查询词典 ignition

Textiles - Burning behaviour of materials for marquees large tents and related products - Ease of ignition; German version EN

织物。大帐篷和相关产品用材料的燃烧特性。易燃性；德文版本 EN

The relational order of indexes to mileages is acid value, ignition point, viscosity, number of big abrasion particles and severity of wear index.

对于汽车行驶里程，发动机油液监测指标间的关联序依次是酸值、燃点、闪点、粘度、大磨粒数和磨损烈度指数。

Unless otherwise specified, if the amount of the residue so obtained exceeds the limit specified in the individual monograph, repeat the moistening with sulfuric acid, heating and igniting as before, using a 30-minute ignition period, until two consecutive weighings of the residue do not differ by more than 0.5mg or until the percentage of residue complies with the limit in the individual monograph.

除非有其他规定，如果这样得到的残渣数量超过具体的各论中指出的限度，重复此前的以硫酸润湿、加热、灼烧等步骤，灼烧30分钟，直到两次连续残渣称量的重量差不超过0.5mg或者直到残渣的百分比符合具体各论中的要求。

Finally, two explosion ventings were simulated numerically with the constructed method since ignition in the premixed methane-air system in the closed vessel.

最后，利用已经建立的方法模拟了甲烷-空气预混气体从点火开始的泄爆过程。

Now comes the turn of the 'sportiest Mini ever' 400X Flow Control Valve to pick up the baton and mark a true leap of technology: the MultiAir system takes the controlled ignition engine to previously unthinkable levels of efficiency.

而此时的'有史以来最具运动迷你轮到拿起指挥棒，标志着一个真正的技术飞跃：该系统采用的MultiAir控制点火发动机的效率以前无法想象的水平。

Circulating fluidized bed ; dynamic ignition by oil gun ; experimental study

循环流化床；油枪动态点火；试验研究

Ignition and combustion-supporting have been widely applied in the site with oil gun, but its operation pressure is higher(2.0-2.5MPa), and oil costing is bigger, the maintenance of the oil system is inconvenience and lower operation economy.

油枪点火与助燃在燃煤锅炉上应用较为普遍，但在应用中油喷嘴雾化所需的压力较高（2.0~2.5MPa），耗油量较大，使整个油系统的维护工作量增大，并影响运行的经济性。

In retrofitting the burners, primary air was concentrated, the distance between primary air and secondary air was enlarged, oil gun was raised, tertiary air was changed to self-induced way which is advantageous for combustion and the furnace was covered with adiabatic materials. The purposes of taking these measures are to raise the furnace temperature and improve the ignition and combustion of anthracite.

对燃烧器的改造，采取了一次风进一步集中，将一二次风之间的距离拉开、油枪位置上提、三次风改为更利于燃烧的自引式、炉膛中增敷了卫燃带等技术措施，提高了炉膛的温度水平，更利于无烟煤的着火、燃烧。

So ,the temperature is quite essential for an engine to produce power .No engines can work well without suitable operating temperatures .If the engine runs too hot ,it may suffer form pre-ignition,while the air-fuel change is ignited prematurely from excessive combustion chamber temperature.Viscosity of the oil circulating in an over heating engine is reduced.Hot oil also forms varnish and carbon deposits may be drawn into the combustion chamber where it increases HC emission.This also causes poor performance and premature wear ,and may even result in engine damage.What is more,the behavior of the metals at excessively high temperature also differs from that at normal temperatures and can produce a condition in which the metal deforms slowly and continuously at a constant stress,If the engine runs too cold, the fuel will not vaporize properly.If liquid fuel reachees the cylinders,it will reduce lubrication by washing the oil from the cylinder walls and diluting the engin oil.This causes a loss ofperformance, an inrease in HC emissions, and premature engine wear.

所以，温度是很有必要的引擎来产生电力，没有引擎，可以工作，如果没有合适的操作温度，如果发动机运行太热，它可能遭受的形式预点火，而空气燃料的改变是点火过早过量燃烧室temperature.viscosity的石油流通的过度加热发动机是reduced.hot油价也构成了清漆和碳存款可能会被拖入燃烧室而增加hc的emission.this也造成业绩不佳和过早磨损，甚至可能导致发动机damage.what更重要的是，行为的研究金属在过高的温度也有不同，在正常温度下，可以达到的一个条件，其中金属变形速度缓慢，不断在恒应力，如果发动机运行太冷了，燃料价格将不会汽化properly.if液体燃料reachees气瓶，将减少润滑洗油从气缸壁和稀释器oil.this造成损失ofperformance ， inrease在hc排放，发动机过早磨损。

In this paper,the oil-saving transformation adopting tiny-oil ignition and steady combustion to substitute coal for oil of No.

针对这一问题，介绍了高井热电厂采用微油点火及稳燃技术，以煤代油，在4号炉进行的节油技术改造。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。