查询词典 inclined shaft

The proposed fault prediction system is successfully applied to the roasting process of a shaft furnace, the fault ratios during production process is decreased, and the proved benefit is achieved.

将所建立的故障预报系统成功应用于竖炉焙烧过程的生产实际中，故障发生率明显降低，取得了显著应用成效。

Silicon carbide bar he-ating elements on both sides of the shaft furnace in the b-rick on the square.

硅碳棒加热元件系竖在炉膛两旁的方形砖上。

The paper introduces the change of structure of materials and influence on the shaft furnace at Pelletizing Plant,analyzing some of the requirements for the structure of materials in pellet production.

介绍南钢球团厂的用料情况及在生产过程中用料结构的变化对竖炉炉况的影响，分析竖炉球团生产对用料结构的一些要求，总结南钢竖炉球团厂在优化用料结构上的经验和调节手段。

In order to settle the difficult problem of deforming and cracking of a shaft furnace's ridge under high-temperature conditions,reform measures were put forward on the basis of an analysis of causes of deforming and cracking of the ridge .

为解决竖炉脊顶高温工矿条件下变形开裂的难题，在对脊顶变形开裂原因进行分析的基础上，提出了改造措施。

Practical operation effect shows that the system is even to distribute, high effective, and provides the basis for realizing high output, low cost and good quality of shaft furnace pellets.

实际的运行效果表明，本系统布料均匀，效率高，为实现竖炉球团的高产、低耗、优质打下基础。

During the reduction process in the shaft furnace, sulphur may move in different directions between the solid raw materials and the reducing gas.

在竖炉直接还原生产海绵铁的过程中，没有熔剂和造渣过程，矿石或球团仅与还原气接触。

Some of important kinetic parameter are obtained by experiments and reaction models. As the countercurrent reactor, the transport phenomena of shaft furnace have close relation with the gas flow.

作为逆流式反应器，竖炉内部的各种传输现象与煤气的流动密切相关，为了了解竖炉内的煤气流状况，建立了缩小的竖炉模型，对竖炉内气体的流动进行实验研究。

Thermodynamic calculation shows that sulphur contained in raw materials in the form of FeS_2 can decompose into FeS in the upper part of the shaft furnace.

一、对竖炉还旅过程中硫行为的一般认识竖炉直接还原的生产实践，推翻了&还原气氛下矿石不可能脱硫&的传统看

Then the technological flow and problems of the drying section which need to solve are discussed in detail. According to the design rules and development process of computer control system, a set of control system for the drying section of shaft furnace pellet plant is designed.

首先在对烘干过程进行机理分析与辨识的基础上进行控制算法设计，系统整体采用串级控制方案，内环温度环采用基于遗传算法参数整定的PID 控制，外环水分环采用模糊控制。

The purpose of shaft furnace reduction is to capture oxygen from iron ore and to produce iron. The experiments of reduce weight is used to measure the reaction ratio of CO and H〓 reduction iron ore.

通过建立一套测反应速率的装置，分别对球团矿、块矿用CO和H〓在不同条件下进行了还原反应动力学实验，建立了单界面动力学反应模型，根据理论分析和实验结果得到了不同原料的反应特性及相应的动力学参数。

Alternatively, the con- trollers can use the synchronous rectifier itself or loss- less inductor current-sensing methods to provide overload protection with lower power dissipation.

另外，康威特罗勒斯可以使用同步整流器本身或亏损减少电感电流检测方法，以提供低功耗过载保护。

Mr. Dauber's other Schatz hangs in his home movie studio.

多伯把沙兹的另一件作品挂在家里的电影室。