查询词典 inverter

This paper analyzes the characteristic of the Power Factor Correction of arc welding inverter power source , introduces the 12-pulse converter based on delta-type autotransformer connection into arc welding inverter power source ,and its configuration, design scheme and theory on PFC.

分析了弧焊逆变电源功率因数校正技术的特点，阐述了弧焊逆变电源中基于差接三角形自耦变压器十二脉波整流电路的原理与设计及其功率因数校正机理。

On the basis of researching basic principle of grid-connected inverter, grid-connected inverter was designed based on deadbeat control.

在研究并网逆变器基本原理的基础上，设计了基于无差拍控制的并网逆变器。

The module integrates dual insulated driving and special protection circuits. It has high push-pull driving capability, bootstrap power supply technology and is easy for miniature design of inverter. The paper also introduces the application in portable diesel engine generator inverter and discusses some attention items in practical application.

该驱动模块内部集成两路独立驱动和独特的故障"局域网"保护电路，驱动能力强，体积对装小，易于逆变器的小型化设计，并介绍了该驱动模块在便携式柴油发电机逆变电源中的应用，讨论了设计中应注意的问题。

By the means of theory, simulation and experiment, the second part of this paper is then analyzed which is on the equivalent output resistance and inductance of the selected inverter and the effect to the output voltage"s amplitude and phase caused by the different values of the inverter"s component. It is concluded that by selecting certain precision level components, the difference of the output voltage amplitude is much greater than that of the output voltage phase.

其次通过理论、仿真和实验分析了本文所采用的电压电流双闭环瞬时控制方式逆变器的等效输出阻抗和两台逆变器器件差异对输出电压的幅值差和相位差的影响，从而得出选用一定精度的器件，两台逆变器输出电压的幅值差比相位差大得多的结论。

Next, the finite element model of induction motor is established by using Maxwell 2D transient module, and the inverter control circuit is also designed by its own circuit design editor. Consequently, a complete field-circuit coupled simulation model of inverter control system is presented.

接下来，利用Ansoft公司的Maxwell 2D瞬态模块建立了异步电动机的有限元模型，并且采用其自带的电路编辑器Schematic Capture设计了异步电机逆变器控制电路，构建了一个完整的变频控制系统场路耦合仿真模型。

Three-phase bridge incontrollable full-wave rectifier circuits and the inverter circuit constitute the main circuit of AC-DC-A voltage source inverter system.

该方法通过判断输出电压矢量的角度来获取三相电流的方向，避免了电流检测中多个零点的现象。

A new universal hybrid topology is brought forward. Two types multilevel inverter: equal DC voltage and DC voltage in geometric proportion is studied, besides this, simulation and experiments on SVPWM applied on cascaded H-bridge inverter is also studied.

提出了多电平逆变器的一种通用组合拓扑结构，针对这种拓扑结构重点，研究了直流侧电压相同及等比变化的两类级联拓扑以及级联H桥逆变器的矢量控制方法；并对级联H桥逆变器的矢量控制方法做了实验研究。

The instantaneous voltage PID control inverter has advantage on circuit and cost, compared with voltage current dual-loop control inverter.

逆变器瞬时电压PID控制与电压电流双环控制相比，在电路结构、成本等方面更具优越性。

A.The inverter part is made of MOSFET single-phase inverter bridges connected in CFI. The power of single-phase bridge is 60kW; the inverter bridge adopts the building block method to realize power superposition. Every piece of bridge plate is designed in the shape of a drawer, which is very easy to install and repair

逆变部分由 MOSFET 单相逆变桥并联组成，单桥功率设计为 60kW ，逆变桥采用积木式方式完成功率叠加，每块桥板均设计为由滑道组成的抽屉式结构，方便安装与维修

A simulation research is conducted on the example of six-phase double star winding shifted by 30°synchronous motor.In order to investigate the control algorithm of multilevel inverter , high harmonics as well as its problems, a mathematical model of the control algorithm based on the voltage space vector is built. For the first time, the principle along boundary is introduced to confirm the chosen switch state when many switch states are corresponding to the same vector. Simulation analysis and hardware realization are conducted with the combination of diode clamped three-level inverter and five-level inverter.

建立了基于空间电压矢量控制算法的仿真模型；仿真研究中采用对偶小矢量搭配改善中点电位波动的问题；针对多个开关状态对应同一待选矢量的问题引入&循边原则&确定被选择的开关状态；对过调制问题进行了相应的处理：结合二极管嵌位式三电平逆变器和五电平逆变器进行了仿真分析和硬件实现。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。