查询词典 insertion

Move the cursor to the target position and click on it to fix the insertion point.

将光标移动到目标位置，并点击来确定插入点。

The insertion had three phases which grouped by the duration of pedipalps inserting.Initial long inserting duration about 25 min was followed by a medium inserting duration(15min or so);however,subsequent short inserting decreased to approximately 5 min in duration.

通过分析，发现了一种微蛛新的交配模式，即可将浅斑近微蛛的插入期分为三个阶段：首先是大约25 min长插入期，接着是一个大约15 min的中度插入期，最后是一个大约5 min的短插入期。

To investigate the relationship between the angiotensinconverting enzyme insertion/deletion mutation and the aldosterone synthase (CYP11B2) gene C(-344)T single nucleotide polymorphism in pedigreed primary hypertension and pedigreed nomortension.

目的探讨原发性高血压家系与血压正常家系血管紧张素转换酶基因插入/缺失位点及醛固酮合成酶（CYP11B2）基因C(344)T位点单核苷酸多态性的关系。

Results:There were 261 oviducts in the 135 infertile women and 57 of them were obstructed.The successful rate of tube insertion is 73.3% in the 57 obstructed oviducts.

结果：135例不孕症患者261条输卵管，经插管确诊梗阻输卵管57条，治疗成功率为733％。

It can be observed from cyclic Volt-Ampere curves of LiNiO〓 that the insertion and extraction of Li〓, at the site of interlayer octahedra and tetrahedron of LiNiO〓 take place in two steps.

研究了P〓O〓、H〓BO〓、SiO〓和Al〓O〓对LiNiO〓结构和充放电机理的影响。P〓O〓提高了充放电过程中晶型转变的可逆性。H〓BO〓和SiO〓使LiNiO〓由六方晶系向无定形态转化。

248Nm zero-order nulled chirped silica phase masks are fabricated by insertion a cylindrical lens to 325nm He-Cd laser holographic system to form the chirped grating patterns on photoresist and then transfer the patterns to silica substrates by reactive ion etching.

采用在325nm He-Cd激光双光路全息干涉系统的一臂上插入柱面镜的方法和反应离子刻蚀技术研制了周期渐变的零级抑制石英相位掩模版，并用该掩模版在B/Ge双掺光纤上研制出中心波长1551nm，带宽11.4nm，反射率约60％的宽带Chirp光纤光栅。

The insertion torque, pull-out strength, relative migration, energy absorption ofeach screw were measured.

结果 拧紧力矩与骨密度、拧紧力矩与轴向拔出力、轴向拔出力与骨密度之间存在明显的正相关关系(P.05)。

AbstractObjectives1 Correlate bone mineral densityto vertebral compressive strengths.2 Consummate the technique for percutaneous polymethylmethacrylate vertebroplasty and observe the pattern of PMMA imaging distribution.3 Determine the strength and stiffness of osteoporotic with or without vertebroplasty with PMMA bone cement.4 Correlation of BMD,insertion torque and pull-out strengths of pedicle screws.5 Ascertain whether augmentation with PMMA bone cement can enhance pedicle screw fixation in the osteoporotic spine.6 Ascertain whether augmentation pedicle screw fixation with PMMA bone cement can enhance the stability of unstable thoracolurner burst fractures of osteoporotic spine.

目 的1、测试椎体压缩强度，分析强度与骨矿物质密度（bone mineral density，BMD）的相关关系。2、观察经皮椎体成形术后聚甲基丙烯酸甲脂（polymethylme- thacrylate，PMMA）骨水泥在椎体内的形态学分布及影像学表现。3、比较PMMA骨水泥骨质疏松椎体成形术前/后椎体最大抗压力和压缩刚度的变化。4、分析椎体BMD、螺钉最大旅入力矩和最大拔出力三者之间的关系。5、分析PMMA骨水泥强化骨质疏松椎弓根螺钉后的螺钉的最大轴向拔出力和拔出刚度的变化。6、评价PMMA骨水泥强化骨质疏松椎弓根螺钉脊柱内固定对不稳定型胸腰椎损伤的即刻稳定性和反复载荷后的稳定性。

But due to significant magnetic flux leakage present in the loosely wound embedded solenoid inductor structure, large inductance cannot be realized in a compact structure. This is followed by the design of a LTCC common-mode filter intended for use with USB 2.0 products. As compared to the wire-wound common-mode choke, the designed multi-layer common-mode filter produces lower insertion loss on differential-mode signal than conventional ferrite-based common-mode filter.

接著讨论利用低温共烧陶瓷制程技术，设计应用於USB 2.0产品的共模滤波器，相较於一般以磁性材料为主的绕线式共模滤波器，使用多层电路技术设计的共模滤波器可提供较低的差模讯号损失，此外，应用偏移线路的新架构而非完全重叠的线路来设计差模讯号线路组，可减少33%的零件厚度。

OBJECTIVE: To observe the methods and results of screw insertion and histocompatibility of host using Kirschner wire plus tapping technique.

目的：以徒手克氏针加叩击法制备胸椎椎弓根钉道，观察螺钉置入的准确性及置入后与宿主的组织相容性反应。

You can snipe the second and third union leaders from this position.

您可以鹬第二和第三工会领袖从这一立场出发。

Aiming at the currently shortage of XML streams quality detecting, this paper proposes a new forecasting method of XML streams quality by least squares support vector machines, which is used the method of XML keys' vector matrix as windows, and vector product wavelet transform to multilevel decompose and refactor the XML streams series, that can fulfill real-time checking demand of XML quality, and ensure constraint, consist- ency and integrality. For even more adapting net load, it proposes a control strategy by weight and adaptive adjustment to ensure XML streams quality.

针对当前XML数据流质量检测存在的不足，提出构建XML键的矢量矩阵作为窗口，利用矢量积小波变换多级分解与重构XML数据流，再结合最小二乘支持向量机对XML数据流质量进行预测的一种方法，满足XML数据流质量重构时实时检测的要求，保证XML数据的约束性、一致性与完整性；为了更好的适应网络负载，采取加权与自适应窗口调整等调度策略充分保证XML数据流的质量检测。