查询词典 in force

Therefore, the torque required to open the gate valve required torque than the closure of large, in addition, for a pair of contact between the sealing surface, the Non Rising Stem Resilient Seated Gate Valves coefficient of static friction between them than the dynamic friction coefficient, to make them from the static state generate the relative movement is required to exert greater force to overcome the static friction; due to temperature changes, so that the sealing surface pressure between the larger, need to overcome the static friction force also will be bigger, so that when you open the valve on the stem nut on the sometimes increase the torque exerted a lot.

所以，开启闸阀所需的力矩比关闭闸阀所需的力矩大，此外，对于一对互相接触的密封面来说，它们之间的静摩擦系数也比动摩擦系数大，要使它们从静止状态产生相对运动，需施加较大的力以克服静摩擦力；由于温度变化，使密封面间的压力变大，需要克服的静摩擦力也随之变大，从而使开启闸阀时，对阀杆螺母上施加的力矩有时会增大很多。" Moment analysis of valve operation "是由中国闸阀网提供的国际阀门新闻，译文仅供参考。另外，中国闸阀网还提供相关产品搜索：闸阀型号、闸阀价格、闸阀技术、闸阀新闻、闸阀生产商等。

Close the valve, the need to open and close with the Coma Berenices two pieces of the sealing surface of the seal formed between certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread between the stem end bearing at and other friction parts of the friction, and therefore must apply the closing force and closing a certain moment, the valve in the open and close the process, the required hoisting hoisting force and moment of change, and its maximum is close to the final instant or open the initial transient.

关闭阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

Close the valve, the need to open and close with the Coma Berenices two pieces of the sealing surface of the seal formed between certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread Automatic Control Valves between the stem end bearing at and other friction parts of the friction, and therefore must apply the closing force and closing a certain moment, the valve in the open and close the process, the required hoisting hoisting force and moment of change, and its maximum is close to the final instant or open the initial transient.

关闭阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

In this paper, the waved-edge force model is deduced on the basis of straight edge force model by use of the curve integral principle. This method is suited to the case for the complex 3-D grooves of random curve edge.

在直线刃铣刀片模型的基础上，利用曲线积分原理，建立了波形刃铣刀片铣削力数学模型，该方法可适用于任意曲线刃的三维复杂槽型的情况。

Police college students, the probationary police, are an important component of police force and the vital new force to construct a safe society in the future.

警察院校学生是预备警官，是人民警察的重要组成部分，是未来建设平安社会的生力军。

Numerical method is used to investigate the bogie's ateral stability under diverse nonlinear factors. The influence of nonlinearities and conicity on the critical speed is investigated. The nonlinear forces considered in the bogie system include creep-force between the rail and wheel, longitudinal damping and the flange contact force.

利用数值方法研究了不同非线性力作用下转向架的横向稳定性，得到轮轨饱和力、蠕滑力、纵、横向阻尼力、轮缘死区接触力、踏面斜率以及轮轨间隙对转向架系统线性、非线性临界速度的影响规律。

The structure feature of the sensor was described in comparison with the classical Stewart platform-based six-component force sensor.By using the finite element method,the elastic dynamics theoretical model of the sensor was established based on the conditions of displacement consistency and force balance.According to this model,the numerical analysis was carried out,and the variety relationship curves between the natural frequencies and the structural parameters are plotted.

描述了该传感器相对于经典Stewart平台六维力传感器所具有的结构特点；利用有限元法，采用位移协调和力平衡条件建立了传感器弹性动力学理论模型，依此模型进行数值分析，绘制了固有频率与各结构参数间变化关系曲线；并利用ANSYS软件建立了传感器有限元模型，进行了振动模态分析，得到其固有频率和振型。

The research put emphasis onto actual application in constant force hanger on the basis of the research of constant force hanger structure and optimized design theory and MATLAB heredity calculation.

本课题研究了恒力吊架结构，优化设计理论和MATLAB遗传算法在恒力吊架设计中的具体应用。

In the numerical simulation, the forming force is the contact force.

在数值分析中成形力即为接触界面的作用力。

In the analysis of sea ice dynamics, the drag forces, internal ice force, Coriolis' force and ocean tilt effect were calculated and contrasted.

在海冰漂移的动力要素分析中，本文对海冰的风和流拖曳力、海冰内力、科氏力和海面倾斜力等动力要素进行了讨论和对比。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。