查询词典 integrated circuit

In Chapter 4, on the basis of the selected CPU chips, the hardware frame of the embroidery machine control system is determined according to the overall framework. The power circuit, reset circuit, memory interface circuit, keyboard and display circuit, USB interface circuit, serial communication interface circuit and nether electromechanical interface circuit are designed in particular.

第四章根据总体架构，在选好的CPU芯片的基础上确定了绣花机控制系统的硬件框架，详细设计了电源电路、复位电路、存储器接口电路、键盘与显示电路、USB接口电路、串行通信接口电路和下层机电接口电路。

The hardware system mainly includes the Hall probe circuit, magnetic-flux meter circuit, extension measurement circuit, data capture circuit, the parameters storage circuit, display and keyboard circuit, serial communication controller circuit etc.

硬件系统主要包括磁场测量、磁通表、伸缩量输入、数据采集、参数存储、显示和键盘电路、通讯接口电路等。

In the course of developing the hardware system, the circuits diagram is finished by the mean of EDA software. On the basis of analyzing function of hardware circuit, choose the AT89C51 as single chip microprocessor. Filter and amplifier circuit, sample and hold circuit, Analog-to-Digital conversion circuit, watchdog circuit, out port control circuit and power supply circuit were designed.

在硬件系统研制过程中，应用EDA软件完成电路原理图的设计，分析了硬件系统的各个组成部分及其功能，选用ATMEL公司的AT89C51单片机作为微处理器，设计了滤波放大电路、采样／保持电路、A／D转换电路、看门狗电路、输出控制电路以及电源电路。

The design of accelerometer/angulometer is based on MSP430FW425 microcontroller and ADXL202 accelerate sensor. Protel DXP is used in circuit design, which completes the schematic and PCB design of modules including the clock circuit, the filtering circuit, the power supply circuit, the communication circuit between MSP430 and PC, ADXL202 collecting signal circuit and LCD display circuit.

硬件部分采用Protel DXP开发平台完成了系统的时钟电路、滤波电路、电源电路、MSP430 与PC机之间通信电路、ADXL202传感器电路、LCD显示电路等的电路原理图和PCB板图设计，完成了硬件实物制作。

First, it analyses all-around design of the electronic computer-based interlocking system and each module, then from introducing CAN bus, it lucubrates design of the censorial module's software and hardware which is based on CAN bus of signal lamp's stimulant state, then the hardware's circuit of the entire system's censorial module is made up of opsonic circuit, collecting circuit, microcontrolled circuit,circuit of communication, interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍CAN总线技术，着重研究了基于CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

First, it analyses all-around design of the electronic computer-based interlocking system and each module, then from introducing CAN bus, it lucubrates design of the censorial module%26rsquo;s software and hardware which is based on CAN bus of signal lamp%26rsquo;s stimulant state, then the hardware%26rsquo;s circuit of the entire system%26rsquo;s censorial module is made up of opsonic circuit, collecting circuit, microcontrolled circuit,circuit of communication, interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍CAN总线技术，着重研究了基于CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

After this text introduced and will imitate the audio frequency signal processing as numerical signal after red shoot outside, the numerical signal that will receive again solution adjust after the audio frequency power enlarger enlarge restore in order to imitate the speech signal, shot the electric circuit outside analyzed to design the audio frequency signal before collecting the electric circuit, signal placed the big electric circuit, frequency to make the electric circuit, red, red circumscribed to accept the electric circuit,, frequency the solution adjusted the electric circuit and audio frequencies to enlarge the electric circuit etc.

本文介绍了将模拟音频信号处理为数字信号后经红外发射，再将接收到的数字信号解调后经音频功率放大器放大后还原为模拟语音信号，在分析设计了音频信号采集电路、信号前置放大电路、频率调制电路、红外发射电路、红外接收电路、、频率解调电路以及音频放大电路等各组成部分。

The cutoff value of E2/E6, used to distinguish the pure episomal form from a mixed form of episomal and integrated HPV16 DNA, was 0.81 in the multiplex real-time PCR test. c） HPV16 existed as episomes in most of the CIN Ⅰ lesions, and 42.9% of them had mixed episomal/integrated HPV16. The integrated form of HPV16 constituted the majority in most of the CIN Ⅱand CIN Ⅲ cases. In squamous cervical carcinomas, the HPV16 was mostly integrated into the host chromosome. d） The rate of HPV16 integration was associated with the degree of cervical lesions and the rate increased with the progression of cervical disease, e） The rate of pure integrated HPV16 in stage Ⅱ and Ⅲ（88%） was higher than that in stage Ⅰ（33.3%）. Conclusions: a） Multiplex real-time PCR is a rapid and sensitive method for detection of the integration state of HPV16 DNA. b） The integration of HPV16 DNA is a very early event in the development of cervical cancer and may act as an activation mechanism for progression from preinvasive to invasive cervical cancer, c） The pure integrated HPV16 in cervical cancer may be a useful prognostic indicator.

HPV—16E2、E6标准曲线相关系数均为1.00，扩增效率均在95％以上：2）确定0，81作为多重实时PCR区分游离型和混合型HPV-16的界值、3）CINⅠ中HPV—16大多以游离方式存在，但仍有整合的发生（42，9％）；CINⅡ和CINⅢ中HPV—16以混合型为主：浸润癌中以整合型HPV—16为主。4）HPV-16整合发生率与不同程度的宫颈病变有关，并且随着宫颈病变级别的升高HPV-16整合发生率呈上升趋势-5）Ⅱ＋Ⅲ期宫颈癌中整合型HPV—16所占比例显著高于Ⅰ期宫颈癌结论：1）多重实时定量PCR是一种敏感性高、简便快速的HPV—16病毒存在状态的检测方法2）HPV-16整合是宫颈癌变的早期事件，与宫颈癌前病变的进展有关。3）宫颈癌中整合型HPV—16的发生可能具有预后价值

This design uses the monolithic integrated circuit to control 8 groups signals the sampling as well as the read-write process, uses the monolithic integrated circuit stored datum, uses the monolithic integrated circuit AT89S52 readout, through application software, 8 group signal demonstrations on hypothesized , and uses the light emitter diode demonstration.

本设计采用单片机控制8路信号的采样以及读写过程，采用单片机存储数据，采用单片机AT89S52读出数据，通过应用软件，将8路信号显示在虚拟示波器上，并且用发光二极管显示。

This design uses the monolithic integrated circuit to control 8 groups signals the sampling as well as the read-write process, uses the monolithic integrated circuit stored datum, uses the monolithic integrated circuit AT89S52 readout, through application software, 8 group signal demonstrations on hypothesized oscilloscope, and uses the light emitter diode demonstration.

本设计采用单片机控制8路信号的采样以及读写过程，采用单片机存储数据，采用单片机AT89S52读出数据，通过应用软件，将8路信号显示在虚拟示波器上，并且用发光二极管显示。

A carrier gas such as nitrogen is directed through line 20 and valve 22 to connect with line 26 and mix with the gas sample.

如氮气之类的载体通过管线20和阀22引入，与管线26相通，与气体样品混合。

But for the most part, knaves and parasites had the command of his fortune

然而支配他的家产的大多是恶棍和寄生虫。