查询词典 in the hole

In this paper, with an original designed tool and selected welding parameters, 2024-T4 aluminum alloy sheets were friction stir welded successfully. A series of weld experiments were performed; the microstructure and the mechanical properties of the joints were analyzed. The influences of the welding parameters upon the quality of the joints were studied. The optimized welding parameters window was obtained in which high quality joints can be made and the tensile strength of the optimized joints were more than 80% of that of parent metal. The residual stresses of FSW joints have been investigated by using the Hole-drilling method.

本文自主设计搅拌头，通过选择合适的工艺参数，成功实现了硬铝合金2024-T4板材搅拌摩擦焊接；通过对接头成形和微观组织的研究得到可以实现焊接的工艺参数范围和工艺参数对接头成形的影响规律，并结合接头力学性能研究形成了接头性能与工艺参数之间的关系，并据此建立了优化工艺参数窗口，优化工艺参数下接头的抗拉强度可达到母材的80%以上。

Regrinds in the light the hole edge fin cutting.

再磨光内孔边缘去除毛刺。

Poke a small hole in the center of each puri.

在每个puri 中间戳个小洞。

If as a result of body shell keycap stuck with the key causes of the "key card" failure, may be key in the cap and put a gasket between the pads can be used稍硬some plastic (such as floppy disk jacket abandoned) made, its size is equal to or slightly larger than the key body size, and location by the rod through the ammonium can open a free passage under the square hole, in accordance with its set of poles, the plug cap; use this pad chip cap with the key body to prevent stuck, you can repair button; If as a result of spring fatigue, shrapnel resistance causes large card key failure, then the Special button to open the body, a little stretching to restore flexibility to reset the spring; Remove the key precursor to the resumption of shrapnel.

若是由于键帽与键体外壳卡住的原因造成&卡键&故障，则可在键帽与键体之间放一个垫片，该垫片可用稍硬一些的塑料做成，其大小等于或略大于键体尺寸，并且在按杆通过的位置开一个可使铵杆自由通过的方孔，将其套在按杆上后，插上键帽；用此垫片阻止键帽与键体卡住，即可修复故障按键；若是由于弹簧疲劳，弹片阻力变大的原因造成卡键故障，这时可特键体打开，稍微拉伸复位弹簧使其恢复弹性；取下弹片将键体恢复。

And if you start it on a cautious note you're placing yourself in a hole before the point has even begun.

依靠有力的和可重复的技巧，良好的落点、旋转，你可以改进你的二发使你发挥应有的水平。

And if you start it on a cautious note you're placing yourself in a hole before the point has even begun.

同时如果你发球时缩手缩脚，那你就会把你自己放在一个尴尬的位置。

The wellbore trajectory control is the key and difficult point in slim hole cluster drilling technology.

井眼轨迹控制是小井眼丛式钻井技术的重点和难点，文中探讨了钻具组合、上部井眼曲率、钻井参数以及钻头选型对小井眼轨迹控制的影响，并建立了相应的井眼轨迹控制模式。

Find a plastic bottles, caps and scored two holes drilled in the bottle, two pipettes insert cap hole.

找一个塑料饮料瓶，拿下瓶盖，在瓶盖上钻两个小孔，将两根吸管插入瓶盖孔内。

When I come back,water burn out,and there was a hole in the bottom of the pot.

等我回来时，水都烧干了，壶底烧出了一个窟窿。

Every day, they carved a hole in the orifices, drilled seven days of chaos also died.

他们每天凿出一个孔窍，凿了七天浑沌也就死去了。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。