查询词典 inner angle

The strew length of prefixed point was 41.84 mm, the screw angle with panes lateralis was 69.41°, the screw angle with inferior verticular plane of panes lateralis was 22.67°; the length of postfixed point was 42.28 mm, the angle with panes lateralis was 68.45°, the angle with inferior verticular plane of panes lateralis was 20.79°. Of the 60 nails drilled, two were drilled out of the post facies articularis of calcaneous, the accuracy rate was 97.67%.

其前点螺钉平均长度为41.84 mm，与跟骨外侧面平均呈69.41°、与跟骨外侧面的底垂面平均呈22.67°；后点螺钉平均长度为42.28 mm，与跟骨外侧面平均呈68.45°、与跟骨外侧面的底垂面平均呈20.79°；30足60枚钢针有2枚钻出跟骨后关节面，钻人安全率为97.67%。

3In the normal space tensile,after controling the influence of density, the variation ofmicrofibril angle had a decisive effect on L MOE and longitudinal tensile strength of D333A wood microtome section; the Correlation coefficient between microfibril angle and L MOE became significant at 0.05 level for D1123A wood microtome section; the Correlation coefficients were all unsignificant between microfibril angle and L MOE and between microfibril angle and longitu- dinal tensile strength to D1223A wood microtome section.

正常间距拉伸中，控制密度的影响后，微纤丝角的变化对D333A组微切片纵向MOE和抗拉强度的变化起着决定性作用；对D1123A组微切片纵向MOE的相关系数达到0.05水平上显著；对D1223A组微切片纵向MOE和抗拉强度都成负相关关系，但都达不到显著水平。

As the forward velocity increasing, the windrowing angle would be decreased, but the effect of forward velocity on windrowing distance was not obvious. The windrowing angle and distance of multiple sugarcane stalks would be smaller than those of single sugarcane stalk, but the maximum range of windrowing angle and distance of multiple sugarcane stalks would be greater than those of single sugarcane stalk. In order to sugarcane stalks outward windrowing, holding height must be within ±100mm of height of sugarcane mass center. As holding height increasing, the windrowing distance would be decreased, but the effect of holding height on windrowing angle was not obvious.

随着夹持输送装置输送速度的增大，甘蔗铺放角和甘蔗铺放距离也随着增大，随着机车前进速度的增大，甘蔗铺放角是减小的，而前进速度对甘蔗的铺放距离影响不大；多根甘蔗的铺放角和铺放距离要比单根甘蔗小，铺放角和铺放距离最大极差要比单根甘蔗大；入口夹持点高度应在甘蔗质心高度±100mm范围内为宜，以保证甘蔗能向机车外侧铺放，随夹持高度的增加，甘蔗质心位于夹持点下方的距离增大，甘蔗铺放距离减小，而夹持高度对甘蔗铺放角影响不大。

Because of this, it is usual to specify the lead angle on the worm, which is the complement of the worm helix angle, and the helix angle on the gear; the two angles are equal for a 90-deg. Shaft angle.

正因为如此，它通常指定牵头角度对蠕虫，它是相辅相成的蠕虫螺旋角，螺旋角对齿轮；两个角度来看都是平等的，为90摄氏度。

To the femoral neck fracture with neck-shaft angle of less than 135 degree, the fixation with the entry angle of less than 135° can make the neck-shaft angle rising, meanwhile, lag screw's location is easier to trend to the inferior of femoral head, displacement and angle between fracture surfaces satisfy the demand of functional reduction or extroversion reduction, and a satisfied stability is performed in biomechanical test.

对于颈干角小于135°的股骨颈骨折，以低于135 °的进钉角度固定时，能增大颈干角，同时拉力螺钉的位置更容易偏向股骨头颈的中、下部，骨折端的位移、成角也能够符合功能复位的要求，在力学测试中表现出较好的稳定性。

The precision of electronic angle gauge is 1Π 7 000 and the total error of Bitterlich angle gauge is 1Π 32. S o the precision of the electronic angle gauge is 200 times as high as general angle gauge and its velocity is higher.

经过分析，电子角规测树精度为1/7 000，而比特利希角规测树精度总误差达1/32，电子角规的测树精度比普通角规高出200倍以上，其速度也较快。

When measuring, based on the segmented contour line of thread, we used the compiled measurement program to calculate and measure the geometrical parameters of the internal taper thread as pitch, half of thread angle and taper angle. Precisions of pitch, half of thread angle and taper angle reached ±0.012mm,±0.17° and ±0.018°. The results satisfied with the technique requirement of production. The reason of error was analyzed.

在测量尺寸时，使用自编程序计算测量内螺纹的螺距、牙型半形及锥角，测量精度分别达到±0.012mm、±0.17°和±0.018°，满足产品的技术要求，并分析了误差产生的原因。

a system of along-track mode sar based on the gps is established.by seeing the gps signal as a chirp,chirp scaling algorithm of this mode with large squint angle is investigated.chirp scaling algorithm is considered more efficient and widely applicable when the bistatic sar system is in side-look or small squint angle mode,but in large squint angle case,the errors caused by taylor expansion are so large that the algorithm could lose its precision.in such a case,an equivalent mono-static sar range mode which has fewer errors than taylor expansion with large squint angle is proposed to substitute the range history of bistatic sar.then bistatic sar images with large squint angles are gotten by common nonlinear cs algorithm.the effectivity of the method is verified by matlab simulation.

摘 要：建立了基于gps的顺轨sar系统模型，通过将gps信号等效为chirp信号，研究了在该模式下的大斜视角chirp scaling算法。在正侧视或小斜视情况下，cs算法具有较好的聚焦性能和广泛的适用性，但在斜视角较大的情况下，该算法将散焦而不能成像，因而提出了用等效的单基地距离模型来代替双基地距离历史的方法，解决了大斜视角情况下距离模型二阶近似误差较大的问题，并结合单基地非线性cs算法，实现了在大斜视角情况下的基于gps反射信号的双基地sar高精度成像，最后通过matlab仿真进行了验证。

At the peak point of backward swing, the vertical height from the center of the ball to the ground was 1.34 ±0.01 meters, the angle of the shoulder was 82 ± 2.5 degrees and the angle of the elbow was 161.35 degrees. During release, the vertical height was 0.13 ±0.01 meters, the angle of the shoulder was 48.00 ± 3.64 degrees and the angle of the elbow was 160.71 degrees.

所得具体结果如下：在后摆最高点时，球体中心点距地面之垂直高度平均为1.34 ±0.01公尺，肩关节角度为82 ± 2.5度，肘关节角度为161.35度；而在出手瞬间球体中心点距地面之垂直高度平均为0.13 ±0.01公尺，肩关节角度为48.00 ± 3.64度，肘关节角度为160.71度。

The theoretical and experimental investigations of discus flight indicate the following useful conclusions:the optimum combination of throw angle and discus inclination angle is 35°/26°at zero wind,while 45°is not the best release angle due to the aerodynamic force;different combinations of throw angle and inclination angl...

由于气动力的作用，45°并非铁饼的最佳投掷角度，实验和理论研究表明：无风时35°/26°的投掷角/倾角组合最佳；顺风和逆风投掷必须采用不同的投掷角/倾角组合才能获得当地条件下的最好成绩；铁饼出手时25r/s的自转速度已经可以满足稳定性的要求。

But this is impossible, as long as it is engaging in a market economy, there are risks in any operation.

但是，这是不可能的，只要是搞市场经济，是有风险的任何行动。

We're on the same wavelength.

我们是同道中人。