查询词典 high strength

To guarantee high quality,BRIGHTWAY has brought in a large batch of the latest advanced equipment from around the world such as omnipotent material tester,M/I index tester,heat deflection temperature tester,RoHS test equipment,aging property tester etc.All of the production processes are under strict control and supervision ofour experienced enginners. Density,flow index,hardness,tensile-strength,tensile stetch, bending strength, flexural modulus,impact strenght, mould shrinkage factor, heat deflection temperature, fibre glass contents, water absorption, combustibility will be tested strictly by the professional engineers.

为了确保产品的高品质，百莱威引进了大量国际新一代的先进设备，如万能材料试验机、M/I指数测定仪、热变形温度测定仪、RoHs检测设备、耐老化试验设备等等，并且所有的生产过程都受到了严格的质量控制，由经验丰富的专业工程师进行了密度、流动指数、硬度、拉伸强度、伸长率、弯曲强度、冲击强度、模收缩率、热变形温度、玻纤含量、吸水率、燃烧性能等十多项苛刻的评审和检测。

The gel strength formed at 20℃ and 30℃ is relatively high; the gel strength degreases when the temperature increases, and it is hard for the gelation when the temperature is above 55℃.

在较低温度：20℃、30℃时能得到较高的凝胶强度；温度升高，凝胶强度减弱。

A new technology of direct fluidizing calcination for FGD gypsum is introduced in this paper. The technology is able to calcine FGD gypsum homogeneously, to control the quality easily, to produce plaster with high compressive strength and bending strength.

综合国内外石膏焙烧技术的发展，并结合脱硫石膏的物性特点，以及一定的焙烧实践经验，本文介绍了一种新型的脱硫石膏直接流化焙烧技术，该技术具有物料受热均匀、产品质量易控制、焙烧设备运行可靠等特点，通过该技术所焙烧的建筑石膏相均匀性好，强度高。

Top sintering material preheats for a short time、sinter at lower temperature、cools too fast and has low crystallinity, especially, network SFCA offorms difficultly in the top layer, that results in high ratio of pore, so the strength of top sinter is low. when thickness of sintering material is increased, the ratio of top sinter will be decreased, in its entirety, the strength of sinter will rise.

5烧结矿破碎属脆性断裂，一般在单轴压缩应力下受剪切产生，本文基于低氟烧结矿物质组成，导出了基体抗压强度与烧结矿物质组成的关系式，由此得出，基体抗压强度受磁铁矿影响不大，而受铁酸钙影响较为显著。

The influence of recessing in adh es ive layer with high elastic modulus on the peak stress of joint is not evident so that it would improve the actual strength of joint markedly based on the load bearing ability not being affected evidenly . On the other hand , the recessing in the joint with low elastic modulus adh es ive caus es the peak stress es increase evidently that may decrease the nominal and actual strength of the joint markedly .

对胶层和被粘物中应力分布的数值分析结果表明：胶层中的间隙对接头端部的应力分布无明显影响，但对间隙附近的应力峰值影响较大；随着胶粘剂弹性模量的增大，间隙附近的应力峰值有所降低；对于高弹性模量胶粘剂接头，胶层中的间隙对接头的应力峰值无明显影响，在不降低接头名义强度的同时可使得接头的实际强度显著提高；而对于低弹性模量胶粘剂接头，间隙使得接头上的应力峰值明显上升，可能导致接头的名义强度和实际强度显著降低。

On the basis of experiment analyses we would got that, When arc met with chute, it was blocked and had a stagnation, this made hot gas flow incrase near the chute; After arc went into the chute, mental vapor from arc root would lower the dielectric strength near the chute, meanwhile, High value of arc voltage and the corase face of the chute made electric strength increase. These factors might give rise to local restriking near the chute, and made arc voltage drop suddenly.

总结实验结果并加以分析，本文提出了这样的观点：电弧进入栅片时，在入口处受阻后的停滞，会使该区域的热气流增加；进入栅片后，弧根蒸发的金属蒸汽、电弧热气流会降低栅片入口区域的介质强度；电弧被栅片分割后，电压急剧上升，再加上栅片表面的不均匀会使局部区域的电场强度显著增加，这些因素的综合作用会导致电弧在栅片入口附近发生局部重击穿，引起电弧电压电压跌落。

DULES chemical has the abundant technical strength and economic strength, is a high-tech-intensive enterprises, with the title of Engineer, the staff of a college education as much as 60%, Britain, Germany connection at the company as the company's long-term technical and management consultancy, which for chemical DULES, a leader in technology laid the foundation.

DULES化工拥有雄厚的技术实力和经济实力，是一家高技术密集型企业，具有工程师职称、大专以上学历的员工高达60％，英国、德国专家顾问团长期驻守公司担任公司技术及管理的顾问，这就为DULES化工在技术方面的领先奠定了基础。

The mechanical properties of the modified material were tested, and the thermal stability of the modified EP blend was also investigated by TG. The results indicate that the graft copolymerization between PU and EP effectly inforces the miscibility of the PU/EP system. Compared with the properties of pure EP, the impact strength and tensile strength of the PU/EP with high thermal stability are markedly enhanced, and the fracture surface of the PU/EP system displays tough fracture features.

研究结果表明：PU和EP分子链之间存在着化学接枝反应，能有效地改善PU/EP体系中PU和EP分子间的相容性及相互贯穿；与TDE-85与E-51的混和环氧树脂比，PU改性TDE-85与E-51的混和环氧树脂仍然具有很强的耐热性能，并且冲击强度、拉伸强度均获得显著提高；PU/EP体系断口裂纹呈明显的韧性断裂特征，说明TDE-85与E-51的混和环氧树脂PU改性增韧效果明显。

This research is to analyze the plyometric strength training effects of elite, male, high school tuggers from the viewpoint of "plyometric strength training".

本研究主要以优秀男子拔河选手为研究对象，对两种拔河起动步的肌力表现，透过肌力诊断的方法进行生物力学分析。

In addition, a ready-made mortar package that required only the addition of mixing water to produce a durable and very rapid strength-gaining material was produced and utilised in rapid restoration of concrete airport runways, aprons and taxiways, highway and bridge decks, and for several new constructions when high early strength was needed.

另外，只需要加混合水就能产生一种耐用且快速强化的材料的砂浆包将会用于混凝土机场跑道，停机坪及滑行道，高速公路和桥梁表面的快速整修恢复，且对于几个新建筑是需要高早强混凝土的。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。