查询词典 interlamellar
- 与 interlamellar 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
FT-IR spectra shows that the polyaniline is present primarily in the emeraldine salt form, and the polymeric chains interact with inorganic framework, most likely via V=O…HN hydrogen bonding. XRD,TG and DSC indicate that the lamellar structure of the V_2O_5 is preserved, PAn chains eliminate water form the interlamellar region and are partially inserted between the layers, and exist with extended-chain conformation owing to the confined environment.Electrochemical investigation in the range of 1.8~3.8V vs.
红外光谱表明复合物中PAn主要以导电聚苯胺盐的形式存在,PAn链与V_2O_5晶格之间可能形成了V=O…HN氢键。X射线衍射、热重和差示扫描量热证实了PAn/V_2O_5复合物保持了较规整的层间排列结构,PAn取代了V_2O_5干凝胶中的层间水而部分嵌入其片层间,由于受空间的限制,PAn分子链以比较伸展的链构象存在。
-
The interlamellar shear stress between the middle two layers was lower than that between the inner and outer two layers respectively.
在主动脉各部位,中间两层间的剪应力均分别显著低于内侧和外侧两层间剪应力。
-
The results indicate that interlamellar structure of montmorillonites, amount of surface acidity and its decoloring performance show significant dependence on methods and conditions used.
结果表明,制备方法、条件等对蒙脱石层间结构、表面酸量及表面吸附性等均有较大的影响,且交联蒙脱石在400℃以下热稳定性较好。
-
Many research works have shown that the microstructural control of TiAl alloys have an important influence on their mechanical properties, and also found that the grain size, the interlamellar spacing and the α〓/γ volume fraction of the microstructural features are the key factors of microstructural control.
已有的研究确定了TiAl合金的显微组织控制对其力学性能有着重大的影响,提出了TiAl合金的显微组织中晶粒大小,片层间距和α〓/γ相比例等是组织控制的主要因素。
-
The results show that with the finishing temperature at 950 ℃, as the cooling rate increases, interlamellar spacings of pearlite is reduced; as cooling rate reaches 5℃/s, martensite precipitates.
结果表明,随着冷却速度的加快,高碳钢SWRH77B在950℃变形时,其珠光体的片层间距变细;冷却速度达到5℃/s时,有马氏体组织析出。
-
Through the comparison of this model with Miller and Smith's shear cracking model, it can be shown that the smaller the interlamellar spacing of pearlite is, the higher the resistance of crack initiation and propagation will be.
该模型与Miller和Smith提出的剪切开裂模型的比较可以说明,珠光体片层间距越细小,裂纹萌生和扩展的阻力越大。
-
The stability of lamellae decreases with decreasing interlamellar spacing and discontinuous coarsening occurres during aging.
层状组织的稳定性随片间距减小而降低,表现为时效时发生不连续粗化。
-
Based on the non-classic theory of plasticity, the elastic and plastic constitutive relationship is established for peaelitic colony with finer interlamellar spacing, and the corresponding numerical method is also developed.
基于非经典塑性理论,建立了珠光体团的弹塑性本构方程,发展了相应的数值计算方法。
-
The test results show that the contact fatigued microstructure characters mainly the reduction of pearlitic interlamellar spacing, the formation of different type of substructures as well as the deformation and fracture of cementitic lamellar in pearlite.
结果表明,PD3钢轨钢接触疲劳变形组织的主要特征是:珠光体片层间距的减小;不同类型亚结构的形成;渗碳体的变形与断裂。
-
The adhesion wear of the coatings is somewhat different from the sintered or cast materials, which could be explained in terms of interlamellar cracking and flaking off of lamellae.
涂层的粘着磨损显示出不同于块体材料的粘着磨损的特点,表现为粘着力引起涂层层间裂纹扩展和层状颗粒剥离。
- 推荐网络例句
-
The split between the two groups can hardly be papered over.
这两个团体间的分歧难以掩饰。
-
This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.
这种做法不仅鼓励了更多的反应,而且减少跟风的可能性。
-
The new PS20 solar power tower collected sunlight through mirrors known as "heliostats" to produce steam that is converted into electricity by a turbine in Sanlucar la Mayor, Spain, Wednesday.
聚光:照片上是建在西班牙桑路卡拉马尤城的一座新型PS20塔式太阳能电站。被称为&日光反射装置&的镜子将太阳光反射到主塔,然后用聚集的热量产生蒸汽进而通过涡轮机转化为电力