查询词典 infinitesimal deformation

GPS location technology is first used in Construction Bank building of Xiamen. It has built the control network of floor construction; Precision of location and setting out can meet the needs of high-rise building construction; Deformation curve reflects the law of sunshine deformation; Frequency spectrum chart of kinematic deformation monitoring reflects kinematic feature and the law of deformation.

GPS定位技术在厦门建设银行大厦工程的首次应用，建立了施工楼层的GPS定位控制网，其定位放样精度完全能满足高层及超高层建筑施工的要求；日照变形监测的变形曲线，反映了建筑物的日照变形规律；动态变形监测的频谱图，反映了建筑物的动态特征和变形规律。

By mechanics analysis of ground deformation, this paper makes a systematic research on the affecting factors of ground deformation of shield tunnel and excavation and establishes a predicted model of ground deformation based on neural network. This model is applied to predict actual ground deformation caused by shield tunnel and excavation in Shanghai, Guangzhou, Nanjing etc.

本文以盾构法隧道和基坑为研究对象，通过对地面变形机理的分析，全面系统地从理论上探讨了盾构隧道和基坑引起地面变形的影响因素，建立了基于神经网络的地面变形预测模型，并运用该模型对上海、广州、南京等城市的盾构隧道和基坑工程所引起的地面变形进行了实际预测，获得了令人满意的预测结果。

Cylinder, the cylinder sets of radial a surplus deformation of the cylinder sets a great impact on the cylinder liner reduced radial a surplus amount to reduce the deformation of the cylinder sets, the top surface of the body decreases roughness, but it will increase the body on the plane cylinder only mouth the roughness ; Preload reduced cylinder head bolt deformation of the cylinder liner little effect, the body can reduce the top surface roughness and cylinder body on the plane I ended roughness; Shen appropriate reduced cylinder head bolt hole deep can reduce the deformation of the cylinder sets, but will cause the body and the top surface roughness on the cylinder body only I roughness increases Plane .

工作工况下，对于第2缸来说，气缸套径向过盈量对气缸套变形影响很大，减小气缸套径向过盈量，有利于减小气缸套的变形，减小机体顶面不平度，但会增大机体上缸套止口平面的不平度；减小缸盖螺栓预紧力对气缸套变形影响很小，可减小机体顶面不平度和机体上缸套止口平面的不平度；适当减小缸盖螺栓沉孔深可以减小气缸套的变形，但会造成机体顶面不平度和机体上缸套止口平面不平度的增大。

Many twinnings are produced during the process of AZ31 magnesium alloy deformation at room temperature, twinning deformation is the mainly deformation manner, and twinning increases with the deformation increase up to fracture.

AZ31镁合金室温下压缩产生大量孪晶，变形方式以孪生变形为主，且随着应变的逐步变大，孪晶明显增加直至断裂。

According to the theory of stress-strain relationship of transverse compressive deformation and wood rheological character, it studies the factors about deformation permanent fixation caused by different methods, and analyzes the component change of wood cell wall caused by four physical treatment methods in this experiment. According to the newest research achievements, it is thought that the absolute release of deformation stress and the effective formation of cohesion inside wood are the main reasons of compressive deformation's permanent fixation.

根据木材横纹压缩应力-应变关系、木材流变学特性等理论对木材压缩及变形固定常用方法对形成变形永久固定的主要原因进行了探讨，根据前人对横纹压缩变形的永久固定理论及本实验中使用的四种物理处理方法在处理过程中对木材细胞壁基质物质的变化和表现出的力学特性的影响进行了分析，结合国内外最新研究成果，认为形成木材压缩变形永久固定的主要原因是木材内部变形应力充分释放和内聚力的有效形成。

We obtained the nasal deformation with three-dimensional reconstruction images and adjusted to separate the images of nasal cartilage, defined the form and structure of nasal deformation. Then we measured 10 cases of adult cadavers nasal alar, lateral and septal cartilage through modern mechanical measuring instruments, to obtain the elastic modulus of above three part structure of nasal cartilage, then to obtain more accurate nasal cartilage elastic modulus data through statistical analysis. At the same time, according to the relevant literature, we obtained nasal soft tissue biomechanical properties, mainly were elastic modulus and Poisson\'s ratio. Finally we established three-dimensional finite element analysis model of unilateral cleft lip nasal deformation, defined the model\'s constraint conditions and carried out biomechanical measurement and analysis of unilateral cleft lip nasal deformation.

将唇裂鼻畸形患者鼻部进行三维重建并调校，分离出外鼻软骨的影像，并对鼻部组织进行分层和重建，确定畸形鼻的形态和组织结构；通过现代力学测量仪器，对10例成人尸体鼻部的大翼、侧鼻和中隔软骨进行弹性模量的测量，获得上述三部分鼻部软骨结构的弹性模量数据，并通过统计学分析来获得较为准确的鼻部软骨结构的弹性模量数据，同时查阅相关文献，得到鼻部软组织的相关生物力学性质，主要为弹性模量和泊松比；建立单侧唇裂鼻畸形的畸形鼻部三维有限元分析模型，确定有限元分析的边界条件等，进行单侧唇裂鼻畸形的鼻部生物力学的测量和分析。

Such parameters as the percentage of ordinary reinforcment, amounts and configuration of unbonded prestressed tendons, the ratio of span to depth and the loading patterns were considered. Based on the results, the fomula for the eqivalent length of deformation zone on the beams at ultimate were developed. A simple formula was developed for the ultimate mid-span deflection of concrete beams with concept of equivalent length of deformation zone, and the deformation of beam before internal reinforcement yielding was predicted by the traditional formula for the deformation of partically prestressed concrete beam. Then an analytical model was deduced for analyzing the ultimate stress increment in those concrete beams prestressed with external or internal unbonded tendons based on the mid-span deflection.(4) Testes were carried out on a thin-walled concrete box beam presressed with external CFRP tendons to study its short-term performances under uniform load, long-term behaviors under uniform load, and full-time performance under four-point load in turn.

3以体内非预应力钢筋配筋率、体外预应力筋配筋率、体外预应力筋布置形式、预应力度、跨高比、荷载形式等为参数，用非线性分析程序对体预应力筋混凝土梁进行了参数分析，依据分析结果提出了以综合配筋指标和预应力度为参数的等效变形区长度的计算公式，进而提出了基于等效变形区长度的极限挠度计算公式；体内非预应力钢筋屈服前的挠度计算采用常用的部分预应力混凝土梁挠度计算公式；依据试验和非线性数值计算结果，将不同转向块布置形式的体外预应力混凝土梁简化为跨中一个转向块的体外预应力混凝土梁，推导了基于跨中挠度的体外预应力筋应力增量的简化计算公式。

Such parameters as the percentage of ordinary reinforcment, amounts and configuration of unbonded prestressed tendons, the ratio of span to depth and the loading patterns were considered. Based on the results, the fomula for the eqivalent length of deformation zone on the beams at ultimate were developed. A simple formula was developed for the ultimate mid-span deflection of concrete beams with concept of equivalent length of deformation zone, and the deformation of beam before internal reinforcement yielding was predicted by the traditional formula for the deformation of partically prestressed concrete beam. Then an analytical model was deduced for analyzing the ultimate stress increment in those concrete beams prestressed with external or internal unbonded tendons based on the mid-span deflection.(4) Testes were carried out on a thin-walled concrete box beam presressed with external CFRP tendons to study its short-term performances under uniform load, long-term behaviors under uniform load, and full-time performance under four-point load in turn.

3以体内非预应力钢筋配筋率、体外预应力筋配筋率、体外预应力筋布置形式、预应力度、跨高比、荷载形式等为参数，用非线性分析程序对体预应力筋混凝土梁进行了参数分析，依据分析结果提出了以综合配筋指标和预应力度为参数的等活动房效变形区长度的计算公式，进而提出了基于等效变形区长度的极限挠度计算公式；体内非预应力钢筋屈服前的挠度计算采用常用的部分预应力混凝土梁挠度计算公式；依据试验和非线性数值计算结果，将不同转向块布置形式的体外预应力混凝土梁简化为跨中一个转向块的体外预应力混凝土梁，推导了基于跨中挠度的体外预应力筋应力增量的简化计算公式。

Theorem 2 The product of a bounded function and an infinitesimal is an infinitesimal.

定理 2 有界函数与无穷小的乘积是无穷小。

In this paper, infinitesimal classification is given and theorem condition of equivalent infinitesimal replacement is simplified,thus,this theorem is easy to operate.

对无穷小提出了新的分类法，并对等价无穷小替换定理的条件进行了简化，从而使得该定理应用更加方便。

Although translator has turned from being a crystal ball by which the original culture can unrestrainedly penetrate to another crystal ball by which the target culture can freely traverse, the translator's personal embodiment, in the process of cognitive act, are still absent in translation studies. Translators are still subjects without body or simply disembodied subjects.

译者虽然由原语文化可以自由穿透的玻璃球变成了译语文化可以自由穿越的玻璃球，但译者认知过程中的个体体验在翻译研究中依然缺席，译者依然仅仅是一个没有躯体体验的主体。

Chillingly, he claimed our technology is 'not nearly as sophisticated' as theirs and "had they been hostile", he warned 'we would be been gone by now'.

令人毛骨悚然的，他声称我们的技术是'并不那么复杂，像他们一样，和"如果他们敌意"，他警告说，'我们将现在已经过去了。