查询词典 high-speed steel

The agitation power consumptions in boiling systems decrease uniformly with the increase of agitation speed, whereas the relative power demand (RPD-the ratio of agitation power input of HEDT for gassed system to that for ungassed system and under the same agitation speed) can maintain at a high level for high gas loadings even when the impeller is operating with a high impeller tip speed. The gas hold-up in the boiling system is much lower than that in the cold gassed system, and the gas hold-up in boiling system increases at first and then decreases with the increase of the agitation power consumption per liquid mass P(subscript m. It implies that the boiling three-phase system has a maximum gas hold-up point. The changes of nucleation site of vapour bubble and the character of suspension of the solid particles with the rotational speed of the impeller are responsible for those behaviors mentioned.

在沸腾条件下，搅拌功率消耗随着搅拌转速的增加有所下降，但HEDT桨具有较高的载气能力，即使在高叶端线速度下，相对功率消耗仍能保持在较高的水平；沸腾体系的气含率随单位质量流体输入功率的增加表现出先增后减的规律，即存在气含率的极大值，蒸汽成核位置和固体颗粒悬浮特性随搅拌功率增加而改变是造成上述行为的主要原因；沸腾体系中的气含率远远低于常温通空气体系。

The calculation results shows that ,(1) when the rotor rotates at the working speed, a local regurgitant whirlpool that is rightabout to the rotor"s rotating direction appears in the classifying region, which makes the separated granules come back to the outside of the classification district and influences the classification efficiency of the turbine classifier;(2) in the condition of a low rotating speed of turbo rotor, ultrafine particles can follow the gas phase by and large, but when the rotating speed increases, a phenomenon of velocity slippage between two phases appears evidently;(3) A operating parameter, air flow rate is so important that can directly influence the stability of flow field in classifying chamber, the bigger the air flowrate is , the steadier the flow field is;(4) Compared with straight blades, the new shape of blades with backward crooked elbow are helpful to improve the stability of flow field and form whole stream easily, also beneficial to advance the classification accuracy and classification efficiency;(5) The motion trace of particles are very complicated when the turbo rotor rotates at a high speed, the constant bounce of the particles appear between the blades and the coarse particles are even bounce back from the inlet, only the finer can pass through the classification area from the oulet;(6) Along with the increase of the rotor"s rotating speed, radiah axial and tangential velocity all begain to fluctuate repetitively like sine-wave, the smaller the particles are, the more violently they fluctuates.

数值模拟结果表明，(1)在涡轮达到工作转速时，在分级区域形成了一个与涡轮旋转方向相反的局部回流涡，它使得分离出来的细粒重又被带回分级轮外边缘，从而严重影响分级机的分级效率；(2)粉尘粒子在涡轮低速运动情况下，基本上能跟随气体运动，但随着转速加大，两相之间出现了明显的速度滑移现象；(3)分级机工作时的风量也是一个比较重要的操作参数，它可以直接影响到分级机内腔流场的稳定性，风量越大，流场越稳定；(4)同直叶片形状相比较，带后弯导板的叶片，有利于改善流场的稳定性，流场容易形成整体流，对提高分级效率和分级精度都非常有利；(5)粒子轨迹线在涡轮转速较高时十分复杂，有的出现了反复的弹跳现象，大颗粒不能通过分级区域而从进口返流了，只有细小的颗粒才从出口处流出；(6)涡轮转速加大时，粒子的径向、轴向和切向速率出现了明显的类似于正弦波的脉动现象，颗粒越小，脉动程度越为剧烈。

By regression of experimental data, therules of the linkage between these factors, which will provide a theoretical basis for designing BBP with different scales.3 Using thermal analysis technology and dynamic thermogravimetry, the paper studies combustion kinetic characteristics of 3 types of agricultural crops at different rate of temperature rise, and thus, achieved dynamic parameters of these fuels at different rate of temperature, established dynamic model of straw combustion, which reflects the dynamic process in the fast combustion area.4 Characteristics of straw briquette combustion was experimented, focusing on the impact of straw type, temperature, air supply, and density, diameter, and weight of briquette on the combustion speed, and the following conclusions were drawn:(1) combustion of straw briquette fuel is static permeation diffusion combustion;(2) temperature has a larger impact on the speed of straw briquette combustion than air supply; the higher the combustion temperature is, the faster volatilizable component separates out, and the less steady the combustion is;(3) density of briquette fuel has impact on the speed of volatilizable component separation and therefore the combustion speed;(4) increase of diameter and weight of briquette fuel increases the average combustion speed in the initial stage, and that in the later stages is comparatively steady;(5) the proportion of volatilizable component in straw briquette fuel is high, therefore, the temperature control during combustion under the rational ventilation condition is essential to ensure its safe combustion.5 Using the above-mentioned results of experiments and theoretical analysis, and based on thought of hydraulic driven and bi-direction compression, the hydraulic system and compression parts of the HBP BBP are re-designed in terms of industrialization.

利用热分析技术，采用动态热重实验法，对我国的三大农作物秸秆在不同升温速率下的燃烧动力学特性进行了较系统的研究。得到了各原料在不同升温速率下的动力学参数；建立了秸秆燃烧的动力学模型，该模型反映了秸秆迅速燃烧区的动力学过程。 4 对秸秆成型燃料的燃烧特性进行了试验研究。着重研究了秸秆河南农业大学博士学位论文巫的种类、温度、空气供给量、成型燃料密度、直径、质量对成型燃料燃烧速度的影响并得出如下主要结论：①秸秆成型燃料的燃烧方式属于静态渗透式扩散燃烧。②秸秆成型燃料燃烧速度受温度的影响大于通风量燃烧速度的影响：燃烧温度越高，挥发分析出速度越快，燃烧平稳性愈差。③成型燃料密度影响成型燃料挥发分的析出速度，影响燃烧速度。④成型燃料直径和质量的增加，使得燃烧初期的平均燃烧速度增大，中后期的平均燃烧速度相对平稳。⑤秸秆成型燃料含挥发分比例高，因此合理配风下的控温燃烧是保证其完全燃烧的关键。 5运用已取得的试验和理论分析结果，以液压驱动、双向成型为基础，从产业化的角度对HBP型成型机进行了液压系统和成型部件的改进设计；同时采用了二级预压机构，使该成型机的生产率达到 500kg.hd；单位能耗 60kwh。上'左右，磨损件修复周期 300小时左右，基本解决了影响生物质固化技术在国内推广的技术难题。

In order to adapt to different production speed, you can use a speed control potentiometer on high speed; adjust the speed of the actual value of the gauge by speed.

为了分适不对别的出不销速率给求，可堵住一个调速电位器不对矮速举行调度，速率的本质值可以堵住速率表辅导出来。

Our company specializes in producing all kinds of material, a variety of cold-drawn round bar, six angle steel, square steel, flat steel and various special-shaped steel, as well as various specifications of stainless steel standard fasteners.

本公司专业生产各种材质，各种规格的冷拉圆钢、六角钢、方钢、扁钢及各种异型钢，以及各种规格的不锈钢标准件紧固件。

The main products have wire wheels, wire wheels, stainless steel wire wheels, pipes pass sweep, steel, copper wire brushes, peeling wheels, roller brush, zippers polishing brush, polishing brush hole, pipe brush, pen and brush, steel wire wheel handle , polishing brush, metal brush, metal surface polishing brushes, paintbrushes peel, roll the long axis of wire brushes, steel round bowl type, flat type wire wheels, disc-type steel wheel, industrial brush business.

主要产品有钢丝轮、铜丝轮、不锈钢丝轮、管道通扫、钢、铜丝刷，剥皮轮，滚筒刷，拉链抛光刷，内孔抛光刷，管道刷，笔型刷，带柄钢丝轮，抛光刷，五金制刷，金属表面抛光刷，剥漆刷，长轴钢丝辊刷，碗型钢丝轮，平型钢丝轮，碟型钢丝轮，工业用刷的企业。

Material has low carbon steel A3, 45 # steel, ICY13 heat-resistant steel, ICY18N19Ti steel, oocr18Ni14MO2Cu2 acid-resistant heat-resistant steel and so on. 2, food cookies Industry: Width 180mm-1200mm cotton, nylon line canvas belt, mesh belt ovens, cooling injector machine with Net, Net-Ping turning machine chain, B-shaped chocolate coating machine belt Net.

材质有A3低碳钢、45#钢、ICY13耐热钢、ICY18N19Ti钢、oocr18Ni14MO2Cu2耐酸耐热钢等。2、食品饼干行业：幅宽180mm-1200mm棉线，尼龙线帆布带，烤炉网带，冷却喷油机网带，平转弯机网链，巧克力涂层机乙形网带。

Professional processing of all kinds of stainless steel mixing tank, stainless steel (2520) sintered crucible, stainless steel hydrogenation cans, stainless steel cabinet, cabinets, grinding machine, the ball mushroom machine, mixer, aluminum parts processing and welding, and titanium and titanium clad steel plate chemical processing equipment, sealing cans, mixing tank, reactor, heat exchanger, titanium crucible.

专业加工各种不锈钢搅拌罐，不锈钢(2520)烧结坩埚，不锈钢氢化罐，不锈钢箱体，柜子，磨筛机，球蘑机，混料机，铝件的加工和焊接，及钛和钛复合板的化工设备加工，密封罐，搅拌罐，反应釜，换热器，钛坩埚。

Since the new century, the rapid development of China's iron and steel industry, average annual growth rate of crude steel production 21.1%. 2008, crude steel production reached 500 million tons, accounting for 38 percent of global production, equivalent to the direct export of 60 million tons of crude steel, iron and steel trade of the world's 15%.

进入新世纪以来，我国钢铁产业快速发展，粗钢产量年均增长21.1%。2008年，粗钢产量达到5亿吨，占全球产量的38%，直接出口折合粗钢6000万吨，占世界钢铁贸易量的15%。

Finally steel balls millstone covering with Ni-Fe-diamond composite electro-brush plating film is produced successfully.Secondly, the steel balls millstone is used to grind steel ball in ones steel ball factory, and process flocculus the steel balls that possess reticulate veins surface.

然后利用制成的钢球研磨板对钢球进行超精磨削加工，加工出了表面具有网状纹理形貌的"绒面"钢球，利用仪器测量钢球表面的粗糙度值达到了0.015μm，表面波纹度值达到了0.006μm，圆度达到了0.010μm，球批直径变动量小于0.015μm。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48