,we can draw the following conclusion:the addition of within the range of 40% once-used cobalt-chromium alloy to casting cobalt-chromium alloy wouldn't affect the quality of restorations,excessive addition of once-used alloy would damaged the microstructure and physical properties.

摘 要：通过比较不同比例的新旧钴铬合金铸造后的抗拉强度、屈服强度、延伸率、硬度等机械性能指标，并结合相应的金相观察及化学成份分析，得出结论：铸造钴铬合金中可加入不超过40％的仅铸造过一次的旧料而不影响合金的主要机械性能，超过这一比例，将影响修复体的质量。

Monel alloy, copper-chromium alloy additives can also be other alloy materials processing .

蒙乃尔合金，铜铬合金添加剂等，也可以来料加工其他合金材料。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48