查询词典 in condition

This paper mainly studies effect and influence factor that typical corrosive medium (muriatic acid, vitriol, nitric acid, sodium hydroxide, sodium chloride etc.), consistence and condition temperature acts on the material coated on castiron centrifugal interface (PFEP, PPS, CPE, remodeled epoxy). It is studied that powder electrostatic spray, suspend fluid spray, suspend fluid electrophoresis underside coat etc. technics influences on coat quality coated with above four anticorrosive material. The property analysis is done that above four anticorrosive material and three coat technics adapt to centrifugal pump frame and running dynamic condition. In addition, the effect is introduced that castiron centrifugal coated anticorrosive material is used in coal water with alum.

本文侧重研究了典型腐蚀工作介质盐酸、硫酸、硝酸、氢氧化钠碱、氯化钠盐等品种、浓度、环境温度，对铸铁离心泵过流面的聚全氟乙丙烯、改性聚苯硫醚、改性氯化聚醚、改性环氧四种防腐涂层材料的试验使用效果和影响因素分析；研究了四种涂层材料粉末静电喷涂、悬浮液喷涂、悬浮液电泳底涂等涂装方法工艺对涂层质量的影响；四种涂层材料和三种涂装方法对离心泵结构和运行动态环境的适应性分析；介绍了铸铁离心泵防腐涂层在煤矿矾水中的应用效果。

The nodal Green's function methods based on the Neumann boundary condition (the second kind boundary condition) in Cartesian geometry is developed and evaluated in this thesis.

本论文发展了Neumann边界条件格林函数节块法NNGFM，并根据先进的组件均匀化技术-广义等效均匀化理论〓引入不连续因子，消除组件均匀化带来的误差，大大提高计算精度。

Since the solutions of this problem are the critical points of the associated energy function. One generally needs some compactness such as PScondition or C-condition to prove the existence of critical points of the energy func-tion, but when we study the elliptic equation in R~N, the compactness condition does not always hold since the imbedding of the Sobolev space H_0~(1,2)into L~(2*) is not compact. In this chapter, based on the nonsmooth critical point theory, and by using the approximation technique with periodic function, the existence of nontrivial solution is obtained.

由于该方程的解就是其所对应的能量泛函的临界点，通常都要在一些紧型条件的基础上来证明其所对应的能量泛函临界点的存在性，但当我们在无界域上考虑该椭圆方程解的存在性时，Sobolev空间H_0~(1，2)到L~(2*)的嵌入非紧，从而导致所对应的能量泛函失去紧性，本章在非光滑临界点理论的基础上，应用周期逼近的方法证明该问题非平凡解的存在性。

As pairs of connected ramets were subjected to reciprocal patchiness of light and nutrients, stolon connection between the two ramets significantly enhanced biomass of both ramet growing in low light intensity but high soil nutrient condition and ramet growing in high light intensity but low soil nutrient condition as well as whole ramet pairs (consisting of LH ramets and HL ramets).

当生长于高光照低养分条件下分株与生长于低光照高养分条件下分株之间的匍匐茎连接时， 3种克隆植物HL分株、LH分株以及整个分株对系统(HL分株+ LH分株)的生物量均得到显著提高。同时， LH分株根冠比显著增加，而HL分株根冠比显著下降。

From the result analysis we can find the activities, discussion and presentation, can inspire children thinking and increase their awareness. We can get better result from intermediate achievers. Besides, the perceptibility of low achievers can achieve steady first-order condition after discussing and testing in class, meanwhile, they can utilize the perceptibility in second-order condition.

其中发现，讨论与发表活动确能激发儿童思考、增进察觉，而以中成就组学童最能展现；另外，低成就组学童的察觉能力则由教学讨论和教学后测验的基础层次提升到延后测较稳固的一阶层次，也渐能使用二阶层次察觉能力。

The formula was established about calculating design parameters and technological parameters of ideal strip and bent strip in the period of forming. The thesis presented how to calculate the deformed area length and contact are radius of contact deforming between two elastic bodies on condition of the friction. The calculating formula of pinch force about plate-strip pinch mill was given and the results were analyzed that friction coefficient and radius of pinch rolls are very important for determining pinch force. Moreover, the rule of deforming and stress distribution of different 〓 ratio were gained on condition that the deforming was considered to be non-uniform distribution in the gap. The differential equations were got that calculate the displacements of large deflection of elastic cantilever rectangle plate with fixed end and the formula of the Finite Strip Method was conducted to study the regularity of mid-plane displacements, deformation and stresses for elastic-plastic large deflection bend of cantilever parallelogram plate with fixed or slidable end by integrating Prandtl-Reuss equation.

建立了一套完整的设计参数计算公式和在成型过程中理想带钢或具有月牙弯带钢的工艺参数的调整公式；在考虑摩擦力的条件下，对两弹性体接触变形过程中的接触变形区长度和接触弧半径用位移解法进行了研究，推导了板带递送机的递送力计算公式，从而得知在递送机设计过程中，应选择适当摩擦系数和辊身直径；另外，还从辊缝内带钢实际变形出发，分析了对于不同的〓值，带钢的变形规律及应力分布状况；建立了固定端悬臂矩形板弹性大挠度弯曲变形的控制方程，并且在对Prandtl-Reuss方程的积分处理的基础上，导出了固定端和滑动端悬臂平行四边形薄板的弹塑性大挠度的中面伸展位移、变形和应力的有限条元法公式，编写了Fortran语言计算程序，在各种参数条件下，对螺旋焊管成型过程变形规律进行了全面的分析研究，从而为螺旋焊管的生产和进一步的改进提供了理论依据。

The result showed that the optimal condition of inorgano-absorbent manufacture as following: concentration of vitriol is 15%, the bentonite carrier must be soaked in the 0.4% La(superscript 3+) solution, the pH is 10, microwave radiation power is 340 W for 5 min. The optimal condition of organo-absorbent manufacture process as following: concentration of CTMA is 5%. The rate of wave must 166 W and the time of radiation is 6 mi In addition, the experimental results showed that with inorgano-absorbent the pH number is 3~6 and the reaction time is 45 min, the removal efficiency of phosphor will be up to 99% and the amount of adsorption will be up to 41 mg/g. And with organo-absorbent the pH number is 3~4 and the reaction time is 45 min, the removal efficiency of phosphor is more 30% than that of inorgano-absorbent. The removal efficiency of phosphor will be up to 99% and the number of adsorption will be up to 60 mg/g.

实验表明：①制备无机稀土吸附剂的适宜条件为：硫酸浓度15%，镧浓度0.4%，浸渍pH值10，微波功率340 W，辐射时间为5 min；②制备有机稀土吸附剂的适宜条件为：表面活性剂浸泡浓度为5%，微波功率为166 W，微波辐射时间为6 min；③无机稀土吸附剂当溶液的pH值为3~6，振荡时间为45 min时，对磷去除率为99%以上，吸附量达到了41 mg/g以上，有机稀土吸附剂当溶液的pH为3~4，振荡时间为45 min时，其效果比原来镧改性的无机吸附剂吸附量提高了30%，磷去除率为99%以上，吸附量达到了60 mg/g以上。

Morphological and anatomical observationsshowed that the pol CMS plants in DGCMS-Yi-3A were complete sterile and hadno pollen sac differention at higher temperature condition,and were partialsterile and had 1-3 pollen sacs in each anther at lower temperature condition.

花器形态和花药发育的解剖观察表明，DGCMS-宜3A中表现波里马细胞质雄性不育的植株在高温条件下表现为彻底雄性不育，无花粉囊的分化；在低温条件下，表现部分雄性不育，可分化出1-3个花粉囊，产生少量可育花粉。

The RGCMSplants in RGCMS-117A or S45A were complete male sterile at the bothtemperature conditions,and there was no pollen sac differentiation at thehigher temperature condition and there were 1-3 pollen sacs in each anther atthe lower temperature condition,but the anther development was inhibited atthe stage of microspore.

表现核质不育的植株，在高温条件下表现彻底波里马细胞质雄性不育，无花粉囊分化；在低温条件下，也表现彻底雄性不育，具核、质不育的共同特点，每个花药可分化出1-3个花粉囊，但无可育花粉，其雄性败育时期和特点与S45A和117A相同。

Based on Pontryagin maximum principle, the lunar soft landing problem is transformed into a two-point boundary value problem in mathematics. In consideration of the bound condition and transversality condition, the resulted two-point boundary value problem is converted into a parameter optimization problem aiming at the initial values of conjugate variables and the terminal time, then it is solved by the nonlinear programming.

首先，从庞德里亚金极大值原理出发，将有限推力作用下月球软着陆问题转化为数学上的两点边值问题；在考虑边界条件及横截条件的前提下，将该两点边值问题转化为针对共轭变量初值和末时刻的优化问题；然后应用非线性规划方法求解所形成的参数优化问题。

She gently rebuff ed him, but agreed that they could be friends

她婉言拒绝了，但同意作为朋友相处。

If in the penal farm, you were sure to be criticized.

要是在劳改农场，你等着挨绳子吧！