查询词典 inlet flow

On the basis of these results, the relations of total-pressure recovery coefficient or flow coefficient and flight mach number, angle of attack and the second movable wedge angle of the inlet have been founded by hypersurface fitting, then the mathematical model of the inlet is established.

根据流场计算结果并利用超曲面拟合方法建立了进气道总压恢复系数、流量系数与飞行马赫数、进气道攻角及二级可调斜板角度之间的关系，由此得到了二元混压式超声速进气道数学模型。

This thesis deals with the axial non symmetry of air flow in the cyclone, with change of single inlet to double inlet .

针对旋风器内气流轴不对称问题，从结构上改单进口为双进口。

After inlet model s three dimensional structural grid was generated, proper numerical scheme and onflow model were choosed, then numerical computation on flow field of inlet was taken, finally the better results were got.

通过建立三维结构化网格模型，选择合适的数值格式与湍流模型，对进气道流场进行数值模拟，得到了合理的结果。

The distance between settled releaser and inlet of raw water is 180 cm, and the range of distance between pensile releaser and inlet of raw water is 60-90 cm. The flow of pensile releaser is 2-3 times as much as settled releaser.

较为合理的布置为：固定式释放器S与原水进水口距离为180 cm，悬挂式释放器P与原水进水口的距离在60～90 cm之间。P与S的流量比控制在2～3之间。

The influences of the inlet solution flow rate, the inlet solution temperature, the absorption pressure and the colling condition on heat and mass transfer of absorption process have been discussed.

在此基础上，设计、研制、安装并调试了竖板及矩形通道降膜吸收试验台本体；确定测量方法，选取测量装置并对测量系统不确定度进行了分析。

The diverter may also be used to alternately divert flow from either of the side run-inlet ports to the branch center-inlet port.

这种分流阀也可以用来将两个侧面进口的流体转向到分支中心进口端口。

To research the ways of relieving inlet unstart phenomenon, the flow of a typical hypersonic 2-D inlet with different suction positions was analyzed in this paper.

对某典型二元高超声速进气道流场进行了二维数值模拟，研究了抽吸位置及抽吸流量对进气道性能的影响。

Findings-The inner flow field changes quickly according to 1 gas inject velocity; 2 surrounding air temperature and pressure, and 3 position of jet nozzle and air inlet. The aim of this project is to find an optimum position and geometry for gas generator and inlet opening that can provide a high aspiration ratio for the new design inflator.

在一封闭空间中外围空气可藉由进气道吸入其中，空气由进气道被吸入的气体会因著喷场的速、周遭环境的温与压、喷嘴与进气道的几何形及其相对应的装置位置等因素而改变，且受后端气囊在震波冲击下的开启运动而影响。

By applying black box theory inlet pressure, inlet subcooling, outlet pressure and valve opening are selected as influence factors to flow coefficient of electronic expansion valve.

根据黑箱理论提出将阀前压力、阀前过冷度、阀后压力和膨胀阀流通面积作为膨胀阀流量系数的影响参数。

According to the results of measurements, the effect of geometric parameters of inlet valve seat on the air motion in the inlet port is found obviously. It is also proved according to the calculations of two-dimension model of a steady intake flow.

在研制低涡流比进气道时发现，气门阀座结构对进气流动性能影响较大，对进气道内二维稳态气流模拟计算的结果可从理论上进一步证实了试验的结论。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。