查询词典 ionization voltage

The capillary temperature and ionization voltage were maintained at 230℃ and 2.5 kV, respectively.

毛细管温度和电离电压保持在230℃和250千伏，分别。

In this article,with the voltage between the probes of a spark plug,ionization currents with different knock intensities of the engine are measured successfully in the experiments on a DA462-A four-cylinder gasoline engine.According to the character of the ionization current four indexes are chosen to analysis the obtained data.It is clear that the resultants by the calculation of ionic current are different with different knock intensities of the engine.

通过在火花塞电极两端加偏置电压的方法，在DA462-A型4缸汽油机的台架试验中，成功地检测出汽油机在不同爆震强度时的离子电流信号，并根据离子电流信号的特征选用了4种爆震强度评价指标，经分析计算表明各工况爆震强度的合理递进顺序。

With this data, we can calculate the resistance, conductivity, ionization voltage and discharge current parameters. This may help us to comprehend more about the electric discharge phenomena.

经由此研究，不但可得碳棒电极间距大小与电压之关系为非直线性，进而获得控制维持电弧持续放电之距离，可应用於金银等电极间或以水等介质作放电的研究。

Gas identity and concentration can be determined by monitoring the ionization voltage and discharge current of the gas. Gas ionization voltages of SWNTs were lower 30 voltages than MWNTs obtained by CVD, and after plasma treatment, the gas ionization characteristics of MWNTs were improved.

与化学气相沉积方法得到的直立式多壁碳纳米管相比较，旋涂法单壁碳纳米管薄膜电极的气体电离阈值电压要低30V左右，等离子处理对改善直立式多壁碳纳米管的气体放电性能有帮助。

The MS was equipped with an ESI interface operating at an ionization voltage of +5500 V and a source temperature of 400 8C.

该MS是配备了电喷雾接口经营处于电离电压为5500 V和A 源温度400 8C条。

There is a conductive brushlelss use of molecular electrostatic voltage air ionization, this high voltage electrostatic high General produced from fast-moving under the pressure of implantated, as in a fast-moving of squeege inverterbral, Polyester mesh surface there static electricity voltage.

有一种导电刷利用已有的静电电压使空气分子电离，这种高静电电压一般产生于在高压力下快速移动的材料表面，如在高速运动的刮板压力下，聚酯丝网表面就会存在静电电压。

Crystallinities and tribological characteristic are presented. The results show that the properties of PECVD TiN coating are affected by the gas composition inletting chamber,deposition temperature and ionization voltage.

结果表明，当N/H比为1、Ti/N比为21、沉积温度为400℃和离化电压为1500V时，镀层具有较好的机械性能及耐磨性能。X—射线衍射分析表明，在本试验条件下所获镀层均为(200)面择优取向。

The triple quadrupole mass spectrometer with the turbo ion spray interface was operated in the positive ion mode and the temperature of the turbo was set at 105℃ and the ionization voltage was 3300V. The multireaction monitoring mode was employed to scan the ions.

三重四极杆质谱采用正离子模式，离子采集方式为多反应监测模式，离子源温度105℃，离子源电离电压为3300V，雾化气流速500L/h。

Hydrocarbon structural-group components in the hydrotreating of residual oils The residual oils were preseparated into 4 fractions by alumina/silica serial column A method for measuring the hydrocarbon structural-group components in saturated fraction, aromatic fraction, and resin fraction of residual oils was established using low resolution, high ionization voltage mass spectroscopy.

渣油加氢处理过程烃类结构族组成变化研究采用氧化铝/硅胶串联柱对渣油样品进行四组分预分离，建立了低分辨、高离子化电压质谱测定渣油饱和烃、芳烃和胶质组分烃类结构族组成的方法。

MS parameter: ion source: ESI; 50～800 m/z; ionization voltage: 3.0 kV; dry gas (N2) flow rate: 318 L/h; temp:150 ℃; emale cone voltage: 3.0 kV.

质谱条件：离子源：ESI；检出模式：正负离子二种形式；扫描范围：50～800m/z；电离电压：3.0kV；电喷雾接口干燥气(N2)流速318L/h；离子源温度150℃；锥孔电压30V。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。