查询词典 in the groove

A shoulder was removed in whole or in part of the groove-type ball bearing inner ring.

一个肩全部或部分被去掉的沟型球轴承内圈。

In this paper,finite-difference time-domain method was used to calculate the driving-point impedance of radial disk in circular groove guide.

引言圆形槽波导是一种新型波导，和传统波导相比，具有低损耗、高功率容量、低色散和宽频带等优良特性。

The etching technique of the groove is also investigated in depth in this paper.

同时，文章详细描述了这种器件的设计和制造工艺。

A man gets in a groove in New York. It takes the West to put a razor-edge on him.

在纽约，人很容易就会墨守成规，裹足不前。

In normal rat embryos, on gestational days 14.5 to 15, cellular apoptosis takes place in the tail groove and dorsal cloacal membrane which makes anal membrane rupture, and then rectum exposes to outside.

正常胎鼠在胎龄14.5天-15天时，尾沟、背侧泄殖腔膜处出现大量的细胞凋亡，使肛膜破裂，直肠与外界相通。

As indicated in the section on simple machines,a screw acts with a wedging action and consists of a circular cylinderwith a helical groove in it.

如在简单的机器上的区段所指出的，一个螺丝钉以一个楔住行动行事而且有圆形圆筒与一螺旋状的在它里面的凹槽。

Cracks have been found in the flange and web splices at groove welds in at least four bridges.

至少在四座桥梁的翼缘板和腹板拼接坡口焊缝中发现了裂纹。

A shoulder was removed in whole or in part of the groove-type ball bearing outer ring.

一个肩全部或部分被去掉的沟型球轴承外圈。

Yun-strip method, the circle-shaped bath temperature higher than the crescent-shaped article transport transport of temperature, the temperature was higher than the crescent-shaped article transport serrated Article transported bath temperature, in the 12mm flat bottom welded seal, using serrated transport of , and with the magnitude and the swinging groove on both sides of the pause, effective control of the bath temperature, so that pore size of the melt is essentially consistent with the roots do not form a welding groove tumor and decrease the chances of burn-through, no penetration has The improvement of the peace panels of the single-sided welding butt welding flat-sided shape is no longer difficult.

运条方法，圆圈形运条熔池温度高于月牙形运条温度，月牙形运条温度又高于锯齿形运条的熔池温度，在12mm平焊封底层，采用锯齿形运条，并且用摆动的幅度和在坡口两侧的停顿，有效的控制了熔池温度，使熔孔大小基本一致，坡口根部未形成焊瘤和烧穿的机率有所下降，未焊透有所改善，使乎板对接平焊的单面焊接双面成形不再是难点。

This paper presents a method, which uses the vortex sensor for gathering location signals of the narrow groove. In terms of the symmetrical characteristic of the edge of the signal, the paper adopts "reverse sequence cross correlation" method,i.e. cross correl ation analysis between the reverse sequence and original signals. This method makes full use of all the process of the signals, filtrating the stochastic signals, and can precisely locates the center of the groove.

文中采用了电涡流传感器来采集窄槽的位置信号，利用信号边沿部分对称的特点，采用了&倒序列相关&的方法，即用倒序信号与原信号进行互相关分析，充分利用了信号的全过程，滤除了信号中的随机成分，精确地求得窄槽的中心位置。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失