英语人>网络例句>in condition 相关的网络例句
in condition相关的网络例句

查询词典 in condition

与 in condition 相关的网络例句 [注:此内容来源于网络,仅供参考]

The full space calculation model, which suits for the asymmetric structure sometimes even including air below the surface of medium, can enable simulative result to approach real one. The FDTD algorithm based on the mixed ABCs is proper to calculate the transmission line where the electromagnetic wave is transmitted in order to send electromagnetic energy along central conductor. The calculation efficiency will be raised if the PML absorbing boundary condition is set on both planes of transmitting direction and so is the MUR two-order absorbing boundary condition in the other planes.

全空间计算模型是适合所有的不对称结构的待研究体的,而且包括了介质下面的空气部分,使仿真更加的接近实验真实情况;基于MUR-PML混合吸收边界条件的时域有限差分法非常适合计算传输线这种结构,因为传输线是传送电磁波的,电磁能量主要是沿着中心导带行进,因此在两个传输端面上设置PML完全匹配层吸收边界条件,在其他面上设置MUR二阶吸收边界条件,会大大提高计算效率,而且计算结果与XFDTD仿真软件计算结果相比较,基本趋于一致。

The third order nonlinear optical refractive index and nonlinear absorption coefficient are enhanced due to the quantum confinement effects and estimated to be 4×10 -12 m 2/W and 2×10 -5 m/W respectively in nonresonant condition,while 2×10 -11 m 2/W and -1×10 -4 m/W respectively in quasi resonant condition.

结果表明,薄膜的三阶光学非线性折射率系数和非线性吸收系数都由于量子限制效应而大大地增强,在非共振条件下,它们分别约为 4× 10 - 1 2 m2 / W和 2× 10 - 5m/ W,在准共振的条件下,它们分别约为 2× 10 - 1 1 m2 / W和- 1× 10 - 4m/ W。

Most of the AMT researches are carried out in the condition of high adhesion, few of them is done in low adhesion condition.

现有的AMT研究大部分是在高附的条件下进行的,少有针对低附情况控制方法的研究。

Evidence suggests that 1 under more stable stratification, the basic flow, if moving faster at low and high levels (particularly in the presence of jets there), allows a resulting meso-β unsteady wave to propagate eastward with respect to basic flow and even at greater velocity compared with it; 2 vertical windspeed shear of basic flow causes instabilities of the TWT perturbation; 3 considering the second derivative of basic-flow wind with respect to z (denoted by zz≠ 0 which is simply given as β* hereafter) the expression for the phase velocity of vortex Rossby wave is obtained, which is unidirectional in propagation with respect to basic flow; 4 VRoW has its physical origin from β*, i.e., from z-varying heterogeneities of y-direction averaged vorticity of the basic flow field; 5 VRoW phase velocity is associated with zonal wave number k, its energy is dispersive and the group velocity exists in the x direction; 6 when windspeed meets the condition of β*, TWT disturbance instability may be that of mixed VRoW and gravity wave; 7 if basic flow is subject to linear shear but does not meet the condition of β*, the TWT instability is that of inertia-gravity wave.

在大气层结比较稳定的情况下,如果基本气流在低层和高层较大(有可能存在低空急流和高空急流),此时产生的β中尺度不稳定扰动相对于基流向东传播,甚至于快速向东传播。基本气流在垂直方向上的风速切变对于中尺度横波型的扰动起着不稳定的作用。如果考虑基流的二次切变,可以得到涡旋Rossby波的相速度表达式,涡旋Rossby波相对于基本气流是单向传播的。涡旋Rossby波产生的物理根源是基本流场的风速二次切变,亦即基本流场y方向的平均涡度在空间z方向上的不均匀所致。涡旋Rossby波的相速度与纬向波数也有关,它的能量是频散的,其在纬向x方向也存在群速度。在基本流场的风速存在二次切变时,横波型不稳定可能是混合的涡旋Rossby重力波的不稳定;而在基本流场的风速仅仅存在线性切变,不存在二次切变时,横波型扰动的不稳定则是重力惯性波的不稳定。

A any stocks of the Products in saleable condition and in the possession of Distributor, shall be forthwith held to the order of Supplier and any such Products which have been paid for in full by Distributor shall be resold by Distributor to Supplier or such person as Supplier shall specify at , due allowance being made for old stock and any out of condition or unsaleable Products

a 可供销售并由经销商占有的任何库存产品,应由经销商替供应商占有,已由经销商全额付款的经销产品应当由经销商转售给供应商或者供应商所指定之人,对陈旧的存货、保存不当的经销产品或不能销售的经销产品在价格上应予以适当扣除;且

From black song fungi with produce the Ruan false silk yeast fungus to constitutePass to design single factor and was hand over to experiment to make sure KB and H Ruan hybrid the fungi ferment of the best condition, test result enunciation:The KB is in N source 5%, anticipate water to compare 1:2, inoculate to compare 1:1, inoculate to measure 20%, pH to be worth 3.5, ferment time for 5 days, ferment to connect to go in to inoculate to measure to 20% H Ruans to mix the germ stub as hybrid fungi on the 3rd day the best ferment a condition, in that case, the Chinese herbal medicine residue true egg white content after ferment is 17.26%, true egg white growth rate is 82.39;The thick fiber content is 26.09% and decline the solution rate is 14.54%.

通过设计单因子以及正交试验确定了KB及H朊混合真菌发酵的最佳条件,实验结果表明:KB在N源5%、料水比1:2、接种比1:1、接种量20%、pH值3.5、发酵时间5天,发酵第3天接入接种量为20%的H朊混合菌株为混合真菌最佳发酵条件,在该条件下,经过发酵后的中药渣真蛋白含量为17.26%,真蛋白增长率为82.39;粗纤维含量为26.09%,降解率为14.54%。

As applications of the method, the linear wave making problems of Wigley hull and Series 60 hull are solved, with less collocation-points than that in traditional panel method, and the Kelvin wave-patterns calculated are in accord with the test data. Reasonable Kelvin wave-pattern and wave resistance of a high-speed round-bulge ship with transom stern are obtained by enforcing a condition, resembling Kutta-type condition, of smooth flow detachment at the transom stern. In addition to that, the linear solution of a catamaran is also presented.

本文运用该方法求解了Wigley船型与系列60船型的线性兴波问题,以较少的配置点计算出了与实验结果相近的Kelvin波系及合理的波形阻力;以在方尾部强加类似于库塔条件的光滑分离边界条件求解了高速圆舭型方尾船的线性兴波问题,得到了合理的三维波型及波形阻力;另外还求解了双体船的线性兴波问题。

Objective: To observe the change of regional cerebral blood flow in different region of interest under quiet condition and performing hand motor condition with single photon emission tomography, elucidate the mechanism of the brain regions activated by simple hand motor (repetitive and sequential finger- to- thumb opposition movements in turn) and detect the role of active cortical areas by analyzing the difference of rCBF in different age groups.

目的:本研究的目的是运用单光子发射断层扫描仪对比观察正常人在安静状态下和执行手指简单运动状态下脑内不同感兴趣区(region of interest, ROI)的血流量变化情况,进而阐明简单运动模式下脑内运动相关功能区的激发情况,并通过分析不同年龄组运动区激发时血流量变化的差异来探讨运动功能区的作用,对于临床中枢神经系统瘫痪后的运动功能重建和康复训练具有指导意义。

When temperature is 300 慍, sulphur raises efficiency of producing gas from kerogen 28 folds in Fushun oil shale (comparing to the condition that no sulphur exists in the oil shale), and raises efficIency of pmducing gas of the whole rock 21 folds (comparing to the condition that xm sulphur exists in the oil shale).

在300℃时使干酪根气态烃产率提高28倍(和无硫时干酪根产率相比),使全样气态烃产率提高21倍。

In addition, the blank holding force that is required to avoid wrinkle and rupture during conical part deep drawing is researched. The necessity of reasonable blank holding force in pressing is expounded. From the view of mechanical analysis, the wrinkle critical condition of side-wall is derived for the first time by the stress state of side-wall, the main deformation region on blank. According to the critical condition of plastic instability for flange, side--wall, corner of punch on blank, The blank holding force in conical part deep drawing is divided into four different regions within its forming figure. The basic principle of reasonable blank holding force during stamping is summarized and provided. The mathematical model of reasonable blank holding force that avoids the wrinkle and rupture is established and verified by the finite element numerical simulation and the grid experiment method. The result shows that it is accurate and reliable.

此外,本文还研究了圆锥形件拉深成形过程中,随着拉深变形过程的进行,毛坯为避免产生起皱、破坏缺陷而对压边力的需求情况,阐明了圆锥形件拉深成形过程中压边力合理变化的必要性;由毛坯主要变形区悬空锥壁部分的受力变形情况,从力学分析的角度,首次推导得出了圆锥形零件悬空锥壁起皱失稳的临界条件;并根据主要变形区法兰、悬空锥壁及凸模圆角部分的塑性失稳临界条件,在其成形范围图中,将圆锥形件成形过程中的压边力划分为四个区域;总结并提出了圆锥形件成形过程中压边力合理变化的基本原则;建立了防止起皱、破坏缺陷产生的压边力合理变化的数学模式,并得到了有限元数值模拟及网格实验法的验证,证实了理论分析结果的正确性和可靠性。

第28/100页 首页 < ... 24 25 26 27 28 29 30 31 32 ... > 尾页
相关中文对照歌词
I'm In No Condition
What Condition Am I In?
Just Dropped In (To See What Condition My Condition Was In)
Just Dropped In (To See What Condition My Condition Was In)
推荐网络例句

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里,举止就文雅一些,因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计,这件高贵的制服是香港本土制造,是我们第一套不配帽子的制服。

Do not 'inflate' your achievements and/or qualifications or skills .

不要 '夸大' 你的业绩或成果,条件或者技能。