查询词典 integral curvature

Distributions of corneal curvature With the formula 〓 Sin〓αwhich is about the curvatures of oblique meridians on toric surface, the theoretical values of anterior, posterior and total corneal radius of curvature of the oblique meridians were obtained.

3角膜曲率分布根据托力克面斜轴子午线曲率F'计算公式〓，确定角膜前、后表面斜轴子午线曲率及斜轴子午线总角膜曲率的理论值，并通过分析该理论值与实测值之间的一致性，明确角膜曲率分布特征。

We corrected this congenital deformity with tunica albuginea plication alone. Complication of mild ventral curvature after plication occurred in two patients, but it was not severe enough to require reoperation. One case developed recurrent penile curvature due to infection, which was resolved after re-plication.

所有病例均接受单纯白膜折叠术治疗，2例在术后追踪仍有轻微的腹面弯曲，但严重程度尚不须再接受手术矫正，另l 例则因术后感染而复发，再次手术后情况良好。

For each patient, a 3D reconstruction of the spine was obtained from calibrated biplanar radiographs.3 The reconstructed models were then used to compute 4 indices of the thoracic segment: the Cobb angle, thoracic kyphosis (measured from T4–T12), axial rotation of the apical vertebra, and the orientation of the plane of maximum curvature with respect to the sagittal plane.22,2 Measurements of coronal and sagittal plane curvature were based on a curve fitted mathematically through the centers of the vertebrae.

对冠状面和矢状面的角度测量基于通过椎体中心的合适的曲度数学计算。

Experimental Research on FBG Sensor for Large Curvature Detection;2. For large curvature arch, the neutral axis does not pass through the centroidal line of the cross-section, so the moment of inertia is not consistent with the second moment of area.

大曲率拱中，截面形心轴与中性轴不重合，其截面抗弯惯性矩与不考虑曲率影响的截面面积二阶矩有一定的差别；当截面尺寸相对拱弧长来说较大时，此时拱为深拱，剪切变形的影响不能忽略。

For loading along curved strain path,it is found that the delay anglenot only depends on the curvature of the path but also on the rate of the curvature re-spected to the path are length.Therefore,we can conclude that Lensky's hypothesisof local determinability for delay angle is not hold for this material.

对沿曲线应变路径加载的情形，实验发现，滞迟角的变化规律不仅与路径曲率有关，而且与曲率的变化率密切相关，表明Lensky的&局部确定性&假设不再成立。

In this dissertation, considering the influence of transverse shearing deflection and noncoincidence of torsion center and gravity center, the equilibrium formulas of variable-curvature box-girder with rectangular cross section were established. Based on deformation expression of arbitrary point on the girder and relationship between inner forces and displacement equations, considering noncoincidence of torsional center and gravity center, the governing differential equations for variable-curvature box-girders were generalized.

针对具有竖直对称轴的矩形断面变曲率箱梁，考虑了挠曲剪切应变和曲梁剪心和形心分离的影响，推导了变曲率箱梁的平衡方程；通过箱梁内任一点的位移方程和内力-位移关系，推导了考虑曲梁剪心和形心分离的变曲率箱梁的挠曲扭转控制微分方程。

The mechanical behavior measured includes: the relationship between the moment and curvature, and the relationship between ovalization and curvature.

本文目的是实验研究316L不锈钢管在循环弯曲负载时的力学行为及皱曲损坏。

The purpose of this thesis is to use finite element software ANSYS to analyze the mechanical behavior of thin-walled SUS304 stainless steel tubes with elliptic-notched subjected to curvature-controlled symmetric cyclic bending. The mechanical behavior contains the relationship among curvature, bending moment and ovalization. There are two kinds of the elliptic-notch.

本研究是以有限元素分析软体ANSYS 分析SUS304 不锈钢椭圆形凹槽薄壁圆管承受对称曲度循环弯曲负载下的力学行为，其中力学行为包含有曲度、弯矩及椭圆化的相互关系，而椭圆凹槽分为两种，一种为固定凹槽的深度，并改变凹槽的宽度；另一种为固定凹槽的宽度，并改变凹槽的深度。

The buckling failure measured includes: the relationship between controlled cyclic curvature and ovalization at buckling, and the relationship between the controlled cyclic curvature and the number of cycles to produce buckling.

力学行为包含有：弯矩－曲度的关系及椭圆化－曲度的关系，而皱曲损坏包含有：控制循环曲度－到达皱曲椭圆化的关系及控制循环曲度－循环至皱曲圈数的关系。

For the ovalization-curvature curve, the ovalization exhibits the unsymmetric-increasing ratcheting manner with the number of cycles. It is shown that the width does not affect the aforementioned curve, however, the deeper the sharp-notch, the larger amount of the ovalization to bend the tube to a certain magnitude of curvature.

至於椭圆化-曲度的曲线图中显示，椭圆化会随著循环圈数呈现非对称棘齿状的增加，而凹槽宽度对上述曲线没有太大的影响，但尖锐凹槽的深度越深，弯曲至某固定曲度时所产生的椭圆化量就越大。

A carrier gas such as nitrogen is directed through line 20 and valve 22 to connect with line 26 and mix with the gas sample.

如氮气之类的载体通过管线20和阀22引入，与管线26相通，与气体样品混合。

But for the most part, knaves and parasites had the command of his fortune

然而支配他的家产的大多是恶棍和寄生虫。