查询词典 interface bus

The AHB bus interface design consists of master module interface design and slave module interface design.

AHB总线接口设计划分为主控模块接口设计及从模块接口设计。

Bus control bus interface as a result of the failure was with the bus control module failure or malfunction caused by other bus master.

总线控制权故障是由于总线接口配备的总线控制模块故障或其他总线主控器故障引起。

C Supports both Firmware Hub and LPC Memory Read and Write Cycles Auto-detection of FWH and LPC Memory Cycles C Can Be Used as FWH for Intel 8xx, E7xxx, and E8xxx Series Chipsets C Can Be Used as LPC Flash for Non-Intel Chipsets Flexible, Optimized Sectoring for BIOS Applications C 16-Kbyte Top Boot Sector, Two 8-Kbyte Sectors, One 32-Kbyte Sector, Three 64-Kbyte Sectors C Or Memory Array Can Be Divided Into Four Uniform 64-Kbyte Sectors for Erasing Two Configurable Interfaces C FWH/LPC Interface for In-System Operation C Address/Address Multiplexed Interface for Programming during Manufacturing FWH/LPC Interface C Operates with the 33 MHz PCI Bus Clock C 5-signal Communication Interface Supporting Byte Reads and Writes C Two Hardware Write Protect Pins: TBL for Top Boot Sector and WP for All Other Sectors C Five General-purpose Input Pins for System Design Flexibility C Identification Pins for Multiple Device Selection C Sector Locking Registers for Individual Sector Read and Write Protection A/A Mux Interface C 11-pin Multiplexed Address and 8-pin Data Interface C Facilitates Fast In-System or Out-of-System Programming Single Voltage Operation C 3.0V to 3.6V Supply Voltage for Read and Write Operations Industry-Standard Package Options C 32-lead PLCC C 40-lead TSOP

0第0页，本页显示记录0-0，共0条记录分0页显示C支持两种固件中心和LPC内存读取和写入周期自动的FWH和LPC的记忆圈C检测可以用于英特尔8xx系列，E7xxx，E8xxx系列芯片组和C可以用作FWH与至于非英特尔芯片组的BIOS应用柔性优化扇区开放16字节热门引导扇区，两个8 - Kbyte的，一个32字节部门，3个64 - Kbyte的C或存储阵列，线性预测编码闪光可分为四个统一为两个可配置的接口擦除的FWH / LPC接口为64 - Kbyte的行业，系统运行C地址/地址多路复用在制造过程中用于编程接口的FWH /线性预测编码界面C与33 MHz的PCI总线时钟 5信号通信接口进行操作，支持字节读取和写入引导扇区的顶部和WP C两硬件写保护引脚：任务型为所有其他部门 5个通用输入的系统设计的灵活性识别的多种设备选型部门登记销锁定为个别部门读取和写保护的A /阿复用界面C 11引脚复用引脚地址和8引脚的数据界面C促进快速系统内或外的系统编程的单电压3.0V至3.6V的操作供应的读取和写入操作业界标准的封装选项电压 32 -引脚PLCC 40引脚的TSOP

A low power AMBA bus system is implemented. In order to separate the core logic from bus interface, a new local bus is defined.

完成了低功耗的AMBA总线系统的设计，并在总线接口和核心逻辑分离的指导原则下，定义了一种新的局部总线。

All these problems still need to be solved. So, towards the IP Core interface compatibility of SoC Bus standard, this thesis, based on analyzing the interconnection of IP Cores, researches the software capsulation of IP Core Bus interface layer, and implements the IP Core interface layer of embedded system developing platform which is based on layers. In this thesis; the design method, flow, and environment of SoC based on IP demultiplexing is explained. While in order to improve the integration of IP Core on SoC, interconnection rules of IP Core and its standardization are researched.

鉴于此，本文在对IP核互连进行分析的基础上，针对SoC总线标准的IP核接口的兼容问题，研究和设计了IP核总线接口层的软件封装，并将其作为课题组提出的基于层次的嵌入式系统开发平台的IP核接口层予以实现，使上层开发人员可以根据此规范快速开发出基于该开发平台的IP核，也使得遵循该接口规范的IP核在无需了解具体SoC互连信息的前提下即可实现核内传输机制，从而提高了SoC设计的可复用性。

Control and management system of facilities for smart home ;2. In allusion to lacking of a universal standard criterion and interface protocol on domestic smart home network , CEBus, home bus protocol, the design for home gateway and bus interface criterion are mainly discussed.

针对国内智能家庭网络缺乏统一的标准规范和接口协议，重点论述了消费总线、家庭总线协议，以及家庭网关的设计和总线接口标准，提出了家庭网络由高速信息子网和低速控制子网组成，控制子网提供的服务和应用在智能住宅中最具实用价值，也是智能住宅设计中的难点所在。

In the article, it briefly analyzes the necessity of monitoring the hydric parameters and the development status of monitoring system about the electronic power, then a real-time monitoring system for generator hydric parameters is presented, which applies the configuration software MCGS, radio-communication SMS, Modbus protocol and RS-485 bus .in the design of the system, MCGS is used to configurate the interface of superordinate computer and the device component of the wireless communication is authorized by Visual Basic; the transmitting and receiving flow through GSM(Global System for Mobile communication)in the way of SMS. The design of the smart communication module, which based on the RS-485 bus and Modbus protocol and the wireless communication interface module, which is connected with the wireless terminal based on Siemens TC35, are also expounded.

该方案利用MCGS组态软件进行上位机监控界面的组态；利用Visual Basic语言进行上位机无线通信设备构件的编制；并利用SMS通过全球移动通信系统GSM(Global System for Mobile Communication)网络实现报警等数据的无线传输；以Flash型超低功耗16位单片机MSP430F149作为通用通信模块控制器核心，开发出了基于RS-485总线模式和Modbus通信协议的远程数据采集模块，以及基于Siemens TC35的无线终端相连的无线通信接口模块。

At first, this paper introduces the receiving and transmitting mechanism about the ARINC629 data based on the ARINC629 protocol. With the computer interface technology, it gives the whole design of the communication card which is divied into three modules, such as the PCI bus interface module, the subsytem processer and memory module and the ARINC629 bus interface module.

论文首先根据ARINC629总线协议规范，明确了ARINC629总线协议的数据发送和接收机制，并结合当今计算机接口技术，确定了数据通信卡的总体方案，将数据通信卡划分为三个模块进行设计，即PCI总线接口模块，通信卡子系统处理器和存储器模块以及通信卡与ARINC629总线接口模块。

According to the calibration information, Research and development status of automotive bus network and automotive calibration system is studied and the research significance is generalized. First of all, the collectivity precept for calibration system is designed, the calibration platform is set up based on the XCP Protocol and the calibration object is CAN bus network simulation ECUs. Then how to create the calibration system based on Ethernet and Series communication is expatiated, the communication way from computer to ECUs is introduced and the calibration system is tested. Then how to create the calibration system based on CAN bus communication is expatiated, the design and the interface programme are introduced and the calibration system is tested. At last the platform is used to calibrate the CAN bus network simulation system to regulate the simulation system's topology and communication speed to test the communication protocol's feasibility.

论文首先设计了标定系统的总体方案，以CAN总线实时仿真系统中的节点标定为研究对象，采用XCP协议建立具有串口、以太网和CAN总线三种通讯接口的标定平台；然后，具体开发了基于以太网通讯和基于串口通讯的标定系统，完成了上、下位机部分的软件设计，确定了标定系统在两种通讯方式下的数据处理方法，并分别应用两种标定方式标定下位机仿真系统的参数，让下位机仿真系统在规定的通讯协议和拓扑结构下进行仿真，对所设计的标定系统进行了调试；接着，设计了基于CAN总线通讯的标定系统，完成了CCP协议（&XCP on CAN&）的接口程序设计，并通过混合动力汽车一种拓扑结构的通讯仿真对所设计的系统进行了调试；最后，应用开发的标定系统，对混合动力电动汽车网络通讯协议进行了仿真研究，并根据实验结果进行了分析。

Pinout: C High-performance 32-bit RISC Architecture C High-density 16-bit Instruction Set C Leader in MIPS/Watt C Little-endian C Embedded ICE (In-circuit Emulation) 8-, 16- and 32-bit Read and Write Support 256K Bytes of On-chip SRAM C 32-bit Data Bus C Single-clock Cycle Access Fully Programmable External Bus Interface C Maximum External Address Space of 64M Bytes C Up to Eight Chip Selects C Software Programmable 8/16-bit External Data Bus Eight-level Priority, Individually Maskable, Vectored Interrupt Controller C Four External Interrupts, including a High-priority, Low-latency Interrupt Request 32 Programmable I/O Lines Three-channel 16-bit Timer/Counter C Three External Clock Inputs C Two Multi-purpose I/O Pins per Channel Two USARTs C Two Dedicated Peripheral Data Controller Channels per USART Programmable Watchdog Timer Advanced Power-saving Features C CPU and Peripheral Can be Deactivated Individually Fully Static Operation: C 0 Hz to 75 MHz Internal Frequency Range at VDDCORE = 1.8V, 85C 2.7V to 3.6V I/O Operating Range 1.65V to 1.95V Core Operating Range -40C to +85C Temperature Range Available in 100-lead TQFP Package

M5L8253P-5引脚说明： C型高性能32位RISC架构C高密度以MIPS /瓦C小端C十六位指令集C领袖嵌入式冰8 - 16 -位和32位的读写支持256K的片上SRAM的 32位数据总线C单时钟周期存取字节完全可编程的外部总线接口C最大的外部地址空间的64M字节多达8个C芯片选择C软件可编程8位外部数据总线8级优先级，独立可屏蔽，向量中断控制器C四外部中断，其中包括一个高优先级，低延迟中断要求32个可编程I / O口线三通道16位定时器/计数器C三个外部时钟输入C两多用途I / O引脚每通道2个通用同步C两专用外设数据控制器通道每个USART可编程看门狗定时器先进的节能特性 CPU和外设可停用独立全静态工作中：C 0 Hz至75 MHz的频率范围内的VDDCORE = 1.8，85℃2.7V到3.6VI / O的操作1.65V到1.95V范围核心工作电压范围在- 40C至+85 C温度范围内使用的100引脚TQFP封装

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。