查询词典 in shock

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

It is found that the time required for the shock formation can be affected by the initial plasma temperature, which influences the energetic proton generation in the shock.

观察到不同的等离子体初始温度会影响靶前激波的产生时间，进而影响质子产额。

Methods:The diagnostic accuracy for severe PPH by the measuring amount of blood loss was compared with shock index or measuring of blood loss combined with shock index in 69 cases.

结果 ：测定出血量和休克指数的符合率分别为 5 9 42 %和 6 9 5 6 %，均显著低于测定出血量结合休克指数的 89 6 8%(P 0 1)。

The several kinds of Ag-NiFe2O4 cermets with different mass percent of Ag have prepared. Microstructural changes were observed by scanning electronic microscope and composition was determined with x-ray detector. Effect of different content of Ag on the density, property of thermal shock,conductivity and corrodent rate were tested. The results showed that the thermal shock performance and conductivity have improved in company with the addition of content of Ag.

制备了不同金属Ag含量的Ag-NiFe2O4金属陶瓷，利用扫描电子显微镜观察显微组织，由X射线衍射分析化学成分，研究了Ag的添加量对其体积密度、气孔率、热震性、导电率以及腐蚀速率的影响，试验结果表明，抗热震性和导电能力随着Ag含量的增加而增强，导电率的提高和腐蚀率的增大仍是一对突出的矛盾。

Hard work in time to avoid the shock of it, because the distance between head and disk very close to, if clustering was head of the shock will lead to knock disk may be scratched disk heads, but also may lead to the total head count of the bad, the entire hard disk can not be used.

在硬盘工作的时候要尽量避免它的震荡，因为，磁头与磁片的距离非常近，如果遭到聚类的震荡会导致磁头敲打磁片，有可能磁头会划伤磁片，也可能会导致磁头的彻底算坏，使整个硬盘无法使用。

Storm Earth and Fire - Your Frost Shock has a 5/10/15/20/25% chance to root the target in frozen ice for 2 sec, your EarthShock's range is increased by 1/2/3/4/5 yards, and the periodic damage done by your Flame Shock is increased by2

土产霹雳火-你的霜震增加 5/10/15/20/25%用冰霜把敌人种在地上2秒，你的地震增加1/2/3/4/5码，你的火震持续时间增加20/40/60/80/100%需要45点投入。

Objective To observe the efficence of the anti-shock-traussers in 266 cases of acute traumatic hemorrhagic shock.

目的 观察使用抗休克裤的效果。

The cold-shock treatment with ozonated water (ozone concentration 2 mg/L, dipping 5 min in the 1 ± 1 ℃cold water) reduced quantities of bacteria and funguses of winter-jujube, and decreased the rate of loss weight, and extended shelf-life of the fruit. By the ultrastructures of winter-jujube pericarp, cold-shock treatment with ozonated water could clean out the waxiness of crackle and lenticel, which is helpful for exchange of fruit internal CO2 and air, and inhibit accumulating of ethanol concentration.

臭氧水冷激处理(臭氧浓度为2mg/L，浸泡时间5min，水温1±1℃)可以明显降低冬枣表面细菌和真菌的数量，减少失重率，延缓冬枣硬度的下降，提高冬枣的货架期；从微观结构观察发现，臭氧水冷激处理可以清洗冬枣表皮裂缝和皮孔的蜡质，有助于枣果内部CO_2气体的排逸，从而延缓了冬枣的酒化；此外，冷激处理可以明显降低冬枣表面残留的农药：如马拉硫磷、氯氰菊酯和溴氰菊酯农药的含量，提高枣果的食用安全性。

AG-707 (recombinant heat shock protein 70 polyvalent peptide complex) is a heat shock protein–based vaccine that is designed to activate the immune system to target HSV-2 infection in a broad population of patients.

银707 （重组热休克蛋白70多肽复合物）是一种热休克蛋白为基础的疫苗是专为激活免疫系统的目标，单纯疱疹病毒2型感染，在一个广泛的人口的病人。

Four markets all are affected by negative shock of unexpected component of monetary policy, but in term of the relation between stock return and positive shock of expected component of monetary policy, we can not obtain a significant result.

我们得出的实证结论是：在我国股市发展初期噪声交易假说成立，投资者的噪声交易行为能够解释市场在开始阶段对利好信息敏感，对利空消息冷淡的非对称反应特征。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。