查询词典 incidence angle
- 与 incidence angle 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
For FSS used in curve, the use of this method can weaken the sensitivity of the center frequency to angle incidence.
此方法可以应用在曲面FSS上以减小中心频率对角度的敏感性,以球壳上应用的FSS为例,给出了应用模型。
-
Compared with the film produced under the normal incidence, the number of the large particles for films fabricated at the deposition angle of 30° decreases greatly and the nano-particles with better distribution and more uniform particle size are formed after high temperature treatment.
经过高温热处理,相比于垂直沉积的纳米薄膜, 30°倾斜沉积制备的薄膜微观结构中大晶粒的数量显著下降,形成颗粒分布较好的纳米颗粒薄膜。
-
Hence, based on acoustic potential function and boundary condition on solid interface, we get reflection coefficient and refraction coefficient of longitudinal wave and transverse wave on solid-solid interface, and provide approximate formula of the reflection coefficient and the refraction coefficient about the first critical angle of incidence. We analyze relation between the refraction coefficient and acoustic impedance.
为此,基于固体介质的声势函数和界面的边界条件,推导了固-固界面纵横波的反射系数和透射系数,以及第一临界角入射情况下反射系数和透射系数的近似公式,并且分析了透射系数与声阻抗之间的关系。
-
The relation is studied in this paper When the angle between the laser polarized direction and the plane of incidence of laser is zero degree, the amplitude of phot...
本文通过实验研究了在相同的激光入射角的情况下,光声信号的大小随激光偏振方向的变化关系,得出了激光偏振方向与激光入射面的夹角为0 度时,光声信号最强;而其夹角为90 度时,光声信号为极小值。
-
Firstly, full factorial experiment method is implemented to achieve an optimization of longitudinal microstructure design in the incidence plane of a LGP for LED BLUs. There are three control factors involving in the optimization process: the pitch and depth of both V-cut and U-cut, and angle and radius for V-cut and U-cut, respectively. Each individual control factor has three levels. It leads to a total of 27 sets of experiments.
本实验先行讨论全因子实验求取发光二极体背光模组之导光板入光侧纵沟微结构最佳化设计,选定入光侧V-cut纵沟微结构控制因子:V-cut角、V-cut间距、V-cut深及入光侧U-cut纵沟微结构控制因子:U-cut半径、U-cut间距、U-cut深等项目,其中各一因子分别有三个水准变化,依控制因子及其水准的目各进行27组实验。
-
Methods To take an axial view radiograph of patella with patient in sedentary position, the patients' hip joints were kept flexural with 90 degrees naturally and knees flexural between 30 to 80 degrees, then photos were taken by adjusting the angle and point of incidence of the central line.
取坐位投照髌骨,患者髋关节保持自然屈曲90°,屈膝角度范围30°~80°,然后调整中心线的入射角及入射点进行投照。
-
The power transmittance of the two pencils of ray from the polariscope changes with the different angle of incidence .
偏光分束棱镜两出射光束的光强透射比会随入射角的改变而发生变化,为了弄清变化情况,我们利用微机绘制了偏光分束棱镜光强透射比随入射角变化的曲线,并进行了分析,得出了结论。
-
We design the output mirror of monolithic quasi planar ring laser according to the edge filters' polarizing effect in angle of incidence.
利用截止滤光片倾斜使用时的偏振效应,制造了单块式准平面环形激光器的输出镜。
-
This method is to lay the polarizing code of the different polarizing eyepiece angle in the different direction. Then, each direction's optical fiber was coupled into a bunch of optical fibers. After the focusing collimation set of lenses injection solution leaning path of rays, the laser incidence direction was obtained through the judgment circuit analysis.
该方法是通过在不同方向上放置不同起偏角的偏振片编码,再将各个方向的光纤耦合成一束,经准直透镜组射入解偏光路中,通过判断电路分析得到激光入射方向。
-
Then the light intensity transmission of polarizing prisms with the incidence of random spatial light beam is studied. Both experimental and theoretical results indicate that the light intensity transmission of air-spaced polarizing prisms are affected more by the change of random spatial incident angle than dielectric-spaced polarizing prisms.
结果表明:胶合层间的多光束干涉对棱镜光强透射比的影响不可忽略,对于空气隙型偏光棱镜,由于空气隙间多光束干涉的影响,光强透射比随任意角度变化较大,而用胶合介质胶合的棱镜,其透射比对空间入射角不是很敏感。
- 推荐网络例句
-
The split between the two groups can hardly be papered over.
这两个团体间的分歧难以掩饰。
-
This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.
这种做法不仅鼓励了更多的反应,而且减少跟风的可能性。
-
The new PS20 solar power tower collected sunlight through mirrors known as "heliostats" to produce steam that is converted into electricity by a turbine in Sanlucar la Mayor, Spain, Wednesday.
聚光:照片上是建在西班牙桑路卡拉马尤城的一座新型PS20塔式太阳能电站。被称为&日光反射装置&的镜子将太阳光反射到主塔,然后用聚集的热量产生蒸汽进而通过涡轮机转化为电力