查询词典 inlet

The system calculation and analysis on stress field, displacement field and failure zone indicate the high rock slope of spandrel groove and water inlet are stable if they are excavated in the designed slope ratio.

通过对拱肩槽及进水口边坡的应力场、位移场和破坏区域模拟计算表明：拱肩槽、进水口边坡在拟订的开挖坡比条件下整体均处于稳定状态。

The local stability analysis on the rock slope indicates there exist unstable rock-mass blocks in the rock slope of spandrel groove and water inlet which have different level threats to the excavation and operation of the slope.

边坡局部稳定性分析表明：拱肩槽、进水口边坡均存在不同程度的不稳定性块体，对边坡开挖施工和后期工程运行存在不同程度威胁。

Car flooded the water will enter the engine from the inlet resulting in engine flameout this time there will be water accumulation in the cylinder chamber and spark plugs in braving the water if the owner starts the engine the piston will Top connecting rod bend or even cylinder head roof leak causing irreparable damage.

车被淹后，水就会从进气道进入发动机，从而导致发动机熄火，这时候就会有水吞积在汽缸室，而火花塞在顶着水的情况下，如果车主启动发动机，就会把活塞连杆顶弯，甚至将缸盖顶漏，造成安全阀不可挽回的损失。

The groove type for the joint of inlet/outlet pipe and main pipe of nuclear reactor pressure vessel is J type, which intersect the spherical surface. And the space between inputlet and outlet is small, welding distortion is small required, so welding become more difficult.

核反应堆压力容器进出口接管与主管道相连接部位的坡口形式为J形，且与球面相交，进出口接管间距小，要求焊后变形小，焊接难度较大。

This is a high degree of water surface to pump impeller center of the vertical distance, it allows a high degree of vacuum suction, can not be confused with manual water pumps or marked on the nameplate on the vacuum suction to allow a high degree refers to pump inlet section on the value of the vacuum, and Is a standard atmospheric pressure, water temperature 20 degrees Celsius circumstances, a pilot and a determination.

这个高度是指水源水面到水泵叶轮中心线的垂直距离，它与允许吸上真空高度不能混为一谈，水泵产品说明书或铭牌上标示的允许吸上真空高度是指水泵进水口断面上的真空值，而且是在1标准大气压下、水温20摄氏度情况下，进行试验而测定得的。

The high is the water surface to pump impeller center line of the vertical distance, it allows a high degree of suction on the vacuum can not be mixed up, pump product specifications or nameplate allows a high degree of vacuum suction on the pump inlet section refers to the vacuum value, and Standard chemical pump is a standard atmospheric pressure, water temperature 20 degrees Celsius case, trial and determination to come by.

这个高度是指水源水面到水泵叶轮中心线的垂直距离，它与允许吸上真空高度不能混为一谈，水泵产品说明书或铭牌上标示的允许吸上真空高度是指水泵进水口断面上的真空值，而且是在1标准大气压下、水温20摄氏度情况下，进行试验而测定得的。

The high water means the water pump impeller to the center line of the vertical distance, which permit smoking should not be confused on a high vacuum pump nameplate on product label instructions or permit smoking on the high vacuum pump is the inlet of the vacuum on the value of cross-section, and are at one standard atmospheric pressure, water temperature 20 degrees Celsius, the determination to carry out a test.

这个高度是指水源水面到水泵叶轮中心线的垂直距离，它与允许吸上真空高度不能混为一谈，水泵产品说明书或铭牌上标示的允许吸上真空高度是指水泵进水口断面上的真空值，而且是在1标准大气压下、水温20摄氏度情况下，进行试验而测定得的。

The high water means the water pump impeller to the center line of the vertical distance, which permit smoking should not be confused on a high vacuum pump nameplate or product label instructions on the permit smoking on the high vacuum pump is the inlet of the vacuum on the value of cross-section, and are at one standard atmospheric pressure; the water temperature 20 degrees Celsius, the determination to carry out a test.

这个高度是指水源水面到水泵叶轮中心线的垂直距离，它与允许吸上真空高度不能混为一谈，水泵铭牌或产品说明书上标示的允许吸上真空高度是指水泵进水口断面上的真空值，而且是在1标准大气压下；水温20摄氏度情况下，进行试验而测定得的。

Based on the N-S equation, standard κ-ε turbulence model, the FLUENT was used to simulate the kind of air inlet of solid ducted rocket.

基于RANS平均的N-S方程、标准κ-ε双方程湍流模型，利用FLUENT软件对某型固体火箭冲压发动机进气道内外流场进行了三维数值模拟。

Although the dispersion of particles with the Stokes numbers far less than or of the same order of 1 are insensitive to the changes of inlet velocity differences, the dispersion of particles with Stokes number much larger than the order of 1 are influenced by the coherent structures under U〓/U〓=α=0, where α=0 means the particles are released into the flow in stationary state.

在目前国内开展三维N-S方程大涡模拟还非常困难的情况下，本文以两相平面湍射流为对象，不采用流动对称性假设，成功地用大涡模拟方法预报了平面湍射流拟序结构的产生、发展及大涡的合并破碎全过程，和F.O。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。