查询词典 inclined shaft

The study made a mechanism research on the inclined wire former and summarized the design method and main points of the inclined wire former by the specific properties of pulp and the particularities of inclined wire .

由斜网成形器的纸浆原料特性和斜网的特殊性，对斜网成形器的成形机理进行了分析研究，总结出斜网成形器的设计方法和要点。

Therefore, when the mine geological conditions of the terrain is not conducive to using Adit or inclined shaft, the shaft can be considered pioneering.

因此，当井田的地形地质条件不利于采用平硐或斜井时，对可以考虑采用立井开拓。

A mass rockslide happened while the pilot shaft of penstock No.2 driving through the wide fracture zone of f 20 fault ,and it was difficult to treat because the rockslide area was in the inclined shaft .

2 高压管道上斜段导井在穿越f 20大破碎带时发生特大塌方，因塌穴位于高压管道斜井上，处理难度大。

Pitch circle diameter: d = mz = 3X12 = 36 Tooth crown heights: ha = m (f0 + x)= 3X (l +0.5)= 4.5 Tooth High: hf = m (f0 + cx)= 3X (l +0.25-0.5)= 2.25 Tooth full height: h = ha + hf = 4.5 +2.25 = 6.75 Addendum circle Chemical pumps diameter: Da = d +2 ha = 36 +2 X4.5 = 45 Fixed string tooth thickness: Sxn = m (π/ 2 * cos2a + xsin2a)= 3X (1.387 +0.6428 X0.5)= 5.125 Fixed string of high gear tooth thickness measurement: hxn = m (π/ 8 * sin2a + xsin2a)= 3X (0.7476X0.117X0.5)= 2.42 Modulus coefficient x0.5 m3 O20 ° pressure angle tooth thickness Sxn5.12 fixed string Addendum Coefficient string f1 fixed gear tooth thickness measurement most high hxn2.42 Teeth z12 2, shaft wear and tear maintenance: Axis gear pump wear is mainly because with the support roller shaft at both ends between the friction and wear, so that smaller shaft diameter.

分度圆直径：d=mz=3X12=36 齿顶高：ha=m（f0+x）=3X（l+0.5）=4.5 齿根高：hf=m（f0+c-x）=3X（l+0.25-0.5）=2.25 齿全高：h=ha+hf=4.5+2.25=6.75 齿顶圆直径：Da=d+2ha=36+2X4.5=45 固定弦齿厚：Sxn=m（π/2*cos2a+xsin2a）=3X（1.387+0.6428X0.5）=5.125 固定弦齿厚测量用齿高：hxn=m（π/8*sin2a+xsin2a）=3X（0.7476X0.117X0.5）=2.42 模数m3变位系数x0.5 齿形角o20°固定弦齿厚Sxn5.12 齿顶高系数f1固定弦齿厚测最齿高hxn2.42 齿数z12 2、轴的磨损维修：齿轮泵中轴的磨损主要是因为轴两端与支撑滚针间的摩擦磨损，使轴径变小。

The transverse dynamic stiffness curve of a ship front shaft bracket,and the transverse and longitudinal dynamic stiffness cruves of a back shaft bracket are obtained by means of experiment measurements.Analyses of these curves make the natural frequencies of the shaft brackets available.

采用实验方法对某舰尾轴架进行动刚度测量，得到了前尾轴架的横向动刚度曲线，后尾轴架的横向和纵向动刚度曲线；分析尾轴架的动刚度曲线，可得到尾轴架结构的固有频率。

The bearing part is like fish back instead customary shaft seat and can weigh different shaft load; Using fish back shaped arc surface for bearing load can overcome error brought by shaft bend and horizontal deviation.

承载部位呈鱼背状，取代原来的轴座，可进行各种轴负荷的称重；鱼背状承载弧面可克服轴受载弯曲或安装水平偏差引起的称重误差；改变弧径尺寸可适应不同轴径。

Invisible screen including yam net and competent, spring box, shaft bearings, shaft, the seat of the yarn nets rolls receive composed with ordinary screens, the function, can also according to need to adjust the Windows and screens, when will the opening window open, with the Windows open, yam net block, when open window closes, gauze net in spring rolls receive institutions under the action of elasticity, winding in charge of shaft, does not occupy a space, do not affect the beautiful window glass, switch or concealed or now, convenient installation, is a kind of push-pull window and supporting the use of ideal screens.

隐形纱窗包括纱网及由主管、弹簧盒、轴支座、内轴、端座组成的纱网卷收机构，具有普通纱窗的功能，同时可根据需要调整窗户玻璃与纱窗的开度，当将玻璃窗推开时，纱网随玻璃窗展开，遮拦打开部分，当关上玻璃窗时，纱网在卷收机构弹簧弹力作用下，卷绕于内轴上收藏于主管内，不占空间，不影响窗户的美观，随玻璃窗开关或隐或现，方便装拆，是一种与推拉窗配套使用的理想纱窗。

This paper analyzes the causes of the blockage of the shaft coal bunker ,and puts forward some methods of treating the blockage of shaft coal bunker and some suggestions for the construction of preventing the blockage of shaft coal bunker .

分析了煤矿井下煤仓堵塞发生的原因，提出了煤仓堵塞的处理办法及防止煤仓堵塞的施工建议。

The mathematical model of reliability design for shaft rigidity was established based on reliability inference theory.Reliability calculation of cylinder shaft rigidity of press was proceeded and regularity of cylinder shaft rigidity reliability as the condition change was found.

应用可靠性设计相干理论建立了轴的刚度可靠性设计的数学模型，着重探讨印刷机印刷滚筒轴的刚度可靠度的计算，并得出不同条件下印刷滚筒轴刚度可靠度的变化规律。

Can be seen, no overload is the essence of the centrifugal pump, pump shaft power curve peak, or shaft power with the increase of flow rate changes are small, relatively flat power curve that axis, so that the pump shaft power in the dead lift off to zero head (that is, from zero flow to maximum flow rate) are less than equal to the original context of the supporting motive power.

可见，无过载离心泵的实质是指，泵的轴功率曲线有峰值或轴功率随流量的增加而有较小的变化，即轴功率曲线比较平坦，使泵的轴功率在关死扬程到零扬程范围内都小于等于原动机的配套功率。

We got alerted a couple of times while we were down south that HETs were on the way to bring us back up north because things were going to go hot again, but it was just rumors.

南下的途中我们不只一次得到警告说重型装备运输车将拉着我们重新北上，因为局势正在变得重新紧张起来，但这只是谣传。

It's the one where they find the ghost in the salt mine.

这一集是演他们在盐矿找到鬼