查询词典 high temperature

In case of direct injection at the latter stage of n-heptane high temperature reaction or nearly after the high temperature reaction, diffusive combustion of iso-octane mainly occurs.

研究发现直喷异辛烷的燃烧模式与其喷入缸内时对应的预喷正庚烷HCCI放热的不同阶段有关，通过控制异辛烷直喷时刻可以实现其不同燃烧模式的调制。

The high temperature metallurgical properties of several burdens for Anyang steel were investigated. The results showed that RIof high basicity sinters was better than others, but the RDI(low temperature reduction degradation index) of it was the highest; the RDI and molten dripping property of pellets and lump ores were well, so we can get rational burden structure by combining sinters for blast furnace.

系统分析了安钢炼铁生产中几种常用炉料的高温冶金性能，结果表明，安钢自产高碱度烧结矿具有较好的还原性，但其低温还原粉化率却是最高的；酸性球团矿及块矿则有着较好的低温还原粉化指数及良好的熔滴性能，能够与高碱度烧结矿搭配形成合理的综合炉料结构，满足高炉冶炼要求。

BIRAL BIO 30 high-temperature chain oil, a large number of wholesale BIRAL BIO 30 high-temperature chain oil, BTU reflow oven for, CONCEPTRONIC, earmarked for reflow oven for lead-free reflow furnace use, in line with EU environmental requirements.

BIRAL BIO 30高温链条油，大量批发BIRAL BIO 30 高温链条油，为BTU回焊炉，CONCEPTRONIC，回焊炉指定专用，适合无铅回焊炉使用，符合欧盟环保要求。

They include all kinds of super mini sealed DC electromagnetic relay, sealed electromagnetic relay, sensitive electromagnetic relay, mini sealed electromagnetic relay, super mini high-power relay, super mini sealed hold relay, coaxial relay, super mini sealed relay, mini sealed temperature relay, high temperature relay, heat protector, priming system safety protector, separation control overload switch, wind speed relay, time relay, sealed switch, program controller and protector for over loading, etc., which are used widely in aviation, aerospace, electronic communication, home appliance, etc.

各类超小型密封直流电磁继电器，密封电磁继电器，灵敏电磁继电器，微型密封电磁继电器，超小型大功率继电器，超小密封保持继电器，同轴继电器，超小型密封继电器，微型密封温度继电器，高温温度继电器，热保护器，火工品安全保护器，分离控制过载开关，风速继电器，时间继电器，风器，密封断路器，程序控制器，过载保护器等广泛用于航空，航天，电子通讯，家用电器等领域，其产品远销欧洲。

The initial discharge capacity of the materials with 1.0 wt% A12O3-coated were 120.2mAh/g and 117.mAh/g, respectively at room temperature and high temperature, among the voltage range 3.25~4.35 V at 0.5C rate, and the capacity retentions were 96.59% and 94.23% after 50 cycles, which indicated that material had high discharge capacity and good cycling property under these optimum conditions.

在3.25~4.35V的充放电电压区间内，表面包覆Al2O3质量分数为1%所制备的LiMn2O4材料显示出优良的电化学性能，在25℃和55℃，分别可达到0.5C 120.2mAh/g和117.9mAh/g，经过50次循环后容量保持率分别为96.59%和94.23%。

Keywords Heat resistent steel for high temperature furnace;High-temperature corrosion;Carburizing;Failure

Article From 浙江大学；材料加工工程硕士论文 2005年度炉用耐热钢；高温腐蚀；渗碳；失效

These factors have seriously influenced the security and economical operation of the unit. This paper firstly summarizes the research background and the general situation of resarch about the overheating problem of boiler's high-temperature surface ,introduces the aspects and research findings in this field such as flux deviation、thermal deviation、flue gas velocity deviation at the exit of furnace and tee bends,et al.Then analyses the reason why high-temperature surfaces are overheated from such aspects as design、manufacture、operation, et al and points out one of the main factors that cause the overheating of reheaters is the flue gas velocity deviation caused by the remaining turning at the exit of furnace.

本文首先综合论述了课题的研究背景和目前电站锅炉高温受热面超温问题的研究概况，介绍了国内外流量偏差、热偏差、炉膛出口残余旋转、&三通&等研究方向和研究成果，然后从锅炉的设计、制造、运行等方面分析了高温再热器超温的原因，指出水平烟道内气流的残余旋转是造成再热器超温的主要原因之一。

Is recommended.8.2 The weld bonds of changed outlet pipes of Huaneng ShanhaiShidongkou Second 8.2 The weld bonds of changed outlet pipes of Huaneng ShanhaiShidongkou SecondPower Plant high temperature reheaters which were welded with thPower Plant high temperature reheaters which were welded with th e qualified e qualifiedprocedures all meet the requirements.

焊后为改善焊接接头性能，建议采用750 ±10℃温度进行焊后热处理。750 ±10℃温度进行焊后热处理。8.2 根据所评定的焊接工艺进行焊接，华能上海石洞口第二电厂高温再热器出口段管子更8.2 根据所评定的焊接工艺进行焊接，华能上海石洞口第二电厂高温再热器出口段管子更换焊口经检查均符合要求。

Temperature and pressure, it would be in normal working under high temperature and high pressure, ask viscous fan anti-related, it can caking and adhesive materials of exclusion, security, normal transmission and reception.

耐温耐压式，它可以在高温高压下正常工作，抚粘性防堵关风机，它可以把物料结块和粘着性排除，安全正常输送和接收。

On the instrument cabinet, there is power switch, start switch, stop pushbutton, main engine exhaust thermometer, lub oil pressure gauge, lub oil thermometer, cooling water thermometer, main engine revolution indicator, starting battery voltmeter, cooling water high temperature and lub oil low pressure alarm device; beside the gear box, there is working oil pressure gauge, lub oil thermometer, lub oil low pressure alarm , working oil low pressure alarm and lub oil high temperature alarm.

本船主机有机带控制报警仪表箱，仪表箱上设有电源开关、启动开关、停车按钮、主机排气温度表、滑油压力表、滑油温度表、冷却水温表、主机转速表、启动蓄电池电压表、冷却水高温及滑油低压报警装置；齿轮箱机旁配工作油压力表、滑油温度表、滑油低压报警、工作油低压报警及滑油高温报警。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。