查询词典 input signal

This task aims to design a full digital integration project of laser range finder signal processing system. There are five parts that include signal arising, signal gathering, synthesis contraling, data processing and data transmission in this integrate circuit, except for laser emission and laser incepting system.

本文针对激光测距信号处理系统设计了一套全数字集成方案，除激光发射、接收电路以外，将信号发生、信号采集、综合控制、数据处理和数据传输五个部分集成为一块专用集成电路。

To exert the use of high sensitive CCD and improve the performance of instruments and the quality of pulsatile signal of spectrum,the paper based on linear CCD of buried channel IL-C6-2048C,the output of which is subtractive polarity and discrete analog signal,and intermixes the high amplitude of reset-pulse,designs the circuit to pre-treat properly to the output's signal.

为了充分发挥高灵敏度CCD的作用，提高脉动光谱信号的质量和仪器的性能，本文在埋沟道型IL-C6-2048C线阵CCD基础上，根据CCD的输出信号是负极性的离散模拟信号并且混杂有幅度较大的复位脉冲干扰的特点，设计电路对CCD输出信号进行适当的预处理。

Well, if you have a laser busily reading the disc, there's obviously going to be quite a bit of reflection and scattering of the signal, and if it's reflected off anything back in phase with the signal that's going on it just mucks the signal up.

嗯，如果雷射头忙著读取光碟，很明显讯号就会有很多反射跟散射，而如果反射讯号又折回跟传输中讯号同相位那讯号就会被搞乱E所以光亮及具反射性的表面很容易破坏整件事，所以必须以能吸收红外线的漆来尽量控制这种情况

The phase signal and the quantized analog signal are used to recreate the digital signal.

该相位信号和经过量化的模拟信号被用于重新创建数字信号。

This dissertation put forward a method of eliminating noise and reconstituting broken wires signal and inquired the space-frequency range of the signal ripple resulted from tensile stress on the MFL signal curve.

提出了去除干扰重组断丝信号的方法，分析了漏磁曲线上应力波纹的空间频率分量。

E. the optimal signal timing method of the green wave tuning signal control and that of the minimum delay time summation of the average delay time.The thesis gives an analysis of the widely adopted signal control systems such as TRANSYT, SCATS and SCOOT and points out the disadvantages of the systems.

分析了当前世界各国广泛使用的信号控制系统TRANSYT、SCATS、SCOOT的主要技术特征、优点及其局限性，指出了这类集中控制系统在四个方面存在的共同缺陷。

Linkage mechanism of study. Forepart all gather be linkage mechanism structural analysis and agency designer. In recent years so emphasize in kinetic synthesis dynamic and motility analysis. So text needle towards inquire into slider four-bar linkage mechanism agency positioning control.Research emphases are as PID control, fuzzy control, Fuzzy sliding mode control three kinds of controllers for control core. Permeate practical mechanism to positioning control to function. Simple exertion market vends signal extract card (PCL-833) and multi-function card (PCI-1711). Make it make signal extract and bring forth exportation control voltage. Will AC servo motor turn signal, as positioning system point of angle sensor. Reach to slider four-bar linkage mechanism servo positional control research.

连杆机构的研究，早期都集中在连杆机构的结构分析和机构设计，近年来也多著重於运动及动力分析上，因此本文就是针对於探讨滑块四连杆机构的定位控制，研究重点是以PID控制、模糊控制、模糊顺滑模式控制三种控制器为控制核心，透过实际的机构达到控制定位的功能，运用市面上贩卖的讯号撷取卡(PCL-833)和多功能卡(PCI-1711)，使其对讯号做撷取和产生输出控制电压，将AC伺服马达的转动讯号，作为定位系统的角度感测器，达到滑块四连杆机构伺服定位控制的研究。

modulation is the transmission of information to be loaded onto a high-frequency signal in the process.amplitude modulation using signal to control the rate of carrier,with its linear modulation signal changes,and maintain the same carrier frequency.in the amplitude modulation,in accordance with the strength of signals in the spectrum of different components,it is divided into ordinary am (amplitude modulation standard am),with inhibition of bilateral carrier am,the carrier single sideband suppression am.the main difference is the different methods and structure of the spectrum.

摘 要：调制是将要传送的信息装载到某一高频信号上去的过程。振幅调制是用调制信号去控制载波的幅度，使其随调制信号线性变化，而保持载波的频率不变。在幅度调制中，根据已调信号的频谱分量不同，分为普通调幅、抑制载波的双边带调幅、抑制载波的单边带调幅。它们的主要区别是产生的方法和频谱结构不同。

The main reasons and its correlated factors of the photoacoustic signal had been quantitatively analyzed based on signal absorption and photoacoustic rationale. It is found that the changed coupling coefficient of sound source and optical cavity modes which caused by the intensity of incident light absorbed by gas sample is the major reason, and a criterion was put forward for signal saturation depth estimating.

基于气体吸收和光声光谱原理定量分析了光声信号饱和的主要原因及影响因素，分析表明气体样本对入射光强吸收而导致的声源与本征共振模式的耦合系数改变是异常饱和的主要原因，并导出判定光声信号饱和深度的准则以用于判定高浓度气体饱和深度。

In this paper, based on the analysis of the IF GPS signal theoretic model, a digitized GPS signal generator is implemented in Matlab, which can generate the received GPS signal at the digitized IF frequencies, and the noise and receiver clock error are also simulated.

本文在中频GPS信号理论模型分析的基础上，用Matlab实现了一种数字GPS信号生成模型，它能够在数字中频上产生GPS接收信号，其中包含仿真的噪声和接收机时钟误差。

The witness also told the jury at the Royal Courts of Justice in London that he saw a paparazzo fighting with a member of the public who was trying to stop him taking pictures in the minutes before the emergency services arrived.

他还告诉在伦敦皇家法庭的陪审团，在急救服务到来之前，他当时看见一个狗仔队正和一群阻止他拍照的人打架。

The entire N／C program on a tape is made up of an accumulation of these successive data blocks.

纸带上的整个数控程序由这些连续数据单元连接而成。