查询词典 inlet flow

Test and analysis show that, the distribution patterns of the tangent veloctiy fields in the big cone area and the small cone area, which are comprised of para-free vortex and para-forced vortex, are basically identical without a change of the radius of the boundary surface; with the increase of the angle of the small cone, the para-free vortex area decreases and the para-forced vortex area increases, and the emulsifiability of the fluid drips increases with the increase of velocity gradient; the tangent velocity increases with the increase of inlet flow, and the maximum tangent velocities of both the big cone area and the small cone area are 4.94 times of the inlet flow; and the maximum tangent velocity increases with the increase of the split ratio and with the radius of the boundary surface not changed.

试验分析表明，大锥段和小锥段切向速度分布规律基本相同，均由准自由涡和准强制涡构成，分界面半径rm没有变化；随着小锥角θ的增加，准自由涡区缩小，准强制涡区扩大，速度梯度增加会加大液滴的乳化程度；随入口流量增加，切向速度增大，经拟合得出大锥段和小锥段的最大切向速度均为入口流量的4.94倍；分流比加大，分界面半径基本不变，最大切向速度增加。

The pipe wall with four 2.5 mm diameter sampling holes and a spin generating element mounted upstream for modifying the inlet flow pattern are set up to improve the representative of the sampled fluid.

管壁四周均匀布置4个直径为2.5 mm的取样孔，并在上游采用旋流叶片将来流整改成液膜厚度均匀分布的环状流型，从而增强了取样的代表性。

It is used to control the pressure of regenerator and regulate the inlet flow of flue gas blower.

它用来控制再生器的压力和调节烟气输送机入口流量。

The effects of process parameters, such as the pressure and the temperature of the saturator, the inlet flow rate and inlet solution concentration of the precipitator, on the particle size and particle size distributions were examined.

在自建的超临界辅助雾化过程实验装置上，以红霉素－乙醇－二氧化碳系统为研究对象，分别研究了混合器压力和温度、溶液浓度及进液速率对微粒形态和粒径的影响。

The experiments show that the PS and PSD of particles produced by SAA process can be controlled by adjusting process parameters, and among them, the pressure of the saturator used has the most effect on the PS and PSD, while the temperature of the saturator has the least effect. When using ethanol as solvent, the optimum operating conditions of using SAA process to produce erythromycin micro-particles from erythromycin-ethanol-CO2 system were found as follows. The pressure and temperature of the saturator are 10.5MPa and 70℃, respectively, the inlet flow rate and the concentration of inlet solution of the precipitator are 9 mLmin^(-1) and 15mgmL^(-1), respectively.

实验结果表明：选用乙醇做溶剂可制备出粒径在1~3μm的红霉素超细微粒，大部分微粒形态呈完整的球形；各影响因素对微粒粒径及粒径分布均有不同程度的影响，其中混合器压力对微粒粒径及粒径分布的影响最明显，混合器温度的影响最小，微粒粒径及粒径分布可通过改变操作参数进行控制；在本研究范围内，最优操作条件为混合器压力10.5MPa，混合器温度70℃，溶液浓度15mgmin^(1)，进液速度9mLmin^(1)。

The effects of solvent properties and process parameters including saturator pressure and temperature, concentration of solution, inlet flow rate and precipitator temperature on PM, PS and PSD were studied experimentally.The results show that water soluble and non-water soluble drugs were micronized successfully using SAA process.

实验结果表明，利用SAA过程能成功地对水溶性和非水溶性药物进行超细化处理，并能制备出具有特定粒径和粒径分布并符合吸入式给药要求的球形微粒。

Based on an analysis of distribution pattern of hydrocyclone"s axial velocity, by changing the inlet flow rate Qi and split ratio Fand making an investigation in the effect of Qi and F on axial velocity field, the factors causing the forming of short-cut circuit and circulating flow are found. It is considered that the short-cut circuit and circulating flow are produced by the structure of the hydrocyclone, and can"t be eliminated completely, though they interfere the flow field inside a hydrocyclone and affect the separation accuracy. Test results show that, by increasing Qi and F and controlling them in a certain range, the separation efficiency of the hydrocyclone can be improved.

在研究旋流器轴向速度分布规律的基础上，分析了短路流与循环流的形成原因，试验研究了改变操作参数，即改变入口流量Qi与分流比F对轴向速度场的影响认为短路流与循环流是由旋流器结构决定的，很难完全消除，它们干扰了旋流腔和大锥段的流场，在一定程度上也影响了分离精度试验结果表明，加大入口流量Qi与分流比F，并将其控制在一定范围内，便可提高分离效率这项研究对水力旋流器分离机理的认识与实际应用均有重要意义

The flow through each unit is controlled by the unit modulating inlet flow control valve.

通过各单元的流量由该单元调制解调器入口的流量控制阀来控制。

When a sudden power failure or accident or normal pump stops when the pump stops, the valve inlet water velocity to reduce stress Agency, the valve plate also fall, when its velocity is zero (that is, inlet flow rate is zero Department), large valve plate because of its own gravity and rapidly turn off (time 3s ~ 5s), the majority of water to prevent backflow, when the valve before and after the formation of a water pressure, water stress, on the one hand through the small valve at the bottom of the three slot for pressure relief vent pressure. 4 water stress from the bypass tube into the cavity patch up the control room (this process for the suction pressure chamber that can effectively absorb the energy of water), when water stress on cavity than inferior vena cava, the pressure of water promote the diaphragm down mobile , the current cavity pressure of water being squeezed out all the small valve plate slowly drop back to standby status, the process time to ease closure adjustable (3s ~ 150s), then the valve has been fully closed, watertight.

当突然停电或事故停泵或正常停泵时，阀门进水口处压力水流速降低，大阀板也随之下降，当其流速为零时，大阀板由于自身重力而迅速关闭（时间3s～5s），可防止大部分水倒流，此时阀门前后形成一种水压差，压力水一方面通过小阀板底部的三条泄压槽进行泄压。4）压力水从旁通管进入膜片控制室上腔（此过程为吸压腔，能有效吸收一部分水能量），当上腔压力水大于下腔时，压力水推动膜片往下移动，当下腔压力水全部被挤出来时，小阀板缓缓下降，恢复到待机状态，此过程中缓闭时间可调节（3s～150s），届时阀板已全部关闭，滴水不漏。

Large axial induced draft fan;; inlet box;; internal flow characteristics;; inlet flow conditions;; rectifier object

论文导师吴克启，论文学位硕士，论文专业流体机械及工程论文单位华中科技大学，点击次数 13，论文页数 85页File Size1796K

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了