查询词典 in rotation

The CD230 of product mixture was positive and negative in the clockwise and anticlockwise rotation,respectively, and the effect was dependent on the rotation speed.

结果表明离心力场能够诱导产物的对映体过量，在顺时针和逆时针旋转力场中得到的产物CD230信号相反并随转速的增大而增大。

We analyze the effect of approximate velocity in the formula of the rotation of the gravity potential, which is caused by the Earth rotation.

分析了地球自转引起的位旋转效应公式中采用近似速度的影响。

Experimental study of stress-strain relationship of normally consolidated intact soft clay in Hangzhou under undrained fixed shear of principal stress direction and monotonic rotation of principal stress axis had been done, which was used to reflect the soil properties response to the monotonic rotation of principal stress axis under real engineering conditions.

为反映真实工程条件下主应力轴旋转应力路径引起土体性状的变化，对杭州地区正常固结原状软黏土在固结不排水的主应力轴定向剪切和主应力轴单调旋转条件下的应力-应变关系进行试验研究。

The element equations are derived in a fixed current element coordinates which are coincident with the current moving element coordinates. The perturbed moving element coordinates and the variation of the element nodal rotation parameters corresponding to the perturbation of element nodal displacements and rotations referred to the current fixed element coordinates is consistently determined using the first order linearization of the way used to determine the current element coordinates and element nodal rotation parameters corresponding to the incremental element nodal displacements and rotations referred to the global coordinates.

本研究在梁元素当前的变形位置上，利用元素节点的座标及断面方位建立一个移动元素座标并决定元素节点的旋转参数，对应於元素节点旋转参数扰动量的广义节点力为一广义力矩，为推导传统力和力矩与该广义力矩的关系，本研究在一个与当前的移动元素座标重合的固定元素座标上，推导出元素节点在当前固定元素座标的扰动位移和扰动旋转与元素节点旋转参数的扰动量的关系。

Rotation, store the data in the matrix as an axis/angle and do the conversions yourself or will need to convert it to a quaternion.A quaternion is composed of four components: a vector with x, y, z coordinates and a w rotation.

当用一个四元数乘以一个向量时，实际上就是让该向量围绕着这个四元数所描述的旋转轴，转动这个四元数所描述的角度而得到的向量。

In order to investigate the coupling characteristics between elastic deflections and rigid motions of the blades, the moderate deflection beam model was adopted to treat elastic deflections and two methods were adopted to treat rigid motions based on infinitesimal rotation and finite rotation.

为了研究桨叶刚柔耦合特性，采用中等变形梁模型处理桨叶弹性变形，分别采用小转角和有限转角两种方法处理桨叶绕铰的刚性运动。

The particles in the shear band demonstrate significant rotation. Higher gradients are found in velocity and rotation fields on the edge of the shear band.

通过转动场和速度场的分析可知，剪切带宽度约为10～15倍的砂土平均粒径，带内颗粒转动明显，带边缘出现大的速度和转动变化梯度。

For the variation of short period of astronomical factors, whether for local time or local sidereal time and lunar phase there is the phenomenon of occurrence of concentrating a interval time for the earthquakes. For the short variation of earth rotation this phenomenon is clear; either the earthquakes occur in most fast or in lowst of earth rotation.

对于天文因素的短周期变化，无论是对于地方时，地方恒星时与月相，都有集中发生在某一段时间的现象；对于地球自转的短周期变化更是比较明显，要么发生在其变化最快时期，要么发生在其变化的最慢时期。

Quaternions extend the concept of rotation in three dimensions to rotation in four dimensions.

四元数将三维中旋转的概念扩展到四维中的旋转。

The results show that the plasticity zone and dynamically quiescent layer become fine equiaxed recrystallisation under the thermo-mechanical effect, the grains in the heat-affected zone grow up because of the effect of friction heat. When the rotation speed is 2 500 r/min and the welding time is 12 s, good joint is achieved, and the tensile shear strength of the joint reaches 9.24 kN. The tensile shear strength of spot increases with increasing tool rotation speed, with increasing welding time, the strength increases first, while then reduces. The microhardness of plasticity zone is high, but is slightly lower than that of the base metal, the minimum value of microhardness is in the heat affected zone. When the energy input of joint is high, the fracture type of spot is mode Ⅰ, and the tensile shear strength is high; on the contrary, when the energy input of joint is less the fracture type of spot is mode Ⅱ, and the strength is low.

结果表明：塑性区和动态静止层的晶粒在热和力作用下发生动态再结晶形成细小的等轴晶，热影响区的晶粒在摩擦热作用下长大变粗；搅拌头旋转速度为2 500 r/min，焊接时间为12 s时，可以获得力学性能较好的焊点，焊点的剪切强度达到9.24 kN；焊点的剪切强度随搅拌头旋转速度的增大而增大，随焊接时间的延长先增大后减小；塑性区的显微硬度较高，但略小于母材，接头显微硬度的最小值分布在热影响区；焊点热输入量较多时，接头为Ⅰ型断裂，焊点的剪切强度较高；焊点热输入量较少时，接头为Ⅱ型断裂，焊点的强度较低。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。