查询词典 inlet and outlet

The numerical simulation result indicated that the deformation of protective erodent products film is relatively small, when the following conditions are satisfied, such as the fluid flows from the small inlet to large outlet, the concentric reducer and the relatively small difference of two end calibers of reducer.

以异径管冲蚀失效为例，运用多物理场耦合软件，分析了异径管流体流向、结构和规格对保护膜变形的影响，模拟结果表明：流向为''大进小出''的冲蚀较严重；偏心异径管比同心异径管冲蚀严重；两端管径差越大，冲蚀越严重。

After passing the condenser, the balls will be automatically removed from the CW by means of a strainer located in the CW outlet piping, and then the balls will be diverted by a recycle pump and collector which will then reinject them into the CW inlet.

胶球通过凝汽器之后，自动的由在循环水出水管道的收集器上滤网收集，再经专门的泵继续输送至循环水入口工作。

We are interesting in find a push button faucet that can hold water presure of 30psi and more, the inlet of 3/8" threaded, outlet 3/8" threaded, our design will use it to open an close regular presure water for a bathroom.

我们对一种能承受30磅/平方英寸或以上水压的按钮插口感兴趣。这种插口的出口和进口都带3/8的螺纹。我们的产品在浴室中将使用它去开启一个封闭的规律的水压

Pump: RCDL / RCDLF standards for the installation of the electrical non-self-priming vertical multi-stage centrifugal pumps, electrical axis through the pump head and shaft connected by coupling, rod bolts to cylinder pressure, over-current components in the pump head and out of fixed paragraph water between the pump inlet-outlet in the same line.

泵： RCDL/RCDLF为安装标准电机的非自吸立式多级离心泵，电机轴通过泵头用联轴器与泵轴联接，拉杆螺栓将耐压筒、过流部件固定在泵头和进出水段之间，泵进出水口在同一直线上。

Increase resistance in outlet pipe to low down the capacity, check the inlet pipe and foot valve, reduce the suction lift, block the air leakage, and lower its temperature.

增加出水管内的阻力，以减低流量；检查泵吸水管；检查底阀；减低吸水高度；堵塞漏气处；降低液体温度。

Increase resistance in outlet pipe to low down the capacity, check the inlet pipe and foot valve, reduce the suction lift, block the air leakage, and lower its temperature.

增加出水管阻力以降低流量，检查泵及水管，检查底阀，减少吸水高度，拧紧堵塞漏气处，降低液体温度。

4 When transformer is in the structure of centralized cooling, a glass thermometer base for temperature measurement should be installed next to bus pipe of oil outlet and inlet for oil box.

3.4.3.4.4 当变压器采用集中冷却结构时，应在靠油箱进出油口总管路处装测温用的玻璃温度计管座。

Moreover, the cavitatig flow in poppet valve were simulated for different inlet velocity and different outlet area, respectively.

而且对锥阀在不同进口速度和不同出口面积的流场分别进行了模拟。

In the model the collector is regard as a system, the outlet temperature is the system output, the other variables: the inlet temperature, the ambient temperature and the solar irradiance on aperture plane per unit area are the system inputs.

中文摘要本文以U型管全玻璃真空管太阳集热器为研究对象，在分析太阳集热器传热机理和管内流体温度分布情况的基础上，根据能量平衡和传递函数理论，对侯宏娟的集热器动态测试方法的数学模型进行改进。

Two holes were used for the inlet/outlet gas lines and a third was used to introduce the reductant, 20% aqueous tin(I1) chloride (Baker Inc., No. 3980-01, Phillipsburg, NJ) in 10% HCl, using a peristaltic pump.

两个孔用于进出气孔，第三个孔用于引入还原剂。20%水和三氯化锡溶于10%盐酸中，用搅拌泵搅拌。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。