查询词典 input power

System start-up BIOS, that is, the computer Basic Input Output System (Basic Input-Output System), is integrated on the motherboard, a ROM chip, which preserves the most important computer system basic input / output procedures, system information settings, the boot Power On Self Test procedures and system bootstrap program to start.

系统开机启动 BIOS，即微机的基本输入输出系统(Basic Input-Output System)，是集成在主板上的一个ROM芯片，其中保存有微机系统最重要的基本输入/输出程序、系统信息设置、开机上电自检程序和系统启动自举程序。

Through analysis of the characteristics of power flow, transmission efficiency and self-lock of a combined planetary transmission, a design method based on the power design parameter of the bifurcated power of the main branch and the total input power ratio was developed in this paper.

对组合式行星传动的功率流特性、传动效率、自锁条件等进行了分析，提出了以系统主支路功率流大小与输入总功率的比值为功率参数的设计方法，并给出了系统实现功率分流传动和自锁的判别准则。

Input power in the technical parmeters list is average power of the allowable power calculated from the antigluing capability of gear contact strength and the allowable power calculated from the antibending capability of the teeth of cogwheel of the turbine.

技术参数表中的"输入功率"；是按齿轮接触强度"抗胶合能力"计算的许用功率和按蜗轮轮齿"抗弯曲能力"计算的许用功率二者的平均功率。

The results show that the ingather of tungsten in the composites using internal feedstock injection is higher than that of the composites using external feedstock injection. For the composites using IFI method, the influence of input power on the copper oxidation is not evident, while more and more cuprite (Cu2O) is detected with the increasing of input power for the composites using EFI method. The thermal conductivity of WCu composite is lower than the theoretical value by ROM.

结果表明，在内部送粉条件下，复合材料中钨的收得率要高于外部送粉条件下复合材料中钨的收得率；在内部送粉条件下，功率对铜氧化的影响并不明显；而在外部送粉条件下，随着功率的提高，铜的氧化明显增多；由于氧化物和孔隙等的存在，利用大气等离子喷涂工艺制备的复合材料的导热率远远低于根据混合法则计算的理论值。

In addition, the ratio of flow rate to input power has maximum value when input power is in the range of 1.2～1.8W.

功率小时，预应力使流量降低，功率大时，预应力使流量增加，泵的流量与输入功率的比值与输入功率的关系曲线有最大值，约在1.2～1.8W之间。

Therefore, the instantaneous power input will have a Power Good signal to change the state of confusion.

所以，电源输入的瞬间会产生一个Power Good信号来改变这种混乱的状态。

The result indicates that the output power oscillates and weakens along with increasing input power,and its oscillation period depends on the distance between the medium and beam focal point.Limiter′s limiting ability will decrease if waist size of the incident Gaussian beam and the aperture size increase.With a fixed input power scope,medium′s best limiting position will move towards the focal point if waist size of Gaussian beam and the aperture size increase,but the best limiting position will change a lot with different input power scopes.

结果表明：限幅器的出射功率随入射功率的增加衰减振荡，其振荡周期取决于介质相对于光束焦点的位置；限幅器的限幅能力随入射光束腰半径和光阑孔径的变大而减弱；入射功率范围固定，入射光束腰半径和光阑孔径增大时，介质的最佳限幅位置向入射光束的焦点靠近，但是在某些入射功率范围内会存在多个最佳限幅位置；光限幅器的箝位输出功率随光阑线性透过率的增加存在线性增加和非线性增加两个不同区域，实际应用中应在线性增加区域确定光阑孔径的大小。

Audio Noise gate, Also has operates the smoothest restoration characteristic automatically, Independent LED demonstrated, Automatic, normal work way, input, power take-off valve, certainly is your best choice, the stereo sound balance, the non-balanced input, the balanced output, the insertion point and in the standard 1U structure sets at the power source, suits your project installment.

audio噪声门电路，还有自动运算最平滑的恢复特性，独立的LED显示，自动、正常工作方式，输入、输出开关，一定是您的最佳选择，立体声平衡、非平衡输入，平衡输出，插入点和标准的1U结构内置电源，更适合您的工程安装。

The result was shown: With input power increasing, the temperature, the pressure and the flow are increasing. As the highest input power 115W is charged, the smallest thermoresistance is 0.55℃/W, the highest pressure is 4.15bar, the highest temperature on the surface of radiator is 78.5℃, the optimal charge ratio is 80%～100%, under this station the biggest flow is 12g,the smallest charge ratio is 60%.

结果表明：随着输入功率的增加，散热装置的温度、压力和流量都在增加，当输入最大功率115W时，该散热装置的最小换热热阻为0.55℃/W，最大工作压力达4.15bar，电子元器件最大表面温度74.5℃，最佳充液率为80%～100%，此时最大工质流量为12g，最小充液率60%。

Input Power Factor Correction: The rectifier shall be power factor corrected so as to maintain an input power factor of 0.98 lagging to unity at all load levels to ensure generator compatibility and avoid reflected harmonics from disturbing loads sharing the utility power.

UPS模块的设计须可使之作为双变换和在线反向输送系统在下列模式下正常工作。A。正常模式：逆变器须可不断向临界负载输电。整流器/电池充电器须从交流电源获取电能并向逆变器供电，同时以浮动方式给电池充电。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。