查询词典 intersection multiplicity

Mark a point on the steering wheel cover that is longitudinally and transversely, as measured along the surface of the steering wheel cover, within ±6 mm (±0.2 in) of the point that is defined by the intersection of the steering wheel cover and a line between the volumetric center of the smallest volume that can encompass the folded undeployed air bag and the volumetric center of the static fully inflated air bag.

S26.2.2 在方向盘面上划一点作记号，这个点是在沿方向盘的表面测量而确定的。这个点的位置由方向盘表面和能装下未充气折叠气囊最小空间的中心与静止状态下充分冲气气囊的空间中心之间的一条线所交叉的那个点来确定。前面的那个记号点在这个交叉点的纵横±6 mm (±0.2 in)处。

A little train, with some ancient flavor, when going through the intersection of roads, would sound its steam whistle in the manner of an extremely majestic-looking.

有一种小火车，带点复古的味道，经过路口的时候，会威风凛凛地拉响汽笛。

A sufficient condition is presented for the existence of square integrable and joint continuity of its self-intersection local time.

给出了其自相交局部时平方可积和联合连续的一个充分条件，并通过对广义α-stable过程自相交局部时的H？

The centre is located in Ho Chi Minh City, the new international airport and the commercial centre of the intersection of broad areas, convenient transportation, advanced facilities, the total area of 12,000 square meters, all use of international standards of design, the Library has over 07,000 square meters exhibition hall, This hall by three separate exhibition hall and then from each area of the Office of 02,400 square meters, can be divided into 50 - more than 100 square meters, ranging from joint regional exhibition.

该中心地处胡志明市新的国际机场与商业中心交汇的宽阔地段，交通便捷，设施先进，总面积达1.2万平方米，全部采用国际标准式设计，馆内拥有超过 0.7万平方米展览大厅，此大厅由三个单独展厅并接而成，每个厅面积为0.24 万平方米，可划分出50——100平方米不等的多个联合展览区域。

The advanced method is to use a new type of bearings are embedded in the seal groove, the groove depth than the standard bearings are slightly A42C Type Pound-Grade Low Lift Spring Loaded Safety Valve shallow point, and just fit in the intersection part, fill in the gap left by the outer ring flange.

该先进方法是用一新型有凹槽的密封圈嵌入轴承中，该凹槽深度要比标准轴承的稍浅点，且恰好适配于相交部分，填入外圈凸缘留下的间隙。

The paper discusses the position relationship between the litter circles of torus and the section circle of sphere figured out the intersection of torus and sphere when the central axis of torus and sphere center in XOZ coordinate plane through coordinate transformation.

利用坐标变换使圆环中心轴与球心同在XOZ平面内，讨论了在该平面内圆环截圆与球圆的位置不相交、相切和相交时圆环面和球面的相交情况，并给出了判别圆环面、球面相交情况的流程图以及圆环面和球面相交实例。

If the Point/Snap button in the Status Bar is set to Snap, the left mouse button will snap to the closest point (either an end point or a line intersection) when clicked in the Design Document Window.

如果在状态栏上的 Point/Snap 点击/捕捉按钮被设置为捕捉模式，当在文档设计窗口中单击时，鼠标左键将捕捉最近点。

This paper describes a PLC system used for the traffic signal lamp for a forced pass of emergency vehicle at intersection.

介绍PLC在十字路口交通信号灯急车强通控制中的应用。

Thirdly, it analyzes and studies in detail Surpac mechanism and the relevant concepts on constructing the model of mineral deposits and mining engineering systems according to the modeling procedure and the actual conditions of Jinchuan"s mines. Based on these:Lit points out some differences between the western countries and China in the practice of the geological data record, explores the inputting data on computers performed by more people at the same time and the method to improve constructing the data-base and finished the data-base of Jinchuan mineral deposits;2.It puts forward the steps and flow chart to construct the solid model and brings forward the scheme of "first individual then whole to set up Jinchuan mineral deposits geological model, summarizes some experiences for constructing the complicated geological ore body of the high accuracy: add control lines, add auxiliary demarcation lines +control lines, the operation of intersection, cross and incorporation between solid bodies and plane and section combination. The above-mentioned methods applied to construct the mineral deposits solid models of four mine areas in Jinchuan; 3.lt studies and presents the detailed flow chart of constructing block and grade model, analyses the workable scheme in setting up the block and grade model of main ore body for Jinchuan mineral deposits and also sets it up.

接着，按建模流程并结合公司矿山实情，详细研究、分析了Surpac构造矿床模型和采矿工程系统模型的机理、有关概念，在此基础上：(1)指出了西方国家与我国在地质数据记录习惯方面存在的一些差异，探索出多人多机同时录入、提高建库效率的方法，建立了金川矿床地质数据库；(2)研究并提出了构造实体模型的步骤和流程图及&先分后整&建立金川矿床地质体实体模型方案，总结出建立高精度复杂地质体模型几点经验：添加控制线法、添加辅助分界线+控制线法、实体间的交、叉、并运算法及平剖面图联合法，建立了金川矿床四个矿区主矿体的实体模型；(3)研究并提出了建立块模型、品位模型详细流程图，分析了建立金川矿床主矿体块模型和品位模型的可行方案，建立了金川矿床主矿体的块模型和品位模型。

Intersection, a common model of self-locating of GeoIMS was introduced.

论文首先介绍了传统的系统自定位模型--前方交会。

You can snipe the second and third union leaders from this position.

您可以鹬第二和第三工会领袖从这一立场出发。

Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.

针对当前XML数据流质量检测存在的不足，提出构建XML键的矢量矩阵作为窗口，利用矢量积小波变换多级分解与重构XML数据流，再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法，满足XML数据流质量重构时实时检测的要求，保证XML数据的约束性、一致性与完整性；为了更好的适应网络负载，采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。