查询词典 hydrogenation
- 与 hydrogenation 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The catalytic activity for the hydrogenation of tetralin was examined with a fixed-bed continuous-flow reactor operating at 4.0MPa. The sulfur tolerance was tested with a feed of 200μg/g sulfur in the form of 4, 6-dimethyldibenzothiophene.
以四氢萘加氢为探针反应,4,6-二甲基二苯并噻吩为硫源,在固定床反应器中考察了催化剂的活性和耐硫性。
-
The following plastic wastes, i.e., polyvinylchloride cable waste, polyethylene cable waste, used "Trabant" car bodies (polyester- and phenolic resins) were mixed with old motor oil, industrial waste oil, and chlorobenzene from waste oil refining processes, and subsequently subjected, in autoclaves, totemperatures up to 500oC and pressures of 20 MPa using disposable catalyst system of slurry phase hydrogenation.
下面的塑料废物,比如聚氟乙烯线状废物,聚乙烯线状废物,使用&随体&汽车车身与旧机油、工业废油和氯苯从废油精炼出来,随后在小孔中使用泥浆阶段加氢的一次性相位加氢系统加热到500摄氏度和20M帕的压强。
-
Synthesis gas ; Hydrogenation ; Dimethyl ether ; Methanol ; Bif unctional catalyst ; XPS ; XRD
合成气;加氢;二甲醚;甲醇;双功能催化剂; XPS ; XRD
-
The active stability and amount of the catalyst were studied and the influential factors ,such as solvent, temperature and pressure were investigated,and then the optimal process parameters were given∶Raney∶ethanol∶3,4-methylene-dioxy nitrobenzene is 0.15∶6∶1;the reaction temperature is 40℃;the hydrogenation pressure is 0.45~0.50 MPa;the stir velo...
对催化剂用量和活性稳定性进行了研究,讨论了溶剂用量、温度、压力等因素对加氢反应的影响。结果表明最佳工艺参数为:雷尼镍∶乙醇∶3,4 亚甲二氧基硝基苯=0.15∶6∶1,反应温度40℃,氢压0.45~0.50MPa,搅拌速度450r/min,反应至不再吸氢为止,产品收率在97%以上,纯度为98%。
-
The demetalation of Ni-OEP in the presence of H2 consists of two steps. The first step is hydrogenation of nickel porphyrin to nickel chlorin, and the second step is decomposition of nickel chlorin and the removal of nickel.
,也有相当一部分镍卟啉发生分解,脱除所配合的金属;镍卟啉的临氢脱金属反应过程分为两步,第一步是卟啉分子中一个吡咯环上的外环双键加氢生成镍卟酚,第二步镍卟酚分解,金属脱除。
-
Catalytic techniques for deep desulfurization, denitrogenation and dearomatization in production of clean gasoline and diesel fuels were reviewed, especially those for producing low-sulfur and extra-low-sulfur gasoline and diesel oil, among which technologies arousing most attention are sulfur-reducing FCC catalyst and additives, selective hydrogenation catalysts and technology, adsorptive desul-f urization of gasoline and diesel oil, biologically catalytic desulf urization of diesel oil, and selective oxid...
为面对新世纪清洁燃料生产的新机遇和新挑战,各种生产清洁燃料的催化技术正在竞相开发之中,尤其是生产低硫、超低硫汽油与柴油技术。其中,催化裂化降硫催化剂和助剂、选择性加氢处理新催化剂及工艺、汽柴油吸附脱硫、柴油生物催化脱硫和选择性氧化脱硫等新技术尤其引人注目。我国应加快清洁燃料生产催化新技术的开发研究,为生产更清洁的汽油和柴油燃料提供技术储备。
-
The results show that fractions of the hydrogenation residue are suitable for catalyzed cracking materials instead of cracking materials.
结果表明,加氢尾油的馏分不适宜作为裂解原料,可以作为催化裂化的原料。
-
The result shows that the hydrogen storage properties increase remarkably after pure magnesium ball-milled with 10% TiFe(subscript 1-x)Cr (x=0, 0.3). Moreover, the chromium content also influences the hydrogen storage characteristics. Furthermore, the ball-milled composite of Mg+10%TiFe0.7Cr0.3 has the best hydrogen storage properties with hydrogenation capacity of 7.14% and dehydrogenation capacity of 6.91% at 613 K. In addition, the lower temperature of 493-573 K, the Cr-contained composite exhibits the best dehydrogenating kinetics.
研究结果表明:在纯Mg中添加质量分数为10%的TiFe(下标 1-x)Cr(x=0, 0.3)进行复合球磨,可以明显提高其吸放氢性能;在相同温度条件下,x=0.3的含铬复相合金具有最佳的吸放氢性能,其中在613 K下的吸氢容量为7.14%,放氢容量为6.91%;在493~573 K的较低温度下,含铬复相合金表现出更好的放氢动力学性能。
-
The results show that Pd/CNTs catalyst has good quality for the hydrogenation of halogenated aromatic nitro compounds.
同时,对影响催化反应的条件进行了研究。
-
This novel catalyst was successfully used in the selective hydrogenation of halogenated aromatic nitro compounds.
作为加氢催化剂,Pd/CNTs对卤代硝基物的催化加氢表现出较高的催化性能,其加氢活性比P出C加氢催化剂高。
- 推荐网络例句
-
Listen,point and check your answers.
听,指出并且检查你的答案。
-
Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.
但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例,经过临床的诊断后,其中施以温针治疗的48例,疗效显著,报道如下。1临床资料本组病例48
-
Some known methods of remnant pump detection and automatic laser shut-down use communications, such as an OSC.
一些已知的残余泵浦检测和自动激光关断的方法利用诸如OSC的通信。