查询词典 inlet flow

, though particles are not in the flow passage of the outlet of the impeller, the absolute velocity of particles has a component velocity whose whirling direction is the same as that of the impeller under the influence of the revolving impeller, in addition, particles do not flow toward the outlet of the impeller, instead, they flow toward the inlet of impeller.

款 尽管粒子是不是在流道叶轮，绝对速度的粒子的一个组成部分，其速度旋转方向是相同的叶轮的影响下， 3777叶轮，此外，颗粒不流向叶轮，相反，它们流向导流叶轮。

Axial-flow compressor ; experimental investigation ; inlet pressure distortion ; absolute flow angle

轴流压气机；试验研究；压力畸变；绝对流动角

The flow characteristics of surface singular point, seperation lines, re-adhesional lines, low speed back-flow area of the impeller and back-flow area at the impellor's inlet were revealed.

揭示了额定流量与小流量时叶轮的表面奇点、分离线、再附着线、低速回流区和进口回流等流动特征，进而提出了改进螺旋离心泵设计方法与结构的设想。

To all project practicality, the introduction is given to the operational characteristics, the methods for calculation and the researching actuality of the tail tunnels with sloping ceiling underground hydropower stations the Three Gorges. This paper has discussed in detail the characteristic method being the same with the compressive flow and the Priessmann solution being the same with the free-surface-pressure flow. And how to deal with boundary conditions has been expatiated. Also hydraulic transient process of tremendous load fluctuation in the tail tunnels with sloping ceiling has been numerical simulated and the Fortran program for numerical simulation has been given. The paper gain the maximal press for tail end of the shell, the maximal rising rate of rotational speed of generating set, the maximal vacuum degree for inlet of the tail tunnels and so on under 11 kinds conditions of tremendous load fluctuation. These conditions include the design conditions, the check conditions and the superposition conditions. Finally, the computing results have been analyzed and summarized. The end chapter is the general comment of the whole-length content and the describing of the intending view of researching.

本文以三峡右岸地下电站尾水洞设计为背景，从工程实际出发，阐述了变顶高尾水洞的工作特性、使用范围及其研究现状；详细论述了适用有压流的特征线法、适用明满交替流的普里斯曼解法等数学模型；边界条件的给定和明满交替流的计算方法；用Fonran语言编制了数值计算程序，对三峡右岸地下电站变顶高尾水洞的大波动工况进行了数值模拟，分别得出了在设计工况、校核工况和叠加工况下蜗壳末端最大压力上升值、机组最大转速上升值和尾水管进口最大真空度等重要参数；对数值计算结果进行了详细分析并得出了有价值的结论；最后展望了今后水电站变顶高尾水洞的研究方向。

According to the Z-score results,the statistical optimization of the spray drying variables was:atomizing pressure 190 kPa;air flow 0.7 m~3·min~-1feed flow rate 7.0 mL·min~(-1 and inlet temperature 110℃.

考察了大鼠气管内滴注TP5溶液及气管内给予不同处方组成的TP5干粉吸入剂后，TP5在肺粘液层中的浓度-时间变化情况。

This is realized by using critical flow venturi- nozzles and by controlling the critical flow inlet conditions to constant va...

该流量是柴油机气态排放和颗粒排放计算中的关键参数之一，是排放测试设备的关键技术。

At constant viscosity, by increasing the liquid flow rate, the liquid film's velocity is increased; at the same experiment condition, the frequency of the liquid film is same at the same radial direction; the air current has minimum effect on liquid film bottom flow velocity, while it has an obvious effect on liquid film surface flow velocity. The longer the distance between liquid film and the inlet, the lower the pulsatory frequency and longer the wavelength.

在粘度基本不变的情况下，随着液体质量流率的增加，液膜流动速度随之增加；在同一个实验条件下，沿圆管径向各质点的频率基本保持不变；气流场速度对液膜底层流动速度影响很小，对于液膜表面流动速度有着较大的影响；沿液膜流动方向，液膜的脉动速度逐渐增加，脉动频率降低，脉动波长变长，与报道的通过快速摄像得到的液膜发展趋势一致，证实用PDA研究液膜流动是可行的。

Because of the asymmetry of the inlet structure and the unstable characteristics of the swirl flow,the spinning center of the gas flow deviated from the geometrical center of the cyclone,which resulted in the asymmetry of the flow field and the change of the three dimensional velocity components.

蜗壳式旋风分离器入口结构的非轴对称以及气相旋流的不稳定性造成了气流的旋转中心与旋风分离器的几何中心不重合，从而导致了气相流场三维速度的非轴对称分布以及速度分量由于基准不同而产生的大小和方向变化。

First super-low specific-speed centrifugal pump has a long and narrow flow passage for its high head and low capacity, and the power absorbed by disc friction is too high, so the efficiency is very low; Secondly the diffusion of flow passage is so high, that the reserved flow often emerges at the inlet and outlet of impeller. Therefore the H ~ Q characteristic curve is often hump-shaped, and at the low-capacity operating condition the instability often occurs; Thirdly the centrifugal pump at high-capacity operating condition is easy to overload because the N ~ Q curve appears a rising trend.

首先由于它的扬程较高、流量较小，所以它的流道狭长，圆盘摩擦损失较大，效率相对较低；其次由于它的流道扩散较严重，易在叶片进口产生回流和在出口产生脱流，扬程流量特性曲线易出现驼峰，在小流量工况下易产生不稳定现象；第三，由于其功率流量曲线呈现上升趋势，在大流量区运行时电机易过载。

The twin vortex at the tip clearance of hub side and the asymmetric recirculation at wall of inlet duct are also observed. 4 The mass-weighted average of flow parameter at inlet and outlet of every passage of impeller changes with different positions. In addition to the above, with the unsteady method, the head rise, shaft power and efficiency have been predicted well.

再次，采用整机非定常计算准确预测了三种工况下部分流泵的扬程、轴功率和效率；发现了叶轮进出口质量加权平均的速度、压力、动量矩的宏观不变特性；蜗壳内流动的非定常性对部分流泵的外特性有重要的影响。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。