查询词典 internal force

The internal force yield condition is a close and convex curve and can correspond to the symmetry of internal force.

该内力屈服条件是一条闭合的外凸曲线，符合内力分量的对称性，在材料拉压强度相同时蜕化为屈雷斯卡内力屈服条件。

And this paper assumes that resisting power is accordwith parabola, gets all arch as basic configuration, gets formulation from the condition that therelative corner , horizontal displacement and vertical displacement of vault section iszero,adds deformation condition of maximum resisting power and zero resisting power, solvesequation group to get the internal force of lining . And lining internal force computing methodunder bias load based on assumed resisting power method is formulized.

本文假定弹性抗力按二次抛物线分布，取全拱为基本结构，由拱顶截面的相对转角、相对水平位移和相对垂直位移为零的条件列出变形协调方程，再增加最大弹性抗力处的变形协调条件和弹性抗力为零处径向位移为零的变形协调条件，解方程组求解得出衬砌结构的弹性抗力分布及内力。

The handworker counting consists of several aspects, included preliminary selection of member size, counting model of frame, loads counting, lateral displacement counting of transverse frame, internal force analysis of horizontal loads and vertical loads, internal force combinations, design of section, check design of the foundation.

其中手算部分计算书的主要内容为构件尺寸的初步确定、框架的计算简图、荷载横向侧移计算、框架在水平及坚向荷载作用的内力分析和计算、内力组合、截面设计及基础设计。

By the computation of program, data which concerned in engineering such as deflection of raft foundation, internal force of raft foundation, internal force of superstructure (Which include beam, columns and shear-wall) and the other useful data for structure design can be obtained. And this can provide guidance and advice for the relative engineering practice.

通过程序计算可以得出工程上关心的考虑与上部结构、地基共同作用的筏板基础的挠度、筏板基础内力、上部结构(包括上部各层梁、柱、剪力墙)内力等结构设计所需的指标，可为相关的具体工程实践提供指导及依据。

The results of lattice beam internal force calculated method based on double parameter groundsill model are more approach the experiment measured values because of consideration of the pass of shearing force in soil, and its calculated workloads are similar with the method of winkler elastic foundation. Besides, the thesis also discusses the moment of torque affected results on node stress situation and the correction of stress value at the bottom of cross node of lattice beam. Due to the repeat calculation of node area during internal force calculation, the stress value of the bottom of beam is lower, this may lead the calculated value unsafe, but the corrected stress value will more approach to practical situation.

对格构梁的内力计算提出基于双参数地基模型的格构梁内力计算方法，其计算结果表明，双参数地基模型上的格构梁内力由于考虑土中剪力的传递更加接近于试验实测值，其计算工作量与winkler弹性地基梁法相当，此外，文中还探讨了扭矩作用对格构梁节点受力情况的影响结果以及格构梁交叉节点底部的应力值的修正，由于内力计算过程中节点处的面积被重复计算，使得梁底应力偏小，可能导致计算结果的偏于不安全，修正后的应力值更接近于实际情况。

Base on summarizing the development state of assembly skew hollow slab bridge, the research content of this dissertation has been determined. Taking Tuan Shan River Bridge, in Hubei province, China, as an example, the finite element method of space slab shell programmed in Ansys Parameter Design Language is adopted to analyze the elastic properties. By calculating the internal force influence surface of assembly skew hollow slab bridge, the internal force-controlling section is attained.

本文在对装配式斜交空心板桥的发展现状进行了详尽的综述后，确定了本文的研究内容，以团山河大桥为工程背景，采用ANSYS提供的参数化语言APDL，用空间板壳有限元法，对装配式斜交空心板桥弹性阶段的受力特性进行全面分析，计算了装配式斜交空心板桥的内力影响面，得到内力控制截面。

The loading program, by which the load can be directly applied to the internal force influence surface, is generated and used to get the result of loading on the influence surface. Through comparing the result of loading on the internal force influence surface of assembly skew hollow slab bridge with the one of the perpendicular bridge, the reduction factor method is offered and its corresponding reduction factor can be obtained.

编制了内力影响面加载程序实现对内力影响面的直接加载；在此基础上，通过参数分析，对比装配式正交空心板桥和斜交空心板桥内力影响面加载的结果，提出斜交空心板桥设计计算的折减系数法，并给出相应的折减系数。

Based on it, the research content of this dissertation has been determined. Tuan Shan River Bridge is selected as an example and APDL is used to analyze the elastic properties. After calculating the internal force influence surface of assembly skew hollow slab bridge, the internal force-controlling section is attained; the transverse distribution of internal force is studied and the transverse distribution coefficient is parametric analyzed. Based on the results, relation formula of transverse distribution coefficient between skew and perpendicular bridges are fitted. Practical calculation method for the internal force calculation of assembly skew hollow slab bridge is offered. Some conclusions are drawn from comparing and analysing the internal force, bearing reaction and deformation of both assembly and monolithic skew slab bridges.

本文对装配式斜交空心板桥的发展现状进行了综述，从此出发，确定了本文的研究内容，以团山河大桥为工程背景，采用ANSYS 提供的参数化语言APDL，对装配式斜交空心板桥弹性特性进行全面分析，计算了装配式斜交空心板桥的内力影响面，得到内力控制截面；同时计算了内力的横向分布影响线和横向分布系数，并对内力横向分布系数进行了参数分析；基于参数分析的结果，拟合了装配式斜交空心板桥与对应正交桥内力横向分布系数的关系式，为装配式斜交空心板桥的内力计算提供了实用计算方法；对比分析了装配式斜板桥与整体式斜板桥的内力、支座反力以及变形特点，得出了一些有益结论。

In order to take the influence of the internal force from translation into consideration, the design of in-plane buckling of unbraced frame s adopted a new second-order elastic method to calculate the structural internal force, e.

为考虑变形对内力的影响，对无支撑框架的平面内稳定计算提出采用假想水平荷载法进行二阶弹性内力分析，以与国际上钢结构设计相接轨。

Thereinto, exterior drive mostly arises from the change of competition mode and custom demand, and inside drive includes up-and-up internal force, culture internal force and desire internal force, and the black hole which result from enterprises plough vast capital into information technology compel enterprises to reengineer its business process.

其中，外部动力主要是由于竞争方式与顾客需求模式的变化所引起的，而内部动力则包括企业内部的趋好内力、文化内力以及欲望内力以及企业对于信息技术的巨额投入所引起的&黑洞&迫使企业实施再造。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。