查询词典 in force

Geometrical and physical parameters of components of the absorber in the virtual prototype follow from those technical data of a specific passenger car. Bench tests are conducted and a series of experimental results have been obtained by the MTS absorber test machine for the damping force-velocity which can be imposed in the virtual prototype for dynamic simulation. The piecewise, the hysteretic looped and the abnormal looped hysteretic force-velocity curves for the absorbers are, respectively, input into the prototype.

减振器阻尼力—速度特性是根据MTS减振器特性试验机试验结果，通过分段拟合，分别以分段线性、迟滞环和迟滞环畸变情况输入虚拟样机进行仿真分析，试验及仿真结果比较说明：减振器速度外特性采用迟滞环非线性，比采用双线性化模型更接近试验结果，能够更合理地解释试验现象；减振器阻尼力速度特性曲线出现畸变，如在复原行程初期迟滞特性曲线出现交叉现象，可以引发减振器系统动力特性的高频振动成分增加。

First, the angular velocity function and maneuver load for certain maneuver flight (including hover, dive-hike and these two combined) are set up. The simulation results of the vibration of double-disk rotor system with cantilever supported on rigid bearings show that rotor would be apparently deformed under maneuver load. Second, the performance of oil force of SFD in maneuver flight is analyzed. The results show that in maneuver flight, the SFD with centering spring will become eccentric and its oil force will be time-related and offset-related.

首先，建立了水平盘旋、俯冲拉起及盘旋+俯冲拉起复合机动三种机动飞行条件下的机动角速度函数，并确定了对应机动飞行条件下的机动附加载荷（附加离心力和附加陀螺力矩），分析了带刚支的双盘悬臂转子系统在机动飞行条件下的振动特性，发现发动机转子在机动飞行时会发生明显变形；随后，分析了非定心挤压油膜阻尼器的油膜力特性，机动飞行时，油膜轴颈在机动附加载荷的作用下偏离外环中心，使得带定心弹支的挤压油膜阻尼器也变成了非定心挤压油膜阻尼器，其非定心挤压油膜力是瞬态时变的，并且与SFD油膜轴颈偏移量和进动形态有关；然后，在经典的Jeffcott转子系统中引入带定心弹支的挤压油膜阻尼器，分析了机动飞行时非线性转子系统的振动特性，发现挤压油膜阻尼器油膜力的非协调特性也反映到转子系统的振动响应中；之后，对机动飞行条件下带挤压油膜阻尼器的双盘悬臂转子系统的振动特性进行了分析，并重点分析、总结了俯冲拉起机动飞行时，系统结构参数和工作状态参数（转速比、机动飞行半径、机动角速度等）对该系统振动特性的影响。

Social influence here is an external force that, like the deists' God, sets things in motion and has no further effects--a force that insinuates itself into the minds and bodies of individuals (as in the movie Invasion of the Body Snatchers), altering their way of making decisions.

因为他们已经被完全社会化了。

In this paper, based on the manipulability measure ellipsoids, the velocity and force directional manipulability measure of redundant robot was defined and the measure method of the velocity and force transmission characteristics was given in special direction under a designated posture.

在速度和力可操作椭球的基础上，定义了冗余度机器人机构速度和力方向的可操作度。

Based on the characteristics and the demands of synchronization, a single nero forecast controller was presented, which was designed to eliminate synchronization error of upset force in flash butt welding. A press feedback loop was designed to solve the problem that it is uneasy to assemble force sensor in flash butt welding.

针对于大截面钢坯闪光焊顶锻阶段的特点和同步要求，提出了一种基于单神经元的同步误差预测控制方案，用于消除闪光焊顶锻过程中的系统之间顶锻力的同步误差；方案中采用液压系统压力反馈的方法解决了闪光焊中不方便安装里传感器的问题。

The fusion of trend part of force and current is used as a standard curve in the total process control in ECM.by using a BP Neural Network to mapping the fusion of force and current and the feed position.

用神经网络建立数显进给位置与力和电流融合信号之间的非线性映射，使它作为标准曲线用于对间隙进行自动的全程控制。

In order to realize nano feeding under large feeding force, according to the research state of nano feeding device and development tendency all over the world, combing with china "863" Program "the key technic research of nano precision drive parts having large feeding force", a scheme of nano precision drive parts with bilateral symmetrical structure using in quasi-static state conditions is proposed, the nano precision thermal drive parts are developed and the experimental system is established.

为了实现具有进给力的纳米级进给，根据国内外纳米级驱动部件的研究现状及发展趋势，结合国家&863&高科技计划资助项目&具有大进给力的纳米级驱动部件关键技术的研究&，本文首次提出一种在准静态条件下使用的具有双边对称结构的纳米级热驱动部件设计方案，并且研制纳米级热驱动部件及试验系统。

Based on the 70 axial force monitoring data on 64 manometers in south tower piles foundation of JiangYin Bridge, the force transferring mechanism of socketed pile group using friction ineffective treatment at the top 20 meters was analyzed. The surcharge problem, the course of stress adjustment and the transition of the slip surface on which was easiest to slide in pile group were discovered.

根据江阴大桥南塔墩基桩轴力64个测点的70次观测成果，分析了桩周摩擦失效嵌岩群桩的传力机理，揭示了群桩中的超载问题和应力调整过程以及最不利滑面的迁移；采用理论计算、定性评价和数值分析相结合的方法首次建立了基桩轴力安全监控模型。

There are almost three months of ice period in the Bohai Sea, and the ice force is more powerful than the force of wave on the structure in winter.

我国渤海每年约有3个月的结冰期，冰与海洋结构的相互作用远较波浪为甚，因此有必要进行冰与海洋结构相互作用的可靠性分析。

The excitation sources of vibration in a in-line 4-cylinder engine include second-order inertia force induced by piston reciprocating movement and rolling moment caused by the side force exerted on cylinder.

四缸发动机的主要激振源为活塞往复运动产生的往复惯性力和气缸承受的侧压力产生的倾覆力矩。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。